Below is a trapezoidal beam with 3-28mm reinforcing bars at the bottom. Using the design properties of fc' = 21MPa, fs = 140MPa, n = 7, 50mm effective cover, determine the following: Note: Assume the beam has cracked. 650 50 500 000 200 150 150 What is the flexural capacity of the beam Express your answer in KN-m.

Below is a trapezoidal beam with 3-28mm reinforcing bars at the bottom. Using the design properties of fc' = 21MPa, fs = 140MPa, n = 7, 50mm effective cover, determine the following: Note: Assume the beam has cracked. 650 50 500 000 200 150 150 What is the flexural capacity of the beam Express your answer in KN-m.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Compute the slope at support A and the deflection at point B. Express the answer in terms of EI. P = 20 kN. L = 8m USE ANY METHOD
The beam is 7m long with EI = 200MNm^2 Let P = 10 kN Find: 1. Slope at 2m from A. 2. Deflection at 2m from A.
Determine the midspan deflection. Use γ=24 kN/m^3 and fc'= 24 MPa
Calculate and draw the internal forces created at H section of the bracket beam? a = 500 mm b= 200 mm Px= 15 Kn Py=0 Kn Pz = 10 Kn
Find the slope and deflection at B and E of the beam and loadings shown using unit load method. The section of the beam is tubular with outer diameter of 500mm and inner diameter of 200mm. E=20GPa. (point B is not an internal hinge).
A horizontal beam AB is freely supported at A and B, 8metres apart and carries uniformly distributed load of 15KN/m run (including its own weight). A clockwise moment of 160KN-M is applied at a point C, 3metres from left hand support A.using Macaulay method, calcite the beam at C if El=40×10^3KN-m^3
Determine the slope at the roller B of the double overhang beam shown. Take E = 200 GPa, I = 18(106) mm4.
Situation 11 An overhang beam is loaded as shown below. The beam cross-section was built by attaching two (2) channels to a 9mm thick plate using 16mm rivets The property of the channel is given: Determine the spacing, in mm, of rivets on the steel plate.
Before the load P was applied, a gap, ?0(2.75mm) existed between the cantilever beam AC andthe support at B. Knowing that E=200 GPa, determine the magnitude of P for which thedeflection at C is δ(5.5mm) and the reaction at B. (Hint: Use the method of superposition and beam deflections in Appendix A)
If the midspan deflection is 50mm, and the load P = 15KN, determine the maximum length L of the beam without failure. See figure 02 below.
For the beam and loading shown, determine (a) the deflection at point C, (b) the slope at end A.
Need help asap Using double integration method, Find: A. Solve the deflection 10ft. from the fixed support (downward) B. Solve the slope at the free end (CW or CCW) C. Solve the slope 10ft. from the fixed support (CW or CCW) D. Solve C2 E. Solve the deflection at the free end (downward)