A capacitance is rated 100 kVar, 380 volts, 50 hz. What will its rating be at 60 Hz 220 V?

Q: PROBLEM 3: Four capacitors are connected in parallel with a battery shown in the figure. Simply the ...

A: We need to find out voltage, charge and energy for each capacitor in the given circuit

Q: Find the Nyquist rates for the following signals: X(t)= sin (20t) X(t) =4sin (30nt) + 3cos (70nt) X(...

A:

Q: Provide a brief (a few phrases) definition and description of each of the following, as well as an e...

A: In consideration of complex system, there are many differential equations. These equations are commo...

Q: 2) DC transistor analysis: Find the indicated DC values: Vbase, Vemitter, Vcollector, Icollector Voc...

A:

Q: Calculate the equivalent inductance of the circuit if the 6-mH inductor and the combination of 8-mH ...

A:

Q: A flow chart detailing the sequence of manufacture of the energy saving switch for a kettle.

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: To calculate the peak voltage for V1 and V2 if Vs is 60V.

A: Sinc  Vs = V1 + V2   In centre tapp transformer, tapping is done at centre of the winding. So V1 = V...

Q: The wistantanerus valkres of furo altemating curpente are grven by i,-voSmiot and i, =10 Sin (ot + )...

A: In this question,  Two alternating current is given.  Find the sum of the both current using the pha...

Q: Question No. 2: Let z1 = 2 - j2 and z2 = 2 + j6 (a) Compute the polar form of z1 and z2. (b) Compute...

A: Note: As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...

Q: Use the analytical method, design a

A:

Q: The message signal m(t) = a cos(2nft)is used to either FM or PM for the carrier A, cos(27f t). Find ...

A:

Q: -5 V Si O V oVo Si 2.2 kQ 6 -5 V

A: Consider the diode connected to 0 V supply has the threshold voltage drop of 0.7 V.  

Q: 8/ The voltage and current across a terminal-pair are given by v(t) = 1+ 1.414 cos t, i(t) = 3 + 5.6...

A: Voltage is given as,vt=1+1.414cost Current is given as, it=3+5.64cost  

Q: Q1: i. Identify and write the name of rectifier giving output as in Figure B2. Output Input Figure B...

A: (ii) Since the negative half cycle is absent in the output waveform the circuit shown is of half wav...

Q: 4.15 For the circuit in Fig. 4.83, use superposition to find i. Calculate the power delivered to the...

A:

Q: List twenty farming operations requiring electrical power. Discuss the advantages and disadvantages ...

A: Electricity Electricity plays an important role in farming operations. It helps the farmers for the ...

Q: Determine Rc RE Rb

A: The given circuit is shown below:

Q: For the circuit in Figure 05, determine the values of labeled node voltages and branch currents assu...

A: We need to find out node voltage and branch current for given circuit

Q: 5 w(t) <(t) Σ d/dt y(t) -3 y(t) + 15dy(t) - 5 dz(t) dt а. = 0 dt - 5 de (t) dt b. dy(t) y(t) + 3- dt...

A:

Q: ww- Rs Di Ish Im Rsh Rm ас Input Rectifier Type of Voltmeter

A: Types of Measuring Instrument Indicating type Instrument (PMMC) Integrating type instrument (Energy...

Q: If we connect a load resistor (RL ) between the terminals a and b, find the value of RL in order to ...

A:

Q: 3/ Calculate the form factor of the triangular voltage waveform shown below v(t)4 10- t(sec) Ans [1....

A: Given Form factor:It is the ratio  of rms value to the average valueForm factor=RMS valueAverage va...

Q: Calculate the current in each resistor. Show complete solutions

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's voltage law and ...

Q: Define rectification. List different types of rectifiers.

A: Rectification is the process by which an alternating current is converted into direct current and al...

Q: Solve the following system by any method 211 - 12 + 313 + 514 = 21 1 - 213 + 14 = -1 511 - 512 + 13 ...

A:

Q: Find the K-maps for the following functions. Eliminate the 0-hazards for the circuit associated to F...

A: In K-map 1. Cover all the adjacent 1's by the same grouping: Eliminates static 1 hazard. 2. Cover al...

Q: aplace transform of the initial and final values ​​of the current i0(t) in the circuit in Figure 2. ...

A: Solution-  For t = 0-,  For this condition, the system is for long time with supply  of 4A only. Ca...

Q: Q1. For the circuit shown in Figure below find the maximum and minimum values of zener diode current...

A: Zenor diode current is maximum when source voltage is maximum. Zenor diode current is minimum when s...

Q: Rz Ri vina VX V2 find

A:

Q: Assume the following system transfer function: к-1 G(s) s³+(K+)s²+2Ks+2 Determine the range of value...

A: The transfer function is given below,G(s)=K-1s3+K+32s2+2Ks+2

Q: A three-phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure b...

A: Transposed line: It is an arrangement of conductors. In this conductors are periodic changes its pos...

Q: Problem 3 What should be the value of R such that maximum power transfer can take place from the res...

A: According to guidelines we are allowed to do only first question. Post again for remaining one 

Q: A PMMC frame has 0.4 m2, 50 number of winding around the coil and flux of 0.30 Wb/m2 = T or Tesla (T...

A: In this question,  If number of turn N= 50 Area = 0.4m2  Flux = 0.3wb/m2   If current flow in then f...

Q: 12. 3) vi Vo Vo Out. draw Voi

A: Given: Consider the circuit: To find: Determine and draw Vo.

Q: - Determine the average power for a signal with the following complex Fourier coefficients: 0.5, n=0...

A:

Q: Design a passive RC low pass filter (see Fig. 14.7) with a cutoff frequency of 100 Hz using a 4.7µF ...

A:

Q: Examlpe: Assume that an analog signal is given by a) x(t) = 5 cos(4 × 10 t) + 3 cos(6 x 10 tt),t 2 0...

A:

Q: How many lines are there in an NTSC signal? a) 1024 b) 1856 c) 625 d) 525

A: We need to select correct option for NTSC lines.  

Q: Two Alternators are operating in parallel supplying a common load of 4250KW at 85% power factor lagg...

A:

Q: discuss an application that uses a transistor amplifier for its operation. It would be best to inclu...

A: DISCUSS: application that uses a transistor amplifier 

Q: We know the Fourier coefficients a,, b, of some signal which is being transmitted. The transmitter m...

A: The fourier coefficients are affected by doubling and shifting   the modified parameters are written...

Q: A 600-kg machine is mounted on a rigid floor of a factory through a spring of stiffness 1,500,000 N/...

A: I am answering first three parts of this question as per guidelines.

Q: 22 4Ω ww st s ら* 10 V 82 6 V +1

A:

Q: Solve the following system of equations using the Gau 5. 27x + 6y – 2 = 85, x+ y + 542 = 110, Gx + 1...

A:

Q: Solve the following system of equations using the Gauss-Seidel iteration method. 6. 4x + 2y + z = 14...

A:

Q: I 42 J22 42 J252 2 10.8: For the circuit shown, Find the currents w.r.t voltages equations (Y-Parame...

A: Apply KVL in two loops to find two equation in terms of voltage V1 and V2. According to KVL sum of v...

Q: ) In a half-wave rectifier, what causes the difference between the amplitude of the input AC voltage...

A: a) Because of stepdown transformer and single diode causes the difference between the amplitude of i...

Q: 1. As shown in Figure 13- 14, compute the amplitude of the voltage Vo, across the capacitor when the...

A:

Q: Triangle Sketch the graph in the time domain and find the Fourier series represen- tation of the fun...

A:

Q: Laplace transform

A: Delta Function- It is also known as the unit impulse function. It's value is equal to zero everywher...

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.