Calculate the amount of heat necessary to raise 92.7 g of water from 26.3 °C to 174.3 °C. the molar heat capacity of water is 18 cal mol1 K-1 Express your answers in kilocalories. Write you answers in 5 significant figures.

Q: Separations of solids, liquids, and gasses are necessary in nearby all chemical and allied process…

A: a) We are going to discuss the process industries from Oman  i) Sohar Refinery Complex ii) Barka…

Q: Steam enters a steady-state steady-flow turbine at 3000 psia and 1000 °F. It leaves the turbine at…

A: Given data: Inlet Pressure; P1=3000 psiaOutlet Pressure; P2=1 psiaInlet temperature; T1=1000…

Q: How can a Chemical Engineer work in the Fermentation, Sugar, and Starch, as well as Vegetable Oil…

A: Answer the following questions.

Q: Calculate the change in entropy involved in heating 2 moles of CHCI3(g) from a volume of 100 liters…

A:

Q: A certain catalyst undergoes sintering over time, causing its catalytic activity to decrease…

A:

Q: The chemical reactor shown below has a cover that is held in place by a series of bolts. The cover…

A: Given data: Diameter of cover = 24 in Specific gravity stainless steel = 8 Thickness = 3 in Gauge…

Q: Example :- Calculate the speed required for 0.6 m³ tank in which 100 W/m³ is supplied to the tank,…

A: Given  Volume  V  = 0.6 m3 Power P = 100 W/m3

Q: Research has shown that tomato ketchup has the following viscous properties at 25°C. Consistency…

A: Given data: Consistency Coefficient; K=18.7 Pa snPower, n=0.27Shear yield stress=32 Pa

Q: 4. The humidity of an air-water vapor mixture is H = 0.030 kg H2O/kg dry air. The dry bulb…

A: The regular thermometers measure ambient air temperatures. These temperatures are dry bulb…

Q: Calculate the final pressure of a sample of water vapour that expands reversibly and adiabatically…

A: Given:  Initial Pressure = P1 = 71 Torr  Initial Volume = V1 = 500 cm3  Final Volume = V2 = 3 dm3  =…

Q: Estimate the convective heat-transfer coefficient for natural convection from a horizontal steam…

A: Given data: Outside temperature of pipe = 80 0C Surrounding temperature = 25 0C Outside diameter of…

Q: Discuss the physical interpretation of any one Maxwell relation.

A: We have to discuss about the physical significance of Maxwell relation by taking one Maxwell…

Q: The HCI concentration in a gas mixture is reduced from 0.0054 mol fraction of ammonia to 2.2% of…

A: Given:  Inlet Gas:          Total gas flow (Inert gas mixture) = 0.035 kmole/m2.s…

Q: Liquid methanol goes through a change from state 1 (27 °C, 1 bar, 1.4 cm 3/g) to state 2 (T °C, P…

A:

Q: 16. Which of the following statements is FALSE? A. Oxidation and reduction half-reactions occur at…

A: "C" AND "D" statement is True. Reduction occur at cathode and Oxidation occur at anode.  Statement…

Q: If you increase the sulfur content in a Dulong equation, what will happen to the heating value of…

A: the dulong’s formula is:  HCV=11008080C+34500(H-O8)+22400S here the C, S, O, H are the percentages…

Q: Q3// For the reaction bellow: C„H 2n+2) + a(02 + 3.76 N2) → nC02 + (n + 1)H,0 + 3.76a N2 If the heat…

A:

Q: 4. From the following data at 298.15 K as well as the data tables (see file below), ΔΗ. reaction (kJ…

A: We are given the above reactions with the enthalpy of reaction next to it. we have to find the…

Q: Twenty grams of potassium dichromate (K2Cr2O7) is dissolved in 150 mL of water. What is its…

A:

Q: Which of the molecular formula correspond to monochloramine? :0=CI: A. ö=ö-ö: H – N-Ci: ċi: С. H B.

A: Formula for monochloramine  1) OCl = hypochlorite  2)O3= ozone

Q: The following information is given for mercury at 1 atm: AHp (356.60°C) = 295.6 J/g Alla(-39.00°C) -…

A:

Q: An industrial wall is constructed of 20 cm thick fireclay (k =1 W/m.°C). This is covered on the…

A:

Q: Which of the following descriptions about plastic pollution is incorrect?   A. Plastic pollutants…

A: Which of the following descriptions about plastic pollution is incorrect?

Q: 5. This experimental method is sometimes called, the vapor density method. Show how the density of…

A: The ideal gas equation is expressed as- PV=nRT Here, P = pressure, V= volume, n= number of moles, R=…

Q: What particle is missing from this reaction? In-110 -> Cd-110 + Select one: Ca. positron Ob. alpha…

A:

Q: 2-1. An incompressible fluid is flowing at steady state in the annular region (i.e., torus or ring…

A:

Q: Air in an ideal Diesel cycle is compressed from 3 L to 0.15 L, and then it expands during the…

A: Given, Air in ideal diesel cycle. V1=3L V2=0.15L V3=0.3L

Q: Question 1 of 10 An ideal gas in an isolated system is expanded isothermally but irreversibly from…

A: Given, T = 400 K

Q: A closed system is one in which Both mass and energy cross the boundaries of the system Neither mass…

A: A physical system where there is no transfer of matter is a closed system. In thermodynamics, a…

Q: In the distribution of succinic acid between ether and water at 15°C, 20 ml of the ethereal layer…

A: Given  T = 20 oC And 20 ml of ethereal layer contain 0.092 gram of acid  Distribution cofficient of…

Q: 30 m3 of humid air at 100 °C and 740 mm Hg with a dew point of 30 °C is cooled to 14°C and 820 mm Hg…

A: Given  Volume of humidity air (V)= 30 m3 Temperature (T1) = 100 oC Pressure P1 = 740 mm hg…

Q: The Pitot tube is used to measure the floor rate of water at 20°C in the center of a pipe having an…

A:

Q: A solid material with 15% by mass H2O is dried to 7% by mass H2O under the following conditions:…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Determine the volumetric discharge at the orifice on the tank shown if the head of the water is…

A: Given: The Head of water H=4.5 m The diameter of the orifice=4 cm=0.04 m The orifice coefficient…

Q: Aluminum metal weighing 2.82 g is exposed to 2.56 g oxygen gas to produce aluminum oxide. (Molar…

A:

Q: Two equal masses of Fe and C were heated by absorbing 30 KJ, which one of the following is correct?…

A: Given  Mass of Fe (MFe)  = Mass of C(MC) = M Specific heat capacity of   Cp ( Fe)  = 0.45 Specific…

Q: Which of the following will result to a higher adiabatic flame temperature? I. Combustion using…

A: Combustion is an exothermic process. In a combustion process the heat produced during the exothermic…

Q: A mixture of water and an organic liquid A, which is immiscible in water, distils at 368 K when the…

A:

Q: 7. Which of the following expressions correctly shows the calculation of AG° in Kj/mol for a Voltaic…

A:

Q: Which of the following statements is correct: O a. constant for a specific reaction at different…

A:

Q: Q) A flash yaporization process was used contains 70% of (A), and 30% of (B), what and the slope of…

A:

Q: Find the Kc at 520 "C.

A:

Q: The following elementary gas-phase reaction has a rate constant of 20 L⁄mol min at 350 K. A + B → C…

A: The total concentration is obtained from pressure and temperature. The initial concentration is…

Q: H.W) When 178 J of energy is supplied as heat to 1.9 mol of gas molecules at constant pressure, the…

A: Given, Energy supplied =178J

Q: 9-88 A simple ideal Brayton cycle operates with air with minimum and maximum temperatures of 27°C…

A:

Q: Explain the alloy formation process and the different between Binary and Triple or

A: To a. explain alloy formation process b. differentiate between binary and ternary alloy system with…

Q: What is the change of energy (L. atm) of a system that absorbed 18.8 L atm of heat and had its…

A:

Q: Plots of AG° of vaporization vs the pressure(gas) for butane and benzene are shown below. At 1 atm,…

A: The change in Gibbs energy of vaporization is obtained from gas constant, temperature, and vapor…

Q: Nitrogen gas at 25 degrees Celsius is compressed reversibly and adiabatically from a volume of 27…

A: For Compressed Reversible and Adiabatically system we have,  (Final VolumeInitial Volume)γ = (Inital…

Q: A liquid-phase irreversible series reaction occurs in an isothermal CSTR: k1 k2 A → B → C

A: