Bendalir mengalir melalui tiub pada ketinggian h, halaju v, dan tekanan P yang berbeza. Terbitkan persamaan Bernoulli dengan menggunakan prinsip keabadian tenaga. Fluid is flowing through the tube at different height h, velocity v, and pressure P. Derive the Bernoulli equation by using the principle of conservation energy. (c) Minyak badam dengan ketumpatan p = 910 kg/m³ mengalir dengan lancar melalui paip mendatar yang meruncing di kawasan keratan rentas dari A1 =4.20 x10-3m2 kepada A2 = A1/2. Perbezaan tekanan antara bahagian paip A, dan Az ialah 5000 Pa. Kira kadar aliran isipadu minyak badam. Almond oil with the density p = (d) 910 kg/m³ flows smoothly through a horizontal pipe that tapers in cross-sectional area from A1 =4.20 x10-3m2 to A2 = A1/2. The pressure difference between A, and A2 is 5000 Pa. Calculate the volume flow rate, Ry of the almond oil.

Bendalir mengalir melalui tiub pada ketinggian h, halaju v, dan tekanan P yang berbeza. Terbitkan persamaan Bernoulli dengan menggunakan prinsip keabadian tenaga. Fluid is flowing through the tube at different height h, velocity v, and pressure P. Derive the Bernoulli equation by using the principle of conservation energy. (c) Minyak badam dengan ketumpatan p = 910 kg/m³ mengalir dengan lancar melalui paip mendatar yang meruncing di kawasan keratan rentas dari A1 =4.20 x10-3m2 kepada A2 = A1/2. Perbezaan tekanan antara bahagian paip A, dan Az ialah 5000 Pa. Kira kadar aliran isipadu minyak badam. Almond oil with the density p = (d) 910 kg/m³ flows smoothly through a horizontal pipe that tapers in cross-sectional area from A1 =4.20 x10-3m2 to A2 = A1/2. The pressure difference between A, and A2 is 5000 Pa. Calculate the volume flow rate, Ry of the almond oil.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 129CP: Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow...

See similar textbooks

Similar questions

Suppose you have a wind speed gauge like the pitot tube shown in Figure 14.32. By what factor must wad speed increase to double the value of h in the manometer? Is independent of be moving fluid and be fluid the Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.
Water pressure inside a hose nozzle can be less atmospheric pressure due to the Bernoulli effect. Explain in terms of energy how the water can emerge from the nozzle against the opposing atmospheric pressure.
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
(a) Using Bernoulli's equation, show that the measured fluid speed v for a pitot tube, like the one in Figure 12.7(b), is given by v=( 2gh)1/2 , where h is the height of the manometer fluid, is the density of the manometer fluid, is the density of the moving fluid, and g is the acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in the text.) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 12.7 Measurement of fluid speed based on Bernoulli's principle. (a) A manometer is connected to two that are close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, and so the fluid has a speed V across the opening; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , and so h is proportional to 12v22 . (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
Prove that the speed of an incompressible fluid through a constriction, such as in a Venturi tube, increases by a factor equal to the square of the factor by which the diameter decreases. (The converse applies for flow out of a constriction into a larger-diameter region.)
Construct Your Own Problem Consider a coronary artery constricted by arteriosclerosis. Construct a problem in which you calculate the amount by which the diameter of the artery is decreased, based on an assessment of the decrease in flow rate.
Calculate the Reynolds numbers for the flow of water through (a) a nozzle with a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when the nozzle is attached to the hose. The flow rate through hose and nozzle is 0.500 us. Can the flow in either possibly be laminar?
Water emerges straight down from a faucet with a 1.80-cm diameter at a speed of 0.500 m/s. (Because of the construction of the faucet, there is no variation in speed across the stream.) (a) What is flow rate in cm3/s? (b) What is the diameter of the stream 0.200 m below the faucet? Neglect any effects due to surface tension.
Referring to Figure 14.20, prove that the buoyant force on be cylinder is equal to the weight of the fluid displaced (Archimedes' principle). You may assume that be buoyant force is F2F1 and that the ends of be cylinder have equal areas A. Note Eat be volume of be cylinder (and that of be fluid displaces) equals (h2h1)A .
Is there a limit to the height to which an entrainment device can raise a fluid? Explain your answer.