Answered: Briefly state the principle following…

Briefly state the principle following multple access protocol a). TDMA; B).FDMA; C) Pure ALOHA d)Slotted ALOHA E) CSMA/CD

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 11RQ

See similar textbooks

Related questions

Q: 3.ARP protocol maps physical address with logical address. The statement is: a) Extremely true b)…

A: Answer: The correct option is (a) = extremely true

Q: Write the answer of each of the following questions in brief with respect to OSI layer model:…

A: Given: Write the answer of each of the following questions in brief with respect to OSI layer model:…

Q: This question deals with computer networking: 1a)Explain with a diagram the Address Resolution…

A: Protocol: The protocol is defined as "a system of rules that explain the proper conduct and…

Q: Give disadvantage of added MSRN opposed to addresses of VLR and HLR

A: disadvantage of added MSRN opposed to addresses of VLR and HLR.

Q: Use suitable serial communication protocols between 1 Master and 3 Slaves (Slave 1 address=0110…

A: Use suitable serial communication protocols between 1 Master and 3 Slaves (Slave 1 address=0110…

Q: d. Assume that the data is transferred using a 4B5B bit synchronization and error detection code (4…

A: In telecommunication, 4B5B is a form of data communications line code. 4B5B maps groups of 4 bits of…

Q: What concerns the physical layer about bit-by-bit delivery?

A: Given:

Q: what conditions can serial data transfers be faster than parallel data transfers? (Our subject is…

A: Given Under what conditions can serial data transfers be faster than parallel data transfers? (Our…

Q: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay.

A: Propagation delay Given as 240 ms Transmission delay is 256/12000 = 0.021 = 21 ms Putting in formula…

Q: Give advantage of added MSRN opposed to addresses of VLR and HLR.

A: Advantage of MSRN over HLR and VLR :- MSRN stands for mobile subscription roaming number and this…

Q: 1-If CS-24F6H and IP-634AH, determine: the physical address and the upper range of the code segment.

A: ans is given below

Q: Consider the following: the latency of an interconnect is 2 seconds, and the bandwidth is 64 bytes…

A: transmission time = Latency + (packet length)/(bandwidth)

Q: 1. identify which layer or layers of the OSl model do the following:…

A: The OSI Model (Open Systems Interconnection Model) is a conceptual framework used to describe the…

Q: The physical layer concerns with bit-by-bit delivery why?

A: In this answer I will be discussing about the Physical layer in OSI model.

Q: Q. 2. (b) Suppose Banglalink has 8 voice channels, each of 80 Mbps. They use synchronous TDM to…

A: A Synchronous TDM is a strategy where time allotment is preassigned to each gadget. In Synchronous…

Q: Compare FDMA, TDMA, and CDMA.

A: FDMA( Frequency Division Multiple Access) TDMA (Time Division Multiple Access) CDMA (Code…

Q: Explain why the following claim should be accepted as true: When compared to a two-channel system…

A: Given: Customers' origins and the whole procedure are two components of the total. When there are…

Q: The physical layer is concerned with the movement of bits over the physical medium. Clarify?

A: The physical layer is concerned with the movement of bits over the physical medium. Clarify?

Q: The physical layer concerns with a. bit-by-bit delivery b. NONE OF THE ABOVE

A: Given question is come from physical layer delivery of data.

Q: Question 4 Assume H1 and H2 are connected to the same access point AP1. H1 want to send a frame to…

A: Given diagram represents a network which contains two hosts H1 and H2, an access point AP1. Given…

Q: 16 Consider a paging system that uses the "Not Recently Used" (NRU) page replacement algorithm. What…

A: 21. FAT stands for File Allocation Table. The size of file BB is 2200 bytes. Each block is of 1024…

Q: d (b) assume there is a s ply calculate the averag 0-Mbps Ethernet throu- ritches as in Exorciso 16

A: (a) The effective bandwidth is 100 Mbps, so that the sender can send data steadily at this rate and…

Q: Suppose a switch is built using a computer workstation and that it can forward packets at a rate of…

A: Below is the answer with calculation:

Q: Q. 2. (b) Suppose Robi has 32 voice channels, each of 60 Mbps. They use synchronous TDM to multiplex…

A: According to our guidelines, we are supposed to solve only 3 subparts. So please repost the question…

Q: Find the new durations for a) the input bit duration, b) the output bit duration, c bit rate, and d)…

A: When there are four channels then each frame will carry 2 bytes from each Channel A)Therefore 2byte…

Q: Suppose that instead of using 16 bits for the network part of a class B address originally 20 bits…

A: Class B networks range from 128 to 191 (or 64 possible values) over their first 8 bits. As a result,…

Q: Q.4: Explain how Files or Applications Data are converted into bits in OSI Model, also mention the…

A: Ans 4) part a) Methodology of how files data are converted into bits in OSI model,please refer…

Q: a- Explain the Stop-and-Wait protocol

A: Answering first part as per the guidelines. The problem is based on the basics of computer…

Q: Explain the differences between SSI, MSI, LSI, and VLSI.

A: Difference between SSI, MSI, LSI, and VLSI: Some of the difference between SSI, MSI, LSI, and VLSI…

Q: An interfacing diagram of 8251A with 8086 system is shown below. An important block is hidden in the…

A: The 8251 is a Universal Synchronous/Asynchronous Receiver/Transmitter bundled in a 28-pin DIP made…

Q: How does Symmetric Multiprocessing (SMP) work?

A: When numerous processing units—two or more—are used in computer hardware and software architecture…

Q: What is principal of locality

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: 8 X 8 Router, where each input runs at 5 Gbps. Assume, the average RTT = 160 msec. What is the rule…

A: Given , 8 X 8 Router Input speed = 5 Gbps (giga bytes per second) = 5 × 103 Bytes/sec. RTT = 160…

Q: Explain the Pros and Cons of layer c

A: Summary The advantages of a layered framework is separation of function. immaculately, the functions…

Q: Write the answer of each of the following questions in brief with respect to OSI layer model: 1.…

A: The Answer is in given below step

Q: Question 3: A) Differentiate between the function of Frame Synchronization and Flow Control in Data…

A: Answer to the above question is in step2.

Q: Match the following to one or more layers of the OSI model: a. Physical addressing  b.…

A: Solution: a) Physical Addressing = Data Link Layer After creating the frames , the data link layer…

Q: Q/3 Explain the main uses of parallel and serial transmission and what is the disadvantage of them?…

A: Serial Transmission- Data is sending bit form one system to another system in serially in both the…

Q: a. Explain the controlled access protocol in detail. b. Describe in detail about channelization.…

A: Controlled Access Protocol:- In controlled access, both departments check each other's information…

Q: The physical layer is concerned with the movement of which of the following over the physical…

A: This mcq is related to physical layers.

Q: 2. Consider a bus-topology network with five stations. A reservation access method is used. Each…

A: Throughput is the amount of data that can be transmitted through a network in a given time frame.…

Q: What is principal of locality

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: basic data link layer principles (e.g. PPP if modems, maximum frame size in byte, maximum header…

A: Here basic question about Ethernet or CSMA/CA or CSMA/CD is asked , in which we have to tell the…

Q: Discuss the advantages and disadvantages of both Byte Count and Byte Stuffing framing techniques of…

A: Advantages of byte stuffing framing technique of data link layer are : End and start can be easily…

Q: required entries) at host A. See uploaded p

A: Draw a fully populated ARP table (all required entries) at host A. See uploaded pic

Q: 2. (b) Suppose we have a 9 GHz bandwidth channel. If the upper limit of the bit rate is about 20…

A: In this question, we are given Channel Bandwidth, capacity and asked signal to noise ratio in…

Q: ng delimiter) and apply bit stuffing approach at layer 2. b) Apply Polar (RZ or NRZ) signaling/

A: SUBJECT:- NETWORKING NOTE:- TAKE X = 1149 QUESTION# 1:- A bit stream X is being transmitted, where;…

Q: What is the main advantage of parallel transfer over serial transfer of binary data?

A: The main advantages of parallel transmission over serial transmission are: It is easier to program.…

Q: Question 3 A backbone is usually a Star Star or Bus Bus Mesh o00

A: The star bus network sometimes acts as the head and monitors the network and all teh connections…

Concept explainers

Embedded Software Development

Using specific programming languages (like C and C++) to write code for a specific hardware device in which it runs is called embedded software development. It makes the device smart by performing actions based on user's input which improves the user experience. They are designed to perform function-specific tasks rather than doing multiple tasks like computers. The embedded system is incredibly intuitive. An embedded software system could be a system developed and organized on any device, apart from an old-fashioned computer. It is the brain of a specific device; however, it is a solely useless tool and simple to elucidate what software system is embedded.

Question

Briefly state the principle following multple access protocol

a). TDMA;

B).FDMA;

C) Pure ALOHA

d)Slotted ALOHA

E) CSMA/CD

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Write the answer of each of the following questions in brief with respect to OSI layer model: Transmission of bit stream across physical medium Answer: *This question has already been submitted, but this question remains unanswered
SUBJECT:- NETWORKING NOTE:- TAKE X = 1149 QUESTION# 1:- A bit stream X is being transmitted, where; X is the ASCII of last digits of your arid number (For example a student having 19-ARID-1149 will use ASCII of 1149 as X). a) Use 100001 as flag (starting/ending delimiter) and apply bit stuffing approach at layer 2. b) Apply Polar (RZ or NRZ) signaling/coding scheme on the resultant data obtained from part a of this question and represent the signal.
Question 1: Define Seek time, Rotational delay, Access time and Transfer time?
42. Though there are practical reasons why we don't complicate our lives this way in the real world, from a theoretical perspective we could borrow non-consecutive bits for subnetting. So, when borrowing the first host bit, the second host bit and the last two host bits (counting from the left of the host bit field) from 172.1.0.0 can you determine the following: g. 1,203rd useable host address?
Q3: A / Draw a diagram showing the PDU messages exchange of writing a file of 950 bytes to the server, using TFTP protocol. Assume all messages are arrived correctly. B / List the command-reply message exchange sequence to get (read) a file of 950 bytes from the TFTP server. Assume the first block of data is corrupted and the ACK of the second block is not arrived. Other messages are arrived correctly.
1) A bus topology is known for being a) Simple and dependable b) Robust c) Efficient and effective d) Reliable
What is the role of the ALU in bitwise logical operations? Provide an example.
Suppose a new CSMA/CD protocol is designed for a 100 Mbps bus network with topology similar to 10Base2. The minimum frame length is 40 bytes. What is the maximum length of the longest cable connecting two nodes so that the collision detection mechanism still works? Write symbolic equations (e.g. using d=distance, R=data rate, etc.) and derive the solution. Explain with words what is going on.
Computer Science Assume the length of each message is L=5, the access link has a speed of X=180 Mbps, and there are B=6 messages per second on average. What is the total average delay for receiving a message when no cache is used, i.e., the sum of LAN delay, access delay, and internet delay? Give your answer in milliseconds.
What are the upsides and downsides of serial data transmission vs parallel?
Suppose that a sender and a receiver exchange data via UART with followingconfiguration:Baud rate = 115200 bits/s 1 start bit, 2 stop bits, 8 data bits, 1 parity bit 16 clock periods used for sampling 1 bit Answer the following questions please and thank you(a) What is the required clock frequency?(b) Suppose a 48 MHz clock. What is a suitable division factor to generate the neededclock in sub-question (a)?(c) How long does it take to transfer 10 MBytes of data?
b) For each of the following networks, discuss the consequences if a connection fails- five devices arranged in a bus topology- five devices arranged in a ring topology