Based on the print, how many contacts are associated with relay CR? a 2 b 3 c 4 d 5

Q: + | t=0 100 V 32 ΚΩ w 0.5 μF HF 240 ΚΩΣ 60 ΚΩ

A:

Q: How many bits are required to represent 6 unique numbers? -2.58 3

A: Given data: How many bites are required to represent 6 unique numbers

Q: 85[1+0.4432/1-.85(sqrt(48.2625/V))]=100 Solve for V

A:

Q: 1. Assume that the JFET with the transconductance curve shown in the figure for Problem 3 is…

A:

Q: The 10-cm-wide, zero-resistance slide wire shown in (Figure 1) is pushed toward the 2.5 12 resistor…

A: In this question we need to find the following Pushing force How much power does the pushing force…

Q: For controlled half wave rectifier, R=80ohm, f=50Hz and Vm=280V and a=0,2 rad. Calculate the rms…

A: We need to find out the RMS current current for given rectifier.

Q: 5. Derive an equation for the output voltage, vo(t), in terms of vi(t) and v₂(t). M R₂ vi(t) R₁ M…

A: In this op-amp circuit we need to calculate the Vo(t) in terms of V1(t) and V2(t). Circuit:-

Q: Draw the root-locus graph for the closed loop system given below. Using this graph, maxi-

A:

Q: r.p.m. windage Calculate: i) The slip. ii) The rotor copper loss. iii) shaft power and iv) The…

A: In this question we will find slip , rotor cu loss , shaft power and efficiency.....

Q: Calcule la potencia disipada por la resistencia de 8.002 en el circuito ilustrado en la figura de…

A: The circuit diagram,

Q: In MEMS the ratio between the forces of parallel plate and the forces of interdigitated capacitors…

A: It is asked to determine the ratio between the forces of parallel plate and the forces of…

Q: Find the current in the RLC circuit, assuming that E(t) = 0 for t > 0 R = 4 ohms; L = .05 henrys; C…

A: In this question we need to find the current in the RLC circuit .

Q: ucation VB Geçiş yap... + H. R₁ W Consider the circuit shown above, assuming ß = 150and Is = 7 x…

A:

Q: 1A ↑ ww 8 Ω; 0.04 F Š + vc(t) 0 i(t) 1H

A:

Q: For the shown root locus in the figure below, answer the following questions 1-  Number of Poles…

A: We answer the following questions we use root locus.

Q: Use nodal analysis to find the voltage V in the circuit given below, where vs = 145 -10 V. Please…

A: In the given questions we need to calculate the node voltage V.

Q: SP10: Reduce the following state table NS, Z into standard form. NS, Z PS A B C D E F G PO: (a b c d…

A:

Q: In figure 3, the supply voltage V is_ a. 500V b. 100V c. 200V d. 400V The voltage across LC…

A: In these questions.  We need to choose the correct options As per ohms law, Voltage across the…

Q: An inductive load is controlled by an impulse commutation chopper in Fig.1 and peak load current…

A: “Since you have posted question with multiple sub parts,we will provide the solution only to the…

Q: For controlled half wave rectifier, R=35ohm, f=50Hz and Vm=280V and a=0,5 rad. Calculate the power…

A:

Q: A regular Wheatstone bridge is used to measure high resistance. The bridge has ratio arms of 10,000…

A: Regular Wheatstone bridge-

Q: madı rinden hiş Vx 1 A B I Ix H IR1R₁ + R₂ VB In the circuit above, plot Ix and IR1 as a function of…

A: We need to draw graph between voltage and current for given circuit.

Q: The voltage of an ac source is given by V(t) Vo sin ut, where V-80 V and w=240 rad/s. Calculate the…

A: Vt=V0sinωt V0=80 V ω=240π rad/s C=25 μF L=5 mH R=35 Ω To find out We have to determine the average…

Q: Let v = 60 cos(200t - 10°) V. 2 ΚΩ 100 mH m ΓΚΩ 10 με ΙΚΩ

A: Supply voltage; Vs=6 cos200t-10° V Inductance value; L=100 mH Capacitance value; C=10 μF Resistance…

Q: Question 2. The efficiency of a 17 kW, 4-pole, 50 Hz, three-phase asynchronous motor is given as…

A: The output power of the motor, P∘=17 KW Number of poles, P=4 The supply frequency, fs=50 Hz The…

Q: Differences between IEC (European) and ASIA standards for electrical safety

A: We need to differentiate between IEC (European) and ASIA standards.

Q: 7.2.16 Use the step-by-step method to find vo(t) for t> 0 in the given circuit.

A: Given circuit,

Q: What distinguishes the old telephone networks and exchanges from their digital equivalents is the…

A: Telephone it is a device which is used simultaneous voice data transmission. It previously it  is…

Q: -Draw the sign given below for the interval n ∈ [ -20,20 ]. x[n]= exp[(2 + j3)n] x[n]=3 cos(0.1πn +…

A: Given: Two discrete time signals:  x1[n]= exp[(2 + j3)n], x2[n]=3 cos(0.1πn + π/3) + 2 sin(0.5πn) ,…

Q: circuit in the figure.) VB=25.2 V, VD ON=800 mV, R₁=5 k /Circuit Parameters Vin Vin is increased…

A: Given that  VB=25.2 v VD(on)=800mv R1=5kohm. We need to find the condition for Vin and Vout for the…

Q: Obtain the Norton equivalent of the circuit depicted in the figure at terminals a-b. Given: is = 9…

A: In this question we need to obtain the Norton equivalent circuit .

Q: The circuit shown below has a sinusoidal input voltage given by v(t) = 15 cos(10t + 20°) V Find the…

A:

Q: Aşağıdakilerden hangisi Kartezyen koordinatlarda verilmiş bir vektördür(notasyona dikkat ediniz)?…

A: We have total three coordinate systems 1.Rectangular coordinate system 2.Cylindrical coordinate…

Q: lov. GaAs 2ks 吡 Find ID & Vo 2 k •Vo 2k Ou GROUND لصمه

A:

Q: 10 22 15 µF 30 V 3 mH 6Ω Figure #3 a. Given that the circuit shown in Figure #3 is at resonance,…

A:

Q: A planar optical waveguide of length = 5 cm is fabricated in an epitaxial layer of GaAs that has an…

A: A planar optical waveguide of length =5 cm is fabricated in an epitaxial layer of GaAs that has an…

Q: HW5: Problem 3. In the following circuits find all the node voltages and branch currents. Assume…

A: Given, beta =100 We need to calculate the all the currents Ic,IB,IE . And all the voltages  Vc,VB,VE…

Q: Problem 3: The circuit below is a BJT common collector amplifier. Obtain expressions for oth the…

A:

Q: 1. A grid consists of three units given: F₁ = 380 +5 P₁+0.00156 P₁² h 230MW ≤ P₁ ≤ 550MW 180MW P₁ ≤…

A: In this question we need to find what unit combination of units should supply the given load most…

Q: A 3-D power system experienced an unbalanced fault type had the following sequence voltages at the…

A: In this question we need to find the following Calculate the related phase components Identify the…

Q: 11.15 In the circuit of Fig. 11.46, find the value of Z, that will absorb the maximum power and the…

A: Need to find the value of load impedance for maximum power delivered and the value of maximum power…

Q: b. Hence or otherwise, determine the numerical values of the corresponding poles and zeroes for the…

A:

Q: Determine conditions for a system being memoryless, causal and stable through its impulse response…

A: In this question we discuss the condition for a system being memoryless , causal and stable.

Q: The integrator of Figure 2 senses an input signal given by Vin Vo sin oot. Determine the output…

A:

Q: Vx Ix R₁R₁ R₂ VB D₁ Ideal In the circuit above, plot I x and I R1 as a function of V x for two…

A: Given: A circuit,  To do: We have to plot IX and IR1 as function of Vx.  a) When VB= -1.5 V, b)…

Q: 91 My two ears want current, resistance, inductance, and capacitance For a source voltage of 100 92…

A: The circuit diagrams,

Q: 2) Fill in waveforms for Q and D_OUT D P.. D_IN CLK CLK D_OUT D_IN D_OUT Ti

A: given logic diagram is

Q: For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V. Calculate the average…

A: To calculate the average current for an uncontrolled half-wave rectifier, we can use the following…

Q: R=652 X₁ = -852 wwwmm a. I-20A a. b. C. 13. The power consumed in the circuit shown in fig. 1 is. a.…

A: In this question we need to choose a correct option.

Q: 1. circuit. 3k0 Use the differential equation approach to find vc(t) for t> 0 in the given 6V 1-0 4…

A: It is given that:-

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.