2. Calculate for the final boiling_point of a 2.70 Maqueous solution of KBr. The boiling point constant ofwater is 0.512 °C kg mol·1, and the density of the KBrsolution is 1.80 g/mL.

We have givenAqueous solution of KBr (M)= 2.70 MBoiling point constant (k)= 0.512 °C Kg mol-1and…

Answered: Calculate for the final boilir aqueous…

Science

Physics

Calculate for the final boilir aqueous solution of KBr. The b water is 0.512 °C kg mol·1, anc solution is 1.80 g/mL.

An Introduction to Physical Science

14th Edition

ISBN:9781305079137

Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Publisher:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Chapter13: Chemical Reactions

Section: Chapter Questions

Problem 38SA: Suppose you are given the volume (in liters) of a salt (NaCl) solution and its molarity. Explain how...

See similar textbooks

Related questions

Q: Two parallel walls 6m apart are stayed together by a steel rod 2.5 cm diameter at a temperature of…

A: Given data:

Q: density of silver is 9.5 g/cm3, the gas stant of 8.62 x10eV/atom-K, the perature of 500 °C, the…

Q: A certain reaction has an activation energy of 51.73 kJ/mol. At what Kelvin temperature will the…

Q: Can carbon dioxide be liquefied at room temperature (20ºC)? If so, how? If not, why not?

A: Introduction: Liquefaction of gases is defined as the conversion of states of gas from the liquid…

Q: what is the vacancy fraction at 800°C?

Q: The initial temperature of a 1.00 L sample of argon is 20°C. The pressure is decreased from 720 mm…

A: Given: The initial volume is 1.00 L. The initial temperature is 20 C. The initial pressure is 720 mm…

Q: What is the identity of a 100g sample of metal that, upon absorbing 900 J of heat, increases in…

A: Using the equation for the heat required to increase the temperature, Q=mc∆Tc=Qm∆T

Q: . Which among the plots shown represents the IV curve of an ohmic material? (a) (b) (c) (d) I L

A: Any electrical conducting material that obeys Ohm's law, where the current through the device is…

Q: y describe are dislocations are necessary or bad ects in metals.

Q: rive the equation H= U + PV

A: Enthalpy, H : It is a property of a thermodynamic system, which is defined as the sum of internal…

Q: eant by the saturation (n-2 42) is used in

A: The Fresnel equations (or Fresnel coefficients) describe the reflection and transmission of…

Q: Given the atmospheric pressure of 14.7psia (29.92 in Hg abs), convert 15 in Hg vacuum to Asia.

Q: Calculate the change in the enthalpy of argon, in kJ/kg, when it is cooled from 75 to 25°C. If neon…

A: The initial temperature,

Q: The equilibrium constant of a reaction triples on raising the temperature from 289 °C to 371 °c.…

A: Initial Temperature, T1 = 289 °C = (289 + 273.15) K = 562.15 K Final Temperature, T2 = 371 °C =…

Q: Suppose that the root-mean-square velocity v-ms of water molecules (molecular mass is equal to 18.0…

Q: theoretical value of the specific heat of cadmium in cal/gc

Q: A walrus transfers energy by conduction through its blubber at the rate of 150 W when immersed in…

A: Given: P = 150 W T1 = −1.00 ºC T2 = 37.0 ºC A = 2.00 m2 K = 0.2 W/m C

Q: 4. 3.00 L of a gas is collected at 35.0°C and 705.0 mmHg. What is the volume at STP?

A: Given Volume of gas, V1 = 3.0 L At temperature,T1 = 35.0° C And pressure ,P1 = 705.0 mm Hg…

Q: How much energy, in kJ, is needed to vaporize 0.2 kg of ethyl alcohol once it reaches its boiling…

A: Given data The mass of the ethyl alcohol is m = 0.2 kg = 200 g The boiling point of the ethyl…

Q: Q.5.Calculate the equilibrium concentration of vacancies per cubic meter in pure copper at 850°C.…

A: We have to use a basic formula

Q: A particular chemical reaction occurs at room temperature (293 K) at half the rate that it does at…

Q: The active element of a certain laser is made of a glass rod 30.0 cm long and 1.50 cm in diameter.…

A: (a). the increases in length is

Q: A simple model for car- bon dioxide consists of

A: from the following relation ω = 2π f and also ω2 = k/m here ω = angular frequency f = linear…

Q: ess of coating (n = 6/4

Q: Calculate the density of HBr in g L−1 at 733 mmHg and 46°C. Assume ideal-gas behavior.

A: Given, Pressure is 733 mmHg and temperature is 46 degree centrigrade

Q: The density of dry air at NTP is 0.001293g/cm3. At what temperature will a litre of dry weigh 1g at…

A: according to the ideal gas equation,

Q: A solution contains 3.5 grams of glucose and 100 g water (Kr of water- 1.86 deg. kg/mol)(mol wt= 180…

Q: Find Vams of Maxuell- Bdtanmen distabution for Hyclrogn at a9ok dhd ane mole of hydrogen has 2g masa…

A: Molar mass of hydrogen gas M=2 g=2*10-3kg, temperature of the hydrogen gas T=290 K and universal gas…

Q: Calculate the value of ni in germanium at a temperature of 300 K.

A: Intrinsic carrier density: The intrinsic carrier density/concentration is defined as the number of…

Q: Calculate the value of ni in silicon at room temperature (300 K).

A: Let T denote the temperature, B denote the constant related to a specific semiconductor, k denote…

Q: The barium-yttrium ceramic compound used to demonstrate superconductivity will work only if…

Q: what A mue of carbun dioxide has a muss of 44 grams, uhat wauld the voume of 1 ka of Carbendioxide…

Q: How much energy (in J) is required to evaporate 25% of 4g of water currently at 100 oC?

A: (given) Mass (m) of water = 4 g = 0.004 kg Temperature of water at 100°C. Specific heat (c) of water…

Q: Why the electrons in fermi level not absorb energy??

A: Fermi level is the term used to describe the top of the collection of electron energy levels at…

Q: On a walk a person burn 345 cal/h. at this rate how many hours of brisk walking would it take to…

Q: How many tons of ice can a 20-ton ice plant produce in 24 hours at 5 degree F from raw water at 80…

A: The mass of the ice that can be produced in 24 hours is 12.672 ton.

Q: Suppose a walrus transfers energy by conduction through its blubber at the rate of 125 W when…

A: Given : P = 125 W T1 = -1.25°C T2 = 37°C A = 1.85 m2 For fatty tissue, k = 0.2 J/s.m.°C (Using…

Q: Speaio Heat (calipc) Sutstance Conductivity (cais omG') 0.0015 Water ALmum Copper 1.000 0.215 0.092…

A: Specific heat is defined as the heat energy required to raise the temperature of a material by 10C.…

Q: A 75-g somple of siicon is at 31 Degree Cetius. 750 Cal of energy is transterred to this somple. The…

A: Given data: Mass (m) = 75 g Initial temperature (Ti) = 31 °C Energy (E) = 750 cal Specific heat…

Q: How many kcal are in 16.3 kJ?

Q: If we have 35.54L of O2 gas at STP, how many moles of this gas do we have?

A: At STP (standard temperature and pressure), 1 mol of any given gas occupies 22.4 L. Given is the…

Question

2. Calculate for the final boiling_point of a 2.70 M
aqueous solution of KBr. The boiling point constant of
water is 0.512 °C kg mol·1, and the density of the KBr
solution is 1.80 g/mL.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The average coefficient of volume expansion for carbon tetrachloride is 5.81 104 (C)1. If a 50.0-gal steel container is filled completely with carbon tetrachloride when the temperature is 10.0C, how much will spill over when the temperature rises to 30.0C?
When exactly 1 cup of sugar is dissolved in exactly 1 cup of water, less than 2 cups of solution result Why?
What is the density of 18.0-karat gold that is a mixture of 18 parts gold, 5 parts silver, and 1 part copper? (These values are parts by mass, not volume.) Assume that this is a simple mixture having an average density equal to the weighted densities of its constituents.
State the short general principle of solubility, and explain what it means.
7) The value for a Mole is _________ x 1023.
1. Find the mass of 1m3 of pure oxygen under std. atmospheric condition having a temperature of 25°C. EXPLAIN THE SOLUTION (STEP BY STEP, AVOID SHORTCUT) AND EXPLAIN WHY THE FORMULA WAS USED IN WORDS. DRAW A FIGURE THAT SUPPORT THE PROBLEM.
1.) A vessel contains a mixture of 20 kg of nitrogen and 20 kg of carbon monoxide. The total volume of the vessel is 20?3. Determine the density of the mixture. a.4 kg b.3 kg c.1 kg d.2 kg
Mercury is the only metal that exists as a liquid (d=13.56 g/cm3) at room temperature. Find the number of moles in 15 mL of mercury.
1. A popular web site state that a 200. pound person will burn 450. calories/hour bicycling (moderate effort) and 650. calories/hour rock climbing (ascending). A 150. pound person decides to start a training routine in which she will bicycle for 45 minutes, 3 times a week and rock climb for 1.50 hours every weekend. How many calories will she have burned after 8 weeks of training (assuming she consumes at the same rate)? 2. The density of silver is 10.50 g/cm3. If 5.50 g of pure silver pellets are added to a graduated cylinder containing 11.0 mL of water, to what volume will the water in the cylinder rise?
2. Rank metals, ceramics, and polymers in order of expected coefficient ofthermal expansion (from highest to lowest) based on their atomic structure, andexplain why this behavior occurs
Suppose you are given the volume (in liters) of a salt (NaCl) solution and its molarity. Explain how you would determine the moles of salt in this solution.
The human body converts sugar into carbon dioxide and water at body temperature (98.6F, or 37.0C). Why are much higher temperatures required for the same conversion in the laboratory?