(B) The state space representation for a closed loop system is shown in figure (5): 1. What is the poles and zeros for this system 2. Obtain the open loop transfer function G(s) for this system if it has a unity feedback.H(s)-1 10 -10 U(s) 10 Figure (5)

(B) The state space representation for a closed loop system is shown in figure (5): 1. What is the poles and zeros for this system 2. Obtain the open loop transfer function G(s) for this system if it has a unity feedback.H(s)-1 10 -10 U(s) 10 Figure (5)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: R₁ 5Ω R₂ 1052 5Ω E₁ 20 V E₂- 10 V In the above network, solve this network using branch current at…

A: given here a circuit and asked to find branch currents by using branch current method and mesh…

Q: (B)- Indicate whether the following statements are true or false and correct the false statements -…

A: Armature control method is used for below rated speed because in armature circuit resistance is…

Q: I Solve for equivalent ro. H • 2.2 ΚΩ 3.3 kohms 60 kohms O 2 Mohms O 5.5 kohms h=-0.99 h=14.32 hob=…

A: For the given common base amplifier we need to compute the value of intrinsic output impedance ro.…

Q: Circuit Diagram: B1 9V SW1 D1 R1 1K BZ1

A: The electronics circuit components shown above can be listed as, A 9 V battery B1 A Switch S1 A…

Q: 4. What is the function of the lead-lag network in the Wein Bridge oscillator? 5. Which type of…

A: Here we discuss about Wein Bridge Oscillator. NOTE :- Though each Q. is a separate Q., but…

Q: Consider Figure 67. Calculate the oscillator frequency in Figure 67 for the following circuit…

Q: An AM transmitter radiates 9 kW of power when the carrier is unmodulated an (10.125 kW when the…

A: We need to find out the modulation index and total power transmitted

Q: A device that converts an electrical signal to a standard instrumentation signal is a…

A: In this question, We need to fill the blank. A device that converts an electrical signal to a…

Q: 9. The number of stator slots of an AC electric machine * O can be arbitrary chosen number O depends…

A: In this question we will write about number of stator slots....

Q: Compute the magnetic field intensity B of a long straight wire that has a circular loop with a…

A: Given , Current I=2 ampere, radius r=0.05m , Magnetic field intensity B=?

Q: An abrupt silicon P-N junction is doped with acceptor concentration, N₁ = 5 x 1016 cm-³ and donor…

A: We need to find out the saturation current for given semiconductor .

Q: 1.Three number of single phase ideal transformers, each of rating. 10kVA, 200V / 100V,50Hz is…

A: Line and phase voltage in delta connected system remain same Line voltage is 1.732 times more than…

Q: 1. Consider the circuit shown, the transistor parameters are ß = 100 and VA = 100V. Determine R₁,…

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: The Excess-3 code of 6 is O a. 0110 Ob. 0111 C. None of the above Od. 1001

A: Given: The decimal number is 6

Q: 3.) (Based on Neaman, Problem 4.1) - Calculate the intrinsic carrier concentration at T= 200 K, 400…

A: We know that,ni2=NcNv T3003 e-Eg/0.0259T/300a For silicon,Putting value Nc=2.8×1019 cm-3,…

Q: Solve for the current gain. Z₁ O 1175 O 20 O 135 O 120 www • 330 ΚΩ Vcc To 12.7 ΚΩ HH hfe = 120 hig…

A: We need to find out current gain for given circuit

Q: Q/A- For the circuit below Bdc=200, RB-50K ohm, RC-330 ohm, VBB= 20 volt, Vcc= 30 Volt. Vcc RB www…

Q: Calculate the output impedance of a voltage-series feedback amplifier having A = - 230, Ri = 1.5 kΩ,…

Q: Consider the circuit with an ideal Op-Amp shown in the figure. RE R www ww +V CC Vout Vin VREF -Vcc…

A: We need to find out the condition to get zero output .

Q: 2 sin 100t t V1 (t) ww 10 Q 2000 UF не Fig. 1 V2 (t) 0.1 H 1.5 cos 100t

Q: 1. Consider the LTI system with impulse response h[n] = u[n] (i) Can this system be implemented…

Q: S + ď laplace 6 1872) (5+4) Inverse Transform

A: (i) Given data, Function is given as, FS=SS+2S+4

Q: i) Sub. 5 from 12. Use I's complement. ii) Add. 22 to -47 in binary. Use 2's c iii) Add 3CE to BSD…

Q: 9) Provide one general method to control the speed of an induction motor.

A: The rotor speed (Nr) of an induction motor is given by,??=(1−?)??And the synchronous speed is…

Q: Q1: Answer the following sentences with (True) or (False) then correct the false sentences: 2- The…

A: We need to tell about whether the given statement is true or false.

Q: e Figure below, calculate Z₁.

A: MOSFET (Metal–oxide–semiconductor field-effect transistor)- It is a type if transistor which is…

Q: 2A (↑ 250 VS2 At ४८.

Q: Exercise 4.19 Find the missing data of the DFT: [1 −0i, ?, 3+li, 4 – li, 1 −0i, ?, ?, 2 – 2i .

A: given here some DFT sequence and asked to fnd the missing sequence.

Q: 4. The air gap in a salient-pole synchronous machine * is maximum along the quadrature-axis…

Q: 1 diagrams of both the direct forms I and II simulation diagrams for the systems with the following…

Q: Given: L = 4pH; C = 11.26nF; R=0.18842 IF = 455kHz RF RF Filter Amplifier Mixer IF Amplifier &…

A: For the above given question we need to calculate the value of resonance frequency, quality factor…

Q: In a certain CS amplifier, RD = 2.84kΩ,RS = 560Ω, VDD = 10 V, AND gm = 5.58mS If the source resistor…

Q: In an AM signal that is 100 percent modulated, what maximum voltage value is present in each…

Q: Find the equivalent resistance across the terminal www 202 60- .892 www 202 892

A: Given A resistor circuit,we need to find the equivalent resistance. Please find the below…

Q: the fault current for a

A: Types of open circuit fault- 1) Symmetrical fault- Three phase line to ground fault Three phase…

Q: . For the figure below shows a d.c. Two-source network; the branch currents I, and I₂ are as marked…

Q: 10. With an increase of the current density of the stator winding * the stator winding electric…

A: In this question we will write effect of increasing current density of stator winding....

Q: Q3-A)-Indicate whether the following statements are true or false and correct the false statements…

Q: The electrostatic force on a small sphere of charge 0.4 uC due to another small sphere of charge 0.8…

Q: 1: Answer the following sentences with (True) or (False) then correct the false sentences: 1. *** .…

A: PLF terminology is used for those powee which is not captured from incident wave by the antenna.…

Q: Q: Calculate the output voltage (Vout) by circuit of figure: - 3 Rf=300 Kohm wit-Vir Ri Vin= 1V…

Q: B. Find the energy of signal f(t) = A[u(t + a)- u(ta)]

A: We need to find out energy of given signal

Q: 3. Which of the following statements IS NOT CORRECT ? * for two motors with equal output power,…

A: Motor: It is an electromechanical device. this takes the electrical input and converts this power…

Q: Q4: Find the current in the (2002) resistor by using thevnin theorem? 100, 10 50 20 G 10 V E

Q: Spectrum analyzer screen 8V₁ 4V OV 450 460 kHz

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you…

Q: Q1: Answer the following sentences with (True) or (False) then correct the false sentences: V 2- The…

A: --> The above statement is False. --> The correct statement is " The side lobes appear in a…

Q: TUTORIAL 2: Unbalanced A-connected load A balanced abc-sequence source Vab= 10020° V. Is connected…

A: Given: A balanced abc-sequence source Vab= 100∠0° V is connected to a delta-connected unbalanced…

Q: What are the power quality issues in the interconnected system of solar PV and wind system

A: Given Enumerate the power quality issues in the interconnected system of solar PV and wind. Please…

Q: Find the Fourier series of Triangular wave. T = 2

A: Given We need to find the Fourier series coefficients for a triangular wave. Please find the below…

Q: For the figure below, obtain the actual value of Io 14 6Ω ww 2 V 1, 2Ω Μ 13 I = 15 A 7Ω 1 V 4Ω 1₁ Μ…

A: In this question, we will find current Io using nodal analysis....

Question

(B) The state space representation for a closed loop system is shown in figure (5):
1. What is the poles and zeros for this system
2. Obtain the open loop transfer function G(s) for this system if it has a unity feedback .H(s)-1
-10
U(Q)
10
-12
Figure (5)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1) Explain the concept of positive and negative feedback And derive the formula of closed loop voltage gain? Please don't write by hand
State whether the following statement is true or false. “Dominant pole compensation increases the unity-loop-gain bandwidth of a feedback system.” Please answer with few line explanation.
a) reduce the block diagram with transfer functions into a unity feedback system configuration as shown in Figure 1 b) Using Routh Hurwitz criterion, do stability analysis to the system with K=1.
Loop gain analysis in a feedback system applies for __________. Option (1) small-signal perturbations Option (2) large-signal perturbations Option (3) both large and small-signal perturbations
Find the range of K using the Routh - Hurwitz method for the closed - loop stability of the negative unit feedback system given the open - loop transition function below
Consider a system with no zeros and only one pole as +5. Place this system in the forward path of a feedback system and add a PD controller in the feedback path with proportional gain 300 and derivative gain 40. Now draw the entire block diagram showing the transfer functions of each block clearly. Then find the closed-loop transfer function of the entire system.
Consider a unity negative feedback system with loop transfer function shown in Figure where L(s)=GcG(s)=K(s2+6s+1)(s2+5s+1) Determine the value of K for which the closed-loop system is stable.
Using Routh-criterion investigate the stability of a unity feedback control system whose open loop transfer function is given by, G(s) = (e ^ (- s * T))/(s(s + 2))
This problem pertains to the unity negative feedback control system below. Compute the gain K that will yield a phase margin (PM) of 40°
Discuss the difference between the current series negative feedback amplifier and voltage shunt feedback amplifier in terms of output impedance, input impedance, voltage gain, bandwidth, distortion and noise.
Use any method you like to determine the limiting value of gain K for which the associated unity negative feedback closed-loop system just becomes unstable.
Determine,if it exists,a state feedback gain K such that the closed loop poles are located at −5 and −6.