Please answer letter B only. 0 - 10 m3 is not the answer. Farmville derives its water from two sources, a deep well and a river. Water from the well has practically zero total dissolved solids (TDS), a conservative pollutant. The river is fed by two upstream tributaries withthe following properties:Tributary A : Flow rate = 20 m3/s, 30 ppm TDS concentrationTributary B : Flow rate = 30 m3/s, 25 mg/L TDS concentrationFlow rate downstream of the river is 46 m3/s.A→ 46 m³/sBFarmvilleWellDraw all necessary mass balance diagrams. Label properly.b.If the Farmville community needs 5.5 m/s to sustain its activities, how much water (in m³) does it extract from the well daily? Round off your answer to whole number.What is the TDS concentration of the total delivered water to Farmville (mg/L)? Round off your answer to two (2) decimal places.

(b) Write the given data. QA=20 m3/sQB=30 m3/sQdown=46 m3/s

Answered: b. If the Farmville community needs 5.5…

b. If the Farmville community needs 5.5 m/s to sustain its activities, how much water (in m) does it extract from the well daily? Round off your answer to whole number.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A fluid flows at 450 ft/s with specific volume of 12.8 ft3 /lbm, pressure of 14.7 psia and specific enthalpy of 430 Btu/lbm. Determine (a) the specific internal energy and (b) the total energy if potential energy is neglected. Ans: 395.2 Btu/lbm; 434.04 Btu/lbm
Blowing air from 3 separate vents to a car gallery where the indoor air temperature is 22 °C and the supply air temperature is 45 °C.is sent. The air flow rate of each culvert is 5000 m3/h. According to this situation, what is the hourly heat loss of this hall? (Weather'sdensity= 1.2kg/m3, specific heat of air= 1.005 kj/kgK) A.425056 kj/hB.517080 kj/hC.416070 kj/hD.516175 kj/hE.456178,9 kj/h
In a hydroelectric potential, the upstream level is at an elevation of 1000 m and the downstream level is at an elevation of850 m. Knowing that the useful flow for use is 13 m³/s and the total efficiency of the system (losses ofload + turbine efficiency + generator) is 87%, tick the alternative that contains the electrical powergenerated (consider g = 9.8 m/s² and the density of water as 1000 kg/m³):ALTERNATIVESa) 16,625 MW.b) 16625 MW.c) 13.33 MW.d) 1.66 MW.e) 1.33 kW.
A mining company depleted more than half of its ore reserves and is no longer using all of its shaft infrastructure. It considers using one of the old shafts for pumped-storage hydro-electricity generation. This means that water will be pumped to the higher level, which is 1 000 m above the bottom level, at night when Eskom charges lower, off-peak, rates. The “higher level” will be changed into a dam (reservoir) by means of plugs that will be installed in some tunnels. The stored water has potential energy, which will be used to generate electricity for the mine at peak hours, when electricity is expensive. The pump that will be installed at the bottom of the column will also be used as a turbine for the generation of electricity The pump-as-turbine (PAT) must pump water to a height of 1 000 m through a column with an internal diameter (ID) of 345 mm. 3.1. Calculate the velocity of the water in the pipe if the quantity of water to be pumped is 220 litres per second (lps). 3.2.…
A hydraulic turbine has 50 m head available at a flow rate of 1.30 m^3/s, and its overall turbine generator efficiency is 78 %. Determine the electric power output of this turbine in kW a.237 b.589 c.378 d.497
A 1000 litre containment tank catches the outflow from a processing apparatus which has 800 litres of water with 2g of chemical agent dissolved in it. Additional supply comes into the tank at 3 litres/hr containing 5 g/litre of the chemical agent. The solution leaves the containment tank at 3 litres/hr. When the amount of chemical agent in the containment tank reaches 500 g, no more supply is allowed to enter the system. Instead,fresh water is input into the tank at 2 litres/hr; and at the same time,the outflow is increased to 4 litres/hr. How much chemical agentis held in the containment tank at any time t.Assume all liquids are well-mixed.
Water in the rural areas is often extracted from underground water source whose free surface is 60 m below ground level. The water is to be raised 5m above the ground by a pump. The diameter of the pipe is 10 cm at the inlet and 15 cm at the exit. Neglecting any heat interaction with the surroundings and frictional heating effects, what is the necessary power of the pump for a steady flow of water at the rate of 15 Liters/second in kW a) 9.54 c) 7.82b) 5.34 d) 11.23
Water is withdrawn at the bottom of a large tank open to the atmosphere. The water velocity is 9.5 m/s. The minimum height of the water in the tank is (a) 2.22 m (b) 3.54 m (c) 4.60 m (d ) 5.23 m (e) 6.07 m
A site is being considered for wind power generation. At this site, the wind blows steadily at 6 m/s for 3,323 hours per year. Assuming the wind velocity is negligible at other times for simplicity, determine the kWh/year that can be produced at the site for a turbine with a mechanical efficiency of 100% and an effective flow area of 5 m2. Use a value of 1.25 kg/m3 for the density of the air. Give your answer in killowatt-hours per year (kWh/year). Hint: I reccomend starting by finding the kinetic energy (kJ/kg) of the wind. Hint 2: Multiply the power generation (kW) by the number of hours of wind per year (h/year) to get kWh/year.
15. A hydro-electric plant in Loboc, Bohol discharges 12300cfm and reduces the pressure from 2585mm Hg to 61.06in Hg. Determine the power in kW.
Give examples of pump efficiency and turbine efficiency?
44#6 in steady flow apparatus, 135 kJ of work is done by each kgm og fluid. the specific volume of the fluid, pressure and speed at the inlet are 0.37m^3/kgm,600kPa and 16m/s. the inlet is 32 m above the floor and the discharge pipe is at the floor level. the discharge conditions are 0.62 m^3kgm, 100 kPa and 270m/s. the total heat loss between the inlet and discharge is 9 KJ/kgm of fluid. in flowing through this apparatus, does the specific internal energy increase of decrease, and by how much?