Blood pressure is normally taken on the upper arm at the level of the heart. Suppose, however, that a patient has his arms in a cast, so you cannot take his blood pressure in the usual way. If you have him stand up and take the blood pressure at his calf, which is 87.5 cm below his heart, what would be the Ap = mmHg magnitude Ap of the difference between this measurement of blood pressure and a normal blood-pressure measurement? The density of blood is 1060 kg/m³.

Blood pressure is normally taken on the upper arm at the level of the heart. Suppose, however, that a patient has his arms in a cast, so you cannot take his blood pressure in the usual way. If you have him stand up and take the blood pressure at his calf, which is 87.5 cm below his heart, what would be the Ap = mmHg magnitude Ap of the difference between this measurement of blood pressure and a normal blood-pressure measurement? The density of blood is 1060 kg/m³.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 107AP: (a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using...

See similar textbooks

Similar questions

(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.
The heart of a resting adult pumps blood at a rate of 5.00 L/min. (a) Convert this to cm3/s. (b) What is this rate m3/s?
A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
Verigy that the SI of hpg is N/m2.
A 75.0-kg floats in freshwater 3.00% of his volume above water when his are empty, and 5.00% of his volume above water when his lungs are full. Calculate the volume of air inhales—called his lung capacity—in liters. (b) Does lung volume seem reasonable?
When physicians diagnose arterial blockages, they quote reduction flow rate. If the flow rate an artery has been reduced to 10.0% of its normal value by a blood clot and be average pressure difference has increased by 20.0%, by what factor has the clot reduced the radius of the artery?
Blood is pumped from the heart at a rate of 5.0 L/min into the aorta (of radius 1.0 cm). Determine the speed of blood through the aorta.
How tall must be to measure blood pressure as high as 300 mm Hg?
In an immersion measurement of a woman's density, she is found to have a mass of 62.0 kg in air an apparent mass of 0.0850 kg completely submerged with lungs empty. (a) What of water does she displace? (b) What is her volume? (c) Calculate her density. (d) If her lung capacity is 1.7S L, is she able to that without treading water with her lungs filled air?
A glucose solution being administered with an IV has a flow rate of 4.00 cm3/min. What will the new flow rate be if the glucose is replaced by whole blood having the same density but a viscosity 2.50 times that of glucose? All other factors remain constant.
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
While researching fluid dynamics, you come across a reference to the dimensionless number called the capillary number, given by the equation below. Ca=\frac{\mu v}{\gamma }, where mu = fluid viscosity [=] g/m s and v = velocity [=] ft/s what is gamma?