Basic Electrical Engineering) An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Basic Electrical Engineering) An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PA: You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor...

See similar textbooks

Related questions

Q: A car battery has gone dead and it needs to be replaced with a large capacitor. The old car battery…

A: To solve above problem, one should know capacitors and capacitance offered by a capacitor. A…

Q: A coil induces 500 mV when the current changes at the rate of 0.2 A/sec, then the value of…

A: The value of inductance is 2.5 Henry. The detailed solution is provided below.

Q: Solve for the value of the capacitance (in nF unit) if R2 = 1035 ohms and Xc = 2132 ohms. Round…

Q: 14. At what frequency will a 2-μH inductor have a reactance of 300ohm? 15. A 2.5-μH inductor has a…

A: L=2uHXL=300Ω

Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…

Q: "If a current of 5A flowing in a coil of inductance 0.1H is reversed in 10ms, emf induced in it is…

A: In this question we will find emf induced in coil...

Q: 14 Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA…

A: Given data, Inductance L= 10 mH =10×10-3 H Current flowing through it i=2 mA

Q: equivalent

A: Here,

Q: To what circuit element does a very large (ideally, infinite) inductance having an initial current…

A: Given that circuit element has large inductance and initial current of 10 A.

Q: How much energy is stored by a 100 mH inductance with a current of 1 A?

A: It is given that: L=100 mHI=1 A

Q: A suspension string has 3 units. Each unit can withstand a maximum peak voltage of 11kV. The…

A: Parameters given are: Maximum Peak Voltage=11kV, Number of Insulator Discs,n=3, The capacitance of…

Q: The energy stored in 2000 turns inductor is 20 Joules, if the inductance value is 3 H. Find, (a)…

A: Inductive coil,

Q: Question 5 An inductive coil has a resistance of 9.5 ohms. A battery of 115V is suddenly connected…

A: Given a inductive coil has, Resistance, R=9.5 Ω Battery voltage, V=115 V Rise current, I = 10 A…

Q: voltage v = 120 sin 377t V is applied across a pure capacitance of 100μF, Determine the energy in…

A: We need to find out energy stored by capacitor

Q: Given L1 6µH, L2 6µH and the equivalent inductance of the circuit Leg = 9.6000µH, then L = μΗ Note:…

Q: The switch (SW) in the circuit is opened for a long time shown Figure 2. A. Calculate the expression…

Q: 100 V 50 8mH 600 200 A The switch is initially open in the circuit diagrammed above. A) What current…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Basic Electrical Engineering 1. Derive the formula for the energy stored in an inductor

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find the mathematical expression for current İ2(t) b) Calculate the complex power on the inductance

Q: When the capacitor is fully charged, how much energy does it store (in Joules, 2 sig figs)? How…

A: The circuit mentioned above employs a capacitor and resistor network in the first loop while the…

Q: Figure shows the waveform of the current passing through an inductor of resistance 1 N and…

A: Inductor is a passive component used in electric circuits. When current flows through an inductor it…

Q: 23. It is desired to operate a 100 W, 120 V lamp at its current rating from a 240 V, 50 Hz supply by…

Q: A circuit possesses an inductance of 1 H when a current through coil is changing uniformly at the…

A: Given: A circuit possesses an, Inductance, L = 1 H Rate of change of current, didt=1 As Opposing emf…

Q: The energy stored in 1000 turns inductor is 15 Joules, if the inductance value is 4 H. Find, (a)…

A: In this question , we will find current flowing through coil and flux linking with coil with given…

Q: Solve for the value of the capacitance (in nF unit) if R2 = 1057 ohms and Xc = 2365 ohms. Round your…

Q: Complete the table below by computing for the equivalent resistance, capacitance or inductance:…

A: We need to calculate the equivalent capacitance for given circuit .we will use series and parallel…

Q: Question 3 (a) Briefly describe the capacitance of a capacitor. i. When area between the plates of a…

Q: W =Cv? The equation above describes the amount of energy stored in a capacitor in joules, W, in…

Q: May you please help me to find equivalent inductance Lab

A: Inductor impedances can be combined in the same as we combine resistances. When two inductors are…

Q: 1. A resistor of resistance 20 ohms is in series with an inductor of inductance 2H. At t = 0, it is…

A: Given data, The value of resistance is R = 20 Ω. The value of inductor is L = 2 H. The value of…

Q: What is the reactance (in Ohms) of a 0.15H inductor at 198rad/sec? (Give answer in 2 decimal places.

A: Here we are given, L= 0.15 H. ω= 198 rad/sec. The reactance(opposition) offered by inductor to flow…

Q: (a) The energy stored in 1400 turns inductor is 10 Joules. If the inductance value is 2 H, Find the…

A: To find the current through the coil And flux linking with the coil in mwb Average induced emf

Q: 1. What is an inductor and what consist of inside?

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: 14 Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA…

A: Given data, Inductance L=10 mH. Current flowing through inductor i=2 mA.

Q: 29. A telephone circuit has a capacitance of 6 microfarads. What current flows through it when 15 V…

Q: 10.A 100-µf capacitor is connected in series with a 150-volt voltmeter that has a resistance of…

A: In this question, we need to determine the reading of the voltmeter V, Where sensitivity of the…

Q: Complete the table below by computing for the equivalent resistance, capacitance or inductance. L,…

A: Given circuit,

Q: Draw the phasor diagram, also write the voltage and current relation statements for the following…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 37 ohms R2 = 46…

Q: (1) Find equation of current if charge q(t) = 5t2+10t+10. Also find value of current at t = 1sec.…

A: (1) Given values are - qt=5t2+10t+10

Q: In your solution, follow the sequence: Given, unknown, solution, and final answer. BOX your final…

A: Use ac network analysis Impedance for ac circuits

Q: An inductor has an inductance of 0.025 H and a wire resistance of 3 . How long will it take the…

Q: n a minimum of 10 sentences: 1. Define resistance, inductance, and capacitance. 2. Describe how…

A: Resistance : Resistance of any circuit is the opposition of current flow in the circuit it resists…

Q: Determine the equivalent inductance of the figure.

A: Brief description: For the given circuit by the clear identification of the placing of the dots we…

Q: Suppose that the equivalent circuit shown in Figure 3.24 accurately represents a real inductor. A…

A: The circuit diagram is,

Question

(Basic Electrical Engineering)

An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A 150V moving iron volt meter intended for 50Hz has an inductance of 0.7H and a resistance of 3K ohm. Find the series resistance required to extend the range of instrument to 300V if this 300V - 50Hz instrument used to measure dc voltage find the dc voltage when the scale reading is 200V
Perform calculations of all circuit currents, the current of each element (source, resistors, capacitors, and coils), also perform voltage calculations on resistors, coils, and capacitors. If you can't do some calculation, explain why.1
A capacitance is rated 100 kVar, 380 volts, 50 hz. What will its rating be at 60 Hz 220 V?
An electrical circuit contains a capacitor of 11.24 microfarads and a resistor of 1124 ohms. If the capacitor is fully charged, and then the voltage is interrupted, in how much time will about 63% of its charge be transferred to the resistor?
A circuit with a supply voltage of 2.5 V is being powered through a package. The packagehas a resistance of 100 m and a certain inductance L. The circuit requires at least 2.25 Vto function correctly. If this voltage is required in a time of 1ns, calculate the effectiveinductance L for the package.
A suspension string has 3 units. Each unit can withstand a maximum peak voltage of 11kV. The capacitance of each joint and metal work is 20% of the capacitance od each disc. Find (i) maximum line voltage for which the string can be used. (ii) string efficiency
Solve for the value of the capacitance (in nF unit) if R2 = 1035 ohms and Xc = 2132 ohms. Round your answer to 2 decimal places.
Please inform in clear handwriting on how you do the work and solve the answer I must make a DC circuit with any two of a resistor, capacitor, or inductor 1) Choose values voltage, resistance, capacitance, and inductance 2) Calculate the time constant or frequency 3) Graph the voltage and current over time
The pure element is either resistor, inductor, or capacitor. Determine the values of either the resistance, inductance, or capacitance. Write the magnitude only in micro (µ) in four decimal places. the correct answer is 96.1171 please show the solution thank you.
An inductance of 2 henries and a resistance of20 ohms are connected in series with an emfof E volts. If the current is zero at time, t = 0,find the current at the end of 0.01 sec if E =100sin150t volts.