barometric pressure or 1 atmospheric 1pressure is equal to1.019 kgf/cm2 O1 kgf/cm2 O0.9 kgf/cm2 O0 kgf/cm2 O* What is the period of vibration of a system that hask=5000 and m=55 kg0.658 sec0 sec O0.557 sec C0.612 secThe specific volume of a liquid is:the reciprocal ofmass densityspecific volumespecific weight Oweight density* A pressure gage connected to a tank reads 500 kPa at alocation where the atmospheric pressure is 94 kPa..Determine the absolute pressure in the tank594 KPa O550 KPa600 KPa602 KPaA Carnot heat engine operates between a source at1000 K and a sink at 300 K. If the heat engine is suppliedwith heat at a rate of 800 kJ/min, determine the thermalefficiency70%72%75%80%OO

Answered: Image /qna-images/answer/a789b256-2f82-4d22-bc6b-6ce374f1e7bb.jpg

barometric pressure or 1 atmospheric 1 pressure is equal to 1.019 kgf/cm2 1 kgf/cm2 O 0.9 kgf/cm2 O 0 kgf/cm2 O * What is the period of vibration of a system that has k=5000 and m-55 kg 0.658 sec 0 sec 0.557 sec 0.612 sec The specific volume of a liquid is :the reciprocal of mass density specific volume specific weight O weight density O * A pressure gage connected to a tank reads 500 kPa at a location where the atmospheric pressure is 94 kPa. .Determine the absolute pressure in the tank 594 KPa 550 KPa O 600 KPa 602 KPa O A Carnot heat engine operates between a source at 1000 K and a sink at 300 K. If the heat engine is supplied with heat at a rate of 800 kJ/min, determine the thermal efficiency 70% 72% O 75% O 80% O

barometric pressure or 1 atmospheric 1 pressure is equal to 1.019 kgf/cm2 1 kgf/cm2 O 0.9 kgf/cm2 O 0 kgf/cm2 O * What is the period of vibration of a system that has k=5000 and m-55 kg 0.658 sec 0 sec 0.557 sec 0.612 sec The specific volume of a liquid is :the reciprocal of mass density specific volume specific weight O weight density O * A pressure gage connected to a tank reads 500 kPa at a location where the atmospheric pressure is 94 kPa. .Determine the absolute pressure in the tank 594 KPa 550 KPa O 600 KPa 602 KPa O A Carnot heat engine operates between a source at 1000 K and a sink at 300 K. If the heat engine is supplied with heat at a rate of 800 kJ/min, determine the thermal efficiency 70% 72% O 75% O 80% O

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A pump 254mm suction pipe and a 127mm discharge pipe is used to deliver 52L/s of water. The suction gage reads 15.6 kPa vacuum and the discharge gage located 100 cm above the suction gage which reads 108 kPa gage. Determine the following: a. the total dynamic head in meters 13.865 14.409 13.415 b. the water power in kW 7.831 7.348 8.245 c. the motor horsepower if the pump efficiency is 66% 15.935 14.924 13.935
A 227 kg bear* is 15 ft up a tree when it falls onto a trampoline deforming it 3 ft (where it touches the ground). Neglecting friction and mass of the trampoline (and assuming the trampoline is a simple spring), what is the spring constant of the trampoline? 1 m = 3.3 ft * the bear was OK a. 24,470.60 N/m b. 2,441.93 N/m c. 741.53 N/m d. 7,415.33 N/m
An experiment is done on a single cylinder engine whose crankshaft makes two complete revolutions in every cycle and the observation data were recorded for 1 hour duration: Crankshaft revolutions =70000, Indicated mean effective pressure=38*0.7 bar, Engine swept volume=1.1 litres, Brake load on dynamometer=6kg, Brake drum diameter=37*0.8 cm, Fuel used=Diesel, Calorific value of fuel=41*0.75 MJ/kg. What percentage of indicated power is available at the engine output shaft? What will be the Indicated Specific Fuel Consumption (ISFC) in kg/kWh, if the conversion efficiency of heat released in the cylinder to indicated power is [38*0.9] %. If the conversion efficiency is less than or equal to 35%, then use [71]*0.5 % for finding conversion efficiency.
To measure the density of a stone, a digital scale and a beaker cup filled with water are used. The balance is used to measure the mass of the stone, while the beaker is used to measure the volume of the stone. It is known that the digital balance has a resolution of 0.1 g and that the beaker cup has a resolution of 5 ml. Repeated mass measurements return the following values: 250.0 g; 249.9 g; 250.3 g; 249.6g; 250.1 g; 249.7g; 250.4 g; 250.0 g; 248.8 g; 250.2 g The volume is measured only once. Placing the stone in the beaker, a volume of displaced water equal to 50 ml is measured. Using a k=2.5, check if the density of the stone is compatible or out of line with the value ρ = (4910 ± 65) kg.m-3 (a) none of the above (b) the values are compatible (c) missing data to perform the compatibility test (d) the values are discrepant
F = 100 Sin(wt) K = 112.5 lb/in M = .50 lb-sec²/in w = 15 rad/sec The displacement of the system shown below must be limited to 50 inches, measured from th static equilibrium position of the system. Determine approximately how long the system will run before it must be shut down. a. 0.1 sec b. 7.5 sec c. 2.0 sec d.75. sec e. 10 sec f. 50.0 sec g.none
In a dead weight tester experiment, theoretical pressure is 4 bar, error is 0.04997% , then its approximate measured pressure is __________ A. 16 bar B. 1600000 N/m2 C. None of the answers given D. 2 bar
During testing of single cylinder two-stroke petrol engine following data were obtained. Brake torque = 640 Nm, cylinder diameter 21 cm, speed 350 rpm, stroke length = 28 cm, mean effective pressure = 5.6 bar, oil consumption = 8.16 kg/h, calorific value of the fuel = 42,705 kj/kg. Determine: Srake thermal efficiency
1. The 1st Law of Thermodynamics gives any information on the feasibility of the change of stateor process. The Second Law of Thermodynamics provides the basis as to the probability ofdifferent processes.A. Both statements are correct.B. Both statements are incorrect.C. Statement 1 is correct while Statement 2 is incorrect.D. Statement 1 is incorrect while Statement 2 is correct 2. The ratio of Cp/R is dependent on the unit of the universal gas constant. Its parameters areindependent of temperature and depends on the value of the constant pressure.A. Both statements are correct.B. Both statements are incorrect.C. Statement 1 is correct while Statement 2 is incorrect.D. Statement 1 is incorrect while Statement 2 is correct. 3. A reconstruction has resisted the combined efforts of the government’s militaryestablishments. It can at best be accomplished by a hen fed with the remains of the original. Thisanalogy best represents the concept of ___________.A. Spontaneous ProcessB.…
What is the specific weight of air at a temperature of 30 degrees C and absolute pressure of 560 kPa?a. 51.45 N/m3 c. 67.56 N/m3b. 45.35 N/m3 d. 63.17 N/m3 An oil sample wight 38612.16 N and has a volume of 4.8m3. Calculate the specific gravity of the said sample.a. 0.67 c. 0.82b. 0.75 d. 0.68 An 8m3 of air at 28 degrees C and absolute pressure of 176 kPa is compressed to 4m3. What is the resulting pressure assuming isothermal condition?a. 352 kPa abs. c. 345 kPa abs.b. 423 kPa abs. d. 245 kPa abs.
A 45 grams (0.045 kg) golf ball of diameter equal to 43 mm fell into a 2m deep lake. Neglect inertia at the moment of impact. Assume viscosity of 1.12x10-3 Ns/m2 , water density of 1,000 kg/m3 and Cd=0.5. Sphere volume equals 4π r³ /3. 1. How long will it take from the moment it hits the surface until it gets to the bottom? 2. If one estimates the Cd with Cd=24/Re formula, the settling velocity would be unrealistically large. Why?
The force-deflection relation of a steel helical spring used in an engine is found experimentally as F( x) = 200 x + 50 x2 + 10 x3, where the force (F) and deflection (x) are measured in pounds and inches, respectively. If the spring undergoes a steady deflection of 0.5 in. during the operation of the engine, determine the equivalent linear spring constant of the spring at its steady deflection.
assume SI units, & 1 atm = 105 Pa; ρwater = 1000 kg/m3; ρair = 1.2 kg/m3; g = 9.8 m/s2