Calculate for the % error, if you were asked by your professor to weigh 279.65g but you got the readi below. Type your final answer with the correct number of significant figures. 100 200 300 400 500 10

Q: Observe the following set of data for measuring a 4kg grocery bag.Identify whether the data is…

A: Accuracy and precision are two different things. Often they are misinterpreted with each other.…

Q: A ball 6 inches in diameter is to be covered by a rubber material which is in-thick. Using…

A: Given: The diameter of the ball is 6 inches. The thickness of the rubber material is 316 in.

Q: what is the ratio of the

A: Mass of object 1, =m/2 Mass of object 2=m Specific heat of object 1, =2S Specific heat of object…

Q: Solve the problem. A cargo container is 50 ft long, 10 ft wide, and 8 ft tall. Find its volume in…

A: Given, Length of cargo = 50 ft Width of cargo = 10 ft Height of cargo = 8 ft Volume of cargo =…

Q: What are significant figures

A: Significant figures are the number of digits in a value, often a measurement, that contribute to the…

Q: What mass of a material with density ρ is required to make a hollow spherical shell having inner…

A: GivenInner radius is r1Outer radius is r2

Q: Find the ratio of A1÷A2 in the attached figure.

A:

Q: What is fractional error or percent error?

A: Fractional error is the ratio of the value of error to the value of the quantity.

Q: Answer the question below: Using dimensional analysis, prove that the expression v = at is correct.

A: Given equation is v=at Here, v is the velocity, a is the acceleration and t is the time. The…

Q: Find the total displacement (sum) from the following measurements: (51±2)m, (48±6)m, (-­27±3)m

A: Consider the given data as below. Displacement with error, d1=51±2 m Displacement with error,…

Q: is that the same answer if the unit is J/kg*K?

A: We know that the upper and lower fixed points in the Celsius scale and the Kelvin scales are…

Q: Our classroom was kept at 25.0°C during your experiment, so v is predicted to be 343 m/s. What is…

A: Given data :              Speed of sound in air ;                                          Expected…

Q: use the formula to estimate the BSA of a person who is 160cm tall and weigh 83kg

A:

Q: could you please check my graph and also help me find the slope and the percent error. Thank you

A: Please see the answer below

Q: What is the angle of the ramp if a 6kg cube slides down a ramp at 4 m/s.

A: Given :-  mass = 6 Kg V=4m/s a= g =10 m/s

Q: What is the number of nautical miles between place A (60°N, 75°W) and place B (70°S, 75°W)?

A:

Q: In an experiment, a student obtained the following masses for a product: 0.651 g, 0.643 g, 0.648 g,…

A: Givenm1 =0.651 gm2 =0.643 g m3 =0.648 gm4 =0.609 gm5 =0.646 g

Q: What is the volume and the associated error for the volume of a solid cylinder with a height of…

A:

Q: The density of wate 8395 9/cm". Buring experimentation, you determine the density of water to be…

A:

Q: Your answer needs to have 2 significant figures, including the negative sign in your answer if…

A:

Q: Convert the given standard notation below to scientific notation. Then, perform the indicated…

A: Solution: Convert the standard notation to scientific notation. 150,000=1.5×105 0.0025=2.5×10-3…

Q: is the unit of Newtons.

A: The gravitational force on Earth is equal to the force the Earth exerts on you. At rest, on or near…

Q: 150 lb, 110 lb A 120 lb

A:

Q: Hello,  I am confused on where to start on this problem, I think it's the ratio part of the…

A: Step down transformer , The number of the turns in the secondary coil (Ns) of the step Transfer is…

Q: Write the difference between base and derived quantities

A: Base quantities In any system of units, the units for some physical quantities must be defined…

Q: If actual value of f(x1)=0,56 and the approximate value of f(x1)=0,6, calculate the relative error?

A:

Q: The height and radius of a cyclinder is measured by a measuring instrument. If the volume was…

A: solution:let height of cylinder=HRadius of cylinder =Rnow volume of cylinder=πR2HV=πR2HTake normal…

Q: A projectile is modelled by the function 9.81 t + vot + ho, 2 h(t) with h measured in meters. Using…

A:

Q: P V =

A:

Q: From the acquired measurements in Table A,plot Q as a function of V

A: Note:- We know that here you asked to plot the Q as a function of V. So We are only giving the…

Q: Which one of the following recorded measures is correct for ruler with 2 mm division ?

A: As the ruler is of 2 mm division, the measured value should be in even number, that is, multiple of…

Q: A quadrilateral shaped area given by the following measurements have these corresponding probable…

A: Perimeter is sum of all four sides. In summation , error is sum of numerical value of all errors.…

Q: What is the smallest quantity that can be weighed on a scale that has a sensitivity requirement of 5…

A:

Q: Convert 1.050 g/cm3into base SI units. Express your answer in scientificnotation with the correct…

A:

Q: In the United States, most people measure weight in pounds and height in feet and inches. When…

A: BMI = W(in kg)[h(in m)]2 As 1 kg = 2.205lbs 1m = 39.37inches Thus conversion factor is…

Q: Carry out the following arithmetic operations. (Enter your answers to the correct number of…

A:

Q: If quantity A is proportional to quantity B, describe how a graph of A vs B should look.

A:

Q: Determine the reading of the measurements below. (Do not type the unit of measurement. Just input…

A: In a triple beam balance, there will be 3 sliders. Here only 2 markings are visible. So we will…

Q: Exactly 1 quart of ice cream is to be made in the form of cube. What should be the length of one…

A: We know that 1 quart =0.00094635 meter cube.

Q: a prescription calls for 750 mg of drug L. After weighing this amount on a balance, which registers…

A: Given data:  Expected weight = 750 mg Actual weight = 720 mg Required: Percentage error

Q: What are dimensions of physical quantity?

A: The dimension of a physical quantity is defined as the power to which the fundamental quantities are…

Q: Convert 0.20 m²/s into micro m²/min considering significant figures

A: Given quantity : A = 0.2 m2s

Q: What are the merits and drawbacks of using a person's foot as a standard?

A: Here , we have to think about using a person foot as a standard and answer about merits i.e…

Q: Conversions involving units raised to a power: include the correct number of significant digits and…

A: 1 centimeter equals to 0.01 meters or 1 meter is equal to 100 cm and 1 millimeter (mm) equals to…