Answered: bläs 3 Q5) for the equilibrium figure…

bläs 3 Q5) for the equilibrium figure below if the tension in the cable AD and AC are 450 N and 600N respectively: Find a) the tension in AB 30 D 60 В B 45

Mechanics of Materials (MindTap Course List)

9th Edition

ISBN:9781337093347

Author:Barry J. Goodno, James M. Gere

Publisher:Barry J. Goodno, James M. Gere

Chapter2: Axially Loaded Members

Section: Chapter Questions

Problem 2.2.21P: Solve the preceding problem for the following data: b = 8.0 in., k = 16 lb/in., a = 45°, and P = 10...

See similar textbooks

Related questions

Q: A tower of 20 m, height is supported by three ropes shown in figure below. If the force of AB Is 50…

Q: A bracket is subjected to the force-couple system shown in the figure below. Determine the reactions…

Q: Consider the 100-cm board supporting three loads as shown below. The beam weighs 35 grams. If the…

A: Given data: - The mass at point D is mD = 65 g. The mass at point B is mB = 10 g. The mass at…

Q: 2. Figure shown below where point O is a fixed support. Determine (follow the direction of tension…

Q: 6. Find the reaction forces at point A and B 20 lb 30 lb/ft A B 10' 10'

Q: 300 N 4 400 N P Q/ The figure above is in equilibrium find the value of the angle and find the value…

Q: Braw the free body diagram (F.B.D) and determine the reactions at points O and A of the system shown…

Q: A 500 N man sands on the middle of 100 N Ladder as shown in figure. Assuming a smooth wall and a…

Q: The tube, shown below, is supported by two cables (AB) and (AC). A force F = 600 lb is applied in…

Q: 2 m. 2 m. A D P cable a=60° w =30 kN bar B

Q: 20 kN/m 4 m Determine reactions in A and tension in cable as shown in figure? A السا 300 KN 8m + 3 m…

Q: 8. The knotted cords in the figure is in equilibrium. Find the tension in each cord that supports a…

A: Given Data Fw=800 N

Q: A 8 ft 20 k B G 80 k 8 ft 8 ft. LBR 20 k су 20 k X LBR X 80 k 8 ft 8 ft 20 k D |BR| 8 ft Find…

A: To find: The reaction at point A and E and also find the members in tension and compression. FBD:…

Q: A bracket is subjected to the force-couple system shown in the figure below. Determine the reactions…

A: The free body diagram of the system is as follows:

Q: [Q3] For the system shown below, a=1.2 m, Pl=1750 N and P2=2150 N. Find moment about DB. D B A a p2…

Q: Q1-A- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a wall…

Q: 8) The reaction at point O along y-axis, a) 225 N,up b) 225 N, down c) 60 N, up d) 60 N, down c) 840…

Q: The triangular block shown in the figure below is subjected to the loads P= 360 N and F = 130 N. If…

A: P=360N F=130N BC=15cm AB=20cm

Q: A 85 kg baby elephant stands on a homogeneous beam of mass 210 kg. Find the reaction forces at…

A: The free-body diagram is shown below.

Q: B L4 Ls Bar AB is supported by pin A and cable BC. Find the reactions at support A and the tension…

Q: Q.2] Find the reactions at point A for the structure shown in the figure. A 10m z kN/m 5m 20 KN #

A: To find; The reaction force at A. Free body diagram: The free body diagram of the structure is shown…

Q: 1-The tension in cable AC is: F 24 7 D 4 4 3 A В Crate /////// 3.

A: Draw a free-body diagram of the crate.

Q: Consider the bracket shown in Fig-3. If: • F1 - 10 lb @ -90° • a = 2 ft b = 4 ft • c= 1 ft then,…

A: Given data F1 = 10lb @ -900 a = 2ft b= 4 ft c = 1ft To determine the direction of horizontal force…

Q: [Q3] For the system shown below, a=1.2 m, P1=1750 N and P2=2150 N. Find moment about DB. D C B A a…

Q: 1.500AN/m 0750m 1.500m 275 N 2.25 1.500 Refer to the diagram. ACD is a rigid member. Determine the…

Q: The uniform 0.60- kN beam is hinged at P. Find the tension in the tie rope and the components of the…

Q: A man stands on the middle rung of a 250 N ladder resting on a smooth flo and against a wall as…

Q: The maximum allowable tension in cables AB and AC is 890 Ibe What is the maximum tension that can be…

Q: 2. Two cables tied together at C are loaded as shown in the figure below. Determine the tension (a)…

Q: Q2: The cylinder A weighs 660 N and it is supported by the vertical smooth wall and the cable system…

A: Given Weight of the ball = 660 N To find Tension at AC

Q: The 9-m boom AB is acted upon by the 5.7 kN force as shown in figure. Determine the tension in cable…

Q: bli 3 Q5) for the equilibrium figure below if the tension in the cable AD and AC are 450 N and 60O N…

A: Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the following…

Q: In the shown figure if the bucket weighs 50 N, determine the following: 9) The tension developed in…

Q: Find the reaction forces at points A and B in the system shown. Soru 5. 20N 10N 15N A 3m 3m

A: The reaction at A is pinned joint so there are two types of reaction at A which is Ax and Ay The…

Q: Q.3] Find the reactions at A and B for the structure shown in the figure. 2 kN/m fo lem 2m 20kN 2m…

A: To find: The reaction at A and B . Free body diagram: The free body diagram shown below. Here , RA…

Q: Q1 -A- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a…

Q: The magnitude of the reaction in predicate A shown in the figure is equal to ............. A 15th O…

Q: Find the reactions for the followings 3 kN/m B A 3 m 2 kN/m 4 m C

Q: A bag of cement weighing 475 N hangs in equilibrium from three wires es suggested in the figure…

Q: 20 kN/m 2m Determine reactions in A and tension in cable as shown in figure? 1 A 300 KN 8 m + 3 m +…

A: To Find : The reaction at point A and tension in the cable. Given : Free body diagram shown…

Q: Members AB, AC, and AD intersect at point A. If a vertical force, F, is applied at point A, find the…

Q: Figure Q2[a] shows a shaft supported by three smooth journal bearings at A, B, and C. Given: F,=923…

Q: 5.7 . Find the tension in *A m each cord in Fig. E5.7 if the weight of the suspended object is w.…

A: The tension is defined by the following: "The force of a string, whenever the string is pulled." If…

Q: 2. A 20-kg crate hanging at D is supported by a horizontal spring AB and a cable AC, as shown.…

Q: R 5 m E 5 m D 40 kN 8 5m C 5 m A 60 kN 4

Q: Q 2/ For the figure below : (a)the reactions at A and c when a = 0° * 600 mn C 250 N 150 mm 250 N…

Q: Q5: A bracket is subjected to the force-couple system shown in the figure below. Determine the…

A: cosθ=513sinθ=1213

Q: . The smooth uniform rod AB is supported by a ball-socket joint at A (Figure 6), the wall at B, and…

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Concept explainers

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.

Question

bläi 3 Q5) for the equilibrium figure below if
the tension in the cable AD and AC are
450 N and 600N respectively: Find a)
* the tension in AB
A
30°
D
60
B
45
E

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: With The Help Of Free Body Diagram Problem Has Been Solved

Step 2: Given

Step 3: Solution

Step 4: Answer

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q/ Find the reaction forces at A and B, (A pin connection and B roller connection)? 120N/m
A uniform bar 3.00 m long is held by ropes at the ends making angle 60.0 and 30.0,respectively, with the horizontal. A weight of 200 N is hung 0.500 m from the leftend where the 60.0 rope is attached. Find the tension in the ropes (T1 & T2) andthe weight (W) of the bar
1) The thin plate shown in the figure below weighing 99 kg/m^2, is lifted slowly by the cables AC and BC. For equilibrium, determine the distance x in m 2) Determine the tension in the cable AC in N. 3) Determine the tension in the cable BC in N
A 100 kg cylinder is suspended by a rope below a ring A, as shown below. The ring is supported by another rope (AB) and by a spring (AC). AC has a spring constant of k = 500 N/m. What is the spring force when the cylinder is in equilibrium?
A transmission cable 300 m long, weighs 600 kg. The tensions at the ends of the cable are 400 kg and 450 kg. Find the distance of its lowest point to the ground. Choices: 150m ,153m , 148m , 145m
There are two parallel forces and two pure moments in the figure. What distance "d" must separate the forces in order for the system to be in equilibrium? F = 9 N, M1 = 15 N-m, M2 = 69 N-m, = 60 degrees, a = 1 m, b = 1 m, c = 2 m
A horizontal board weighing Wb = 600 N is hinged to a vertical wall. A personweighing Wp = 400 N stands at the end of the board 5 m from the wall. A rope is attached to theboard at a point 3 m from the wall and makes an angle of θ = 40° with theboard. Determine the tension (T) in the rope
Physics for Engineering A uniform bar 3.00 m long is held by ropes at the ends making angle 60.0 and 30.0, respectively, with the horizontal. A weight of 200 N is hung 0.500 m from the left end where the 60.0 rope is attached. Find the tension in the ropes (T1 & T2) and the weight (W) of the bar. (Hint: Formulate three equations for the three unknowns, 2 equations for the 1st condition and 1 equation for the 2nd condition.)
A 40 kg-mass hangs from the end of a uniform beam. The beam is 6.0 m long and has a mass of 60 kg. The beam is supported at the left end by a hinge at the wall and by a cable at the right end. The other end of the cable is tied to the wall at a point 4.0 m above the left end of the beam. (g = 9.81 m/s² )A. Draw the FBD;B. Find the tension (T) in the supporting cable in Newtons; andC. Find the reaction force (R) of the hinge on the beam ( magnitude and direction).
A prismatic bar AE of negligible weight is hinged to avertical wall at A and supported by a strut BD as shownin Fig. 1. Find the reaction induced at A and B throughthe action of a sphere of weight W tied by a string CFthat is parallel to AE. Also, find the tension in the string.The radius of the sphere is such that the points B and Care at the same level. Assume W = 1000 lb.
Find the internal force system acting on section 3 for the pin-connected frame. a P = 255 N (C), V = 0, M = 29.8 N · m b P = 255 N (T), V = 0, M = 29.8 N · m c P = 255 N (C), V = 0, M = 92.8 N · m d P = 525 N (C), V = 0, M = 29.8 N · m
A man raises a 10-kg joist with a length of 4 m by pulling on a rope.Find the tension T in the rope and the reaction at A.