C 7. A capacitor, a coil, and two resistors of equal resistance are arranged in an AC circuit as shown in the figure. An AC source provides an emf of AVrms = 20.0 V at a frequency of 60.0 Hz. When the double-throw switch S is open as shown in the figure, the rms current is 183 mA. When the switch is closed in position a, the rms current is 298 mA. When the switch is closed in position b, the rms current is 137 mA. Determine the values R R AVms S- of R, C, and L. ell

C 7. A capacitor, a coil, and two resistors of equal resistance are arranged in an AC circuit as shown in the figure. An AC source provides an emf of AVrms = 20.0 V at a frequency of 60.0 Hz. When the double-throw switch S is open as shown in the figure, the rms current is 183 mA. When the switch is closed in position a, the rms current is 298 mA. When the switch is closed in position b, the rms current is 137 mA. Determine the values R R AVms S- of R, C, and L. ell

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Similar questions

Two sinusoidal voltages of the same frequency have rms values of 8 V and 3 V. What is the smallest rms value that the sum of these voltages could have? The largest? Justify your answers.
Consider a 760 W light bulb that requires an RMS voltage 21 V to operate normally. How large should an inductance be connected in series with the bulb if the combination is connected across a RMS voltage 255 V, 71 Hz line? (You may neglect the resistance of the inductor and the inductance of the light bulb.)
Given the waveform of a voltage source shown inFigure P7.8, find:a. The steady DC voltage that would cause the sameheating effect across a resistance. b. The average current supplied to a 10-Ω resistorconnected across the voltage source.c. The average power supplied to a 1-Ω resistorconnected across the voltage source.
The frequency of a sinusoidal voltage with a maximum value of 250V is 55 Hz.a) Write the equation for this voltage.b) Calculate the value of the voltage at 0.008 seconds from the beginning, while the curve increases in the positive direction from the moment t = 0?
At t=−2 ms, a sinusoidal voltage is known to be zero and goingpositive. The voltage is next zero at t=8 ms. It is also known that thevoltage is 80.9 V at t=0.1. What is the frequency of v in hertz?2. What is the expression for v?
A sinusoidal voltage has a peak value of 15 V, has a frequency of 125 Hz, and crosses zero with positive slope at t=1 ms. Write an expression for the voltage
Give the solution for J and K ONLY ans (0.99959 degrees and 63.643 ms respectively).Read A 70-Vac source has the following waveform. Determine:a. Vpkb. Vpk-pkc. Vrmsd. Periode. Frequencyf. Angular Velocityg. Phase Angleh. equation of the waveform (in time domain)i. the instantaneous voltage when t = 120 msj. the angle (1st occurrence) after t = 0 when the voltage is +80 Vk. the time (2nd occurrence) after t = 0 when the voltage is –10 VAnswers:a. 98.9949 Vb. 197.9899 Vc. 70 Vd. 100 mse. 10 Hzf. 20π rad/secg. 125.0876°h. v(t) = 98.9949sin(20πt + 125.0876°)i. -29.0880 Vj. 0.99959°k. 63.643 ms
Q5. For an exhibition project you are designing a circuit of signal processor which can be connected to 230V, 50 Hz supply have a 5.0 H inductor, 80 μ F capacitor and 40Ω resistor kept in series. How can you evaluate the rms current and average power delivered to the circuit? Based on your observation, evaluate the potential drop across capacitance and inductor. Comment about that r m s voltage found in this circuit is less than peak voltage? Justify it with your answer. If you remove the inductor and connect a bulb in series with a capacitor. What will happen to the brightness of bulb if it is connected to DC source and then to an AC source. Assess and find reason for your observations in each case.
A sinusoidal voltage is given by the expression.(FIND ALL THE VALUES NEED HANDWRITTEN ONLY NO CHAT GPT)NOTE: need all values as they are small .
An industrial coil is modeled as a series combination of an inductance L and resistance R, as shown in the figure below. Since an ac voltmeter measures only the magnitude of a sinusoid, the following measurements are taken at 60 Hz when the circuit operates in the steady state: Using the instruction provided, find R when E = 166 V, V1 = 80 V, VO = 101 V. Round off to 5 decimal places if applicable.
Find the rms value of the half-wave rectified sinusoidal voltage
Q6: An AC source operating at 60 Hz with a maximum voltage of 170 V is fed to a series combination of1.2kΩ resistor and 2.5μF capacitor connected in a timer circuit. How can you evaluate the maximumcurrent in the circuit? Can you estimate the rms value potential difference across each circuit element?Compare the power factor of this timer circuit with a circuit contain only ohmic resistance. Justify youranswer?