i need the answer quickly An oblique shock wave ,the following upstream conditions : P=150 kPa ,T=500 K,M1=1.605 and a shock angle ß =60°.Calculate :1. Upstream velocity V1 and deflection angle 0.2. Downstream Mach number M23. Static and stagnation temperature ( T2, To2)4. Downstream velocity V25. Normal and tangential velocity component upstream and downstream of the obliqueshock (Vin, Vit, V2n, V2 )6. Static and stagnation pressure (P2, Pol).

Answered: Image /qna-images/answer/211036d3-096e-4e4d-8d33-feff9ab74e04.jpg

Answered: Calculate : 1. Upstream velocity Vi and…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An explosion occurs which creates a plane normal shock wave propagating into a region of air that is at rest (stagnation pressure po=1.0135×105Pa) and (stagnation temperature of To=290K). The speed of the shock is 1700 m/s. The air is modelled as an inviscid fluid, specific heat ratio γ=1.4 and gas constant R=287~J/kg⋅K. Calculate the air speed in m/s, relative to a stationary observer in the region behind the shock?
Consider the Gulfstream IV flying at Mach = 0.35. Calculate thrust required given an altitude of 30,000-ft, assuming weight of 73,000-lb. Airplane data: S = 950 ft2, AR = 5.92, ??? = 0.015, and K = 0.08 a. The thrust required at 30,000-ft. (in pounds)
A large tank, at 500 K and 200 kPa, supplies isentropicairfl ow to a nozzle. At section 1, the pressure is only 120kPa. What is the Mach number at this section?(a) 0.63, (b) 0.78, (c) 0.89, (d ) 1.00, (e) 1.83 assume one-dimensional fl ow of ideal air, R 5287 J/(kg ? K) and k 5 1.4.
AERODYNAMICS 1. A uniform supersonic air flow at Mach 2.0 passes over a wedge. An oblique shock, making an angle of 40° with the flow direction, is attached to the wedge. If the static pressure and temperature in the freestream are 0.5 Pa and 0°C, determine: a. the deflection angle in degrees b. the pressure ratio c. the Mach number in the downstream region
Air enters a convergent-divergent nozzle at a temperature of 400K and a pressure of 10 atm. The throat area is one-half that of the discharge of the divergent section. Assuming the Mach number in the throat is 0.75, what are the values of the following quantities at the throat: pressure(atm), temperature(K), linear velocity(m/s), density(kg/m3), and mass velocity(kg/m2s)? Write your answers according to order of properties asked.
Supersonic air at Ma1 = 2.0 and 230 kPa flows parallel to a flat wall that suddenly expands by ? = 10° . Ignoring any effects caused by the boundary layer along the wall, calculate downstream Mach number Ma2 and pressure P2.
A tiny scratch in the side of a supersonic wind tunnelcreates a very weak wave of angle 17°, as shown in Fig., after which a normal shock occurs. The air temperaturein region (1) is 250 K. Estimate the temperaturein region (2).
A normal shock wave was formed on the surface of a supersonic aircraft at a velocity of 1,600 m/s into still atmospheric air at standard seal level conditions. Calculate: a) M₁ b) M₂ c) P₂ d) T₂ e) V₂
Consider the Gulfstream IV flying at Mach = 0.8 at an altitude with atmospheric pressure of 33,283.40-Pa. Calculate thrust required assuming a weight of 73,000-lb. Airplane data: S = 950 ft2, AR = 5.92, CDo = 0.015, and K = 0.08. The thrust required. (in lbf)
Consider the Gulfstream IV flying at Mach = 0.8 at an altitude with atmospheric pressure of 33,283.40-Pa. Calculate thrust required assuming a weight of 73,000-lb. Airplane data: S = 950 ft2, AR = 5.92, ?Do = 0.015, and K = 0.08. The thrust required. (in lbf)
Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23 kg/m3 (0.002377 slug/ft3) and 1.01 × 105 N/m2 (2116 lb/ft2), respectively. Consider a low-speed open-circuit subsonic wind tunnel with aninlet-to-throat area ratio of 12. The tunnel is turned on, and the pressuredifference between the inlet (the settling chamber) and the test section isread as a height difference of 10 cm on a U-tube mercury manometer.(The density of liquid mercury is 1.36 × 104 kg/m3.) Calculate thevelocity of the air in the test section.
Compressible laminar fl ow, f≈ 64/Re, may occur in capillarytubes. Consider air, at stagnation conditions of 100°Cand 200 kPa, entering a tube 3 cm long and 0.1 mm indiameter. If the receiver pressure is near-vacuum, estimate(a) the average Reynolds number, (b) the Mach number atthe entrance, and (c) the mass flow in kg/h.

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

Calculate : 1. Upstream velocity Vi and deflection angle 0. 2. Downstream Mach number M2