(b) The 0.31 Kg mass slides at the shown frictionless wire that lies in a vertical plane. What is the minimum value of distance b to reach mass to point B at the end of wire. Free length of spring is 0.08 m and stiffness of spring is 120 N/m. 031 kg 80 mm

(b) The 0.31 Kg mass slides at the shown frictionless wire that lies in a vertical plane. What is the minimum value of distance b to reach mass to point B at the end of wire. Free length of spring is 0.08 m and stiffness of spring is 120 N/m. 031 kg 80 mm

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.78P: The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016,...

See similar textbooks

Related questions

Q: 3. The 75-kg chest shown is intended to be moved P= 400 N 15° 一十一 under the condition shown. Does…

Q: A 3 m long steel rod with a mass of 5000 (kg) is lifted from its ends in balance with a 6 m long…

Q: 6. Derive the mass equivalent of the system shown.

Q: A block of mass, M = 25 kg, is at rest on the horizontal. If μₛ = 0.3 and a constant force of 100 Nt…

Q: Solve the given problem. Box your final answer. 6. The 5 lb. pan P carries the 30 lb. mass D. In…

Q: A small roller in a mechanics setup is pushed by a force F = 4 N as shown in the sketch. The mass of…

Q: •*344. A scale is constructed using the 10-kg mass, the 2-kg pan P, and the pulley and cord…

Q: A block of mass m = 1.40 kg is at rest on a ramp of mass M = 3.90 kg which, in turn, is at rest on a…

A: Given Data: The mass of the block is m=1.40 kg. The mass of the ramp is M=3.90 kg. The displacement…

Q: Q4/ Assuming frictionless motion, compute the force exerted by the arm OA on the cylinder B when 0=…

Q: Find the smallest distance d for which the hook will remain at rest when acted on by the force P.…

A: Given Data Given force system

Q: When a car is rounding a bend on a flat road, the centripetal force is provided by the friction…

A: the free body diagram of car at the turn can be plot as, where r=200m so,…

Q: Determine all the cable tensions and the mass of block E of the system shown below.

Q: A stone of mass ? = 0.1 ??, attached to the end of a 1 ? long rope, rotates in the direction of the…

A: Given, Mass, m=0.1 kg Tangential velocity, v=10 m/s Radius, r=0.1 m θ=370

Q: 20 mm R B P

A: Given, mass of cylinder A:mA=2kg mass of cylinder B:mB=1kg radius of cylibder B:rA=20 mm radius…

Q: The box of mass m = 10 kg is in motion. What is the minimum force F needed to keep it moving?

A: Given that: m = mass of the body = 10 kg coefficient of static friction = 0.2 coefficient of kinetic…

Q: The 300 kg cylinder shown in the figure is wrapped with rope as shown and released from rest. Find…

Q: A 4-kg block rests on a smooth surface and is acted upon by force F, as shown in the figure. What is…

A: According to Newton's second law, the acceleration of an object is directly proportional to the net…

Q: The gardener of question 4 wishes to transport a second 250-N bag of fertilizer at the same time as…

A: Draw the force diagram

Q: A 300 |b block rests on a hortzontal plane. Find the magnitude of the force P required to give the…

A: mg=300×32.2=9660 lb-fts2F=frictional force=μk NF=0.25N

Q: A car is moving with a velocity of 20 m/s on a curved road as shown. The radius of curvature of the…

Q: Q5) A rod having a mass of M and length of L is falling. What is the equation of motion if the…

A: The free body diagram of the rod is given below,

Q: Three identical steel balls, each of mass m=75kg, are placed in the cylindrical ring which rests on…

A: Solution- Given data- m =75kg

Q: 1- -- pomn) A pilot of mass m= 70 kg in a jet aircraft executes a loop-the-loop, as shown in Figure.…

A: mass=70Kg radius=3Km v=250m/s Ans(a) Centripetal acceleration ac=v2r=25023000=20.833 m/s2

Q: Three identical steel balls, each of mass m=80kg, are placed in the cylindrical ring which rests on…

A: Solution.jpg

Q: A 150 lb cylindrical tank is at rest as shown in the figure. Determine the minimum force P required…

A: Let's mark the points O, A, B, C as shown in below free body diagram for understanding purpose. Let…

Q: Find forco ( Fs), the force perpendicular to the the friction surface ( Normal Force, N. ), and the…

A: Given: m = 540 kg mu = 0.5

Q: Q2/ Three blocks having masses of 5 kg , 10 kg and 15 kg are in contact on a fixed smooth inclined…

Q: An electric motor M is used to reel in cable and hoist a bicycle into the ceiling space of a garage.…

Q: A 0.150 kg frame, when suspended from a coil spring, stretches the spring 0.0400 m. A 0.200 kg lump…

A: According to the law of conservation of energy, total initial energy of a system is equal to the…

Q: What is the minimum height h in meters of a slope that must be constructed in order for a rider in…

Q: A 30° a P. B.

A: Support reaction induce at point C , normal reaction at point B and friction force develop at point…

Q: 1/9 A space shuttle is in a circular orbit at an altitude of 200 mi. Calculate the absolute value of…

Q: Q1) The quadriceps tendon attaches to the tibia at a 30° angle 4 cm from the joint center at the…

A: Given that the 80 N weight is attached to the ankle 0.28 m from the knee joint, Also, Fm is the…

Q: The figure below shows two blocks moving on the surface of a frictionless incline. If F = 30 N, what…

Q: When landing on a carrier, a 10,000-lb airplane is given a deceleration og 3kg(96.6 ft/sec^2) by…

A: GIVEN- WEIGHT OF AIRPLANE=10000LB DECELARATION=3kg(96.6 ft/s2 Find…

Q: A "swing ride" is shown in the figure. For b=1.6 m, L=4.2 m and 0=36° neglect the mass of the cables…

A: Given:-b=1.6mL=4.2mθ=36°m=37kgTo find:-1) Radiys of horizontal circle2) Tension in cable3) Velocity…

Q: Blocks A, B, and C are placed as in Fig. and connected by ropes of negligible mass. Both A and B…

A: The free body diagram for the block A and B is (a) Here T1 is the tension in the rope between block…

Q: Calculate the mass m of a body that weighs 600 lb at the surface of the earth .

A: Weight of the body W=600 lb

Q: leva usly. At a given instant, 0 = 37°, 0 = 43 deg/s, ö = 113 deg/s2, 1 = 0.51 m, = 0.33 m/s, and ï…

A: Solution - Given data - d = 0.55 m l = 0.51 m m = 8.8 kg

Q: The smooth can " is lifted from "A" to "B" by a rotating rod. The mass of the can is 3 kg. Neglect…

A: given,anguale speed of the rod,θ˙= 0.5 rad/sradius of the circle made by rotation of the rod,…

Q: Pure water has a surface tension of 0.0728N/m. Soap water has a surface tension of 0.025N/m. A soap…

A: Given Data: The surface tension of pure water is Fpw=0.0728 N/m. The surface tension of soap water…

Q: Q4/ Assuming frictionless motion, compute the force exerted by the arm OA on the cylinder B when e-…

Q: The angle of the slope 23.0∘ and use a different cart and a different bucket. You observe that the…

A: Given data: Tension in the cable (T) = 175 N The angle of the slope α=23.0∘ Need to determine the…

Q: Three identical steel balls, each of mass m=85kg, are placed in the cylindrical ring which rests on…

Q: What is the bank angle of the airplane? (b) What is the pilot’s appar- ent weight during the turn?…

Q: block C mass = 99 kg block D mass = 66kg horizontal force (H) = 555N and is applied at block D.…

Question

I need the answer as soon as possible

(b) The 0.31 Kg mass slides at the shown frictionless wire that lies in
a vertical plane. What is the minimum value of distance b to reach
mass to point B at the end of wire.
Free length of spring is 0.08 m and stiffness of spring is 120 N/m.
0.31 kg
80 mm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given Data

VIEW

Step 2 Calculation

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The 400-kg drum is held by tongs of negligible mass. Determine the magnitude of the contact force between the drum and the tongs at D.
The cable AOB weighs 5.2 N/m. When the horizontal 30-N force is applied to the roller support at B, the sag in the cable is 5 m. Find the span L of the cable.
The tongs shown are designed for lifting blocks of ice. If the weight of the ice block is W, find the horizontal force between the tongs and the ice block at C and D. Neglect the weights of the tongs.
The woman is trying to move the crate of weight W by pulling on the rope at the angle to the horizontal. Find the smallest possible tension that would cause the crate to slide and the corresponding angle .
Determine the horizontal force P that would keep the uniform 12-kg rectangular plate in the position shown.
Draw the FBD for the bar described in Prob. 5.1 if the bar is homogeneous of mass 50 kg. Count the unknowns.
The cable AOB weighs 24 N/m. Determine the sag H and the maximum tension in the cable.
The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016, determine the force F required to advance the bar at a constant speed.
Find the stable equilibrium position of the system described in Prob. 10.56 if m = 2.06 kg.
The uniform bar of weight W is held in equilibrium by the couple C0. Find C0 in terms of W, L, and .