Calculate the percent passing by starting with 100% and subtracting the percent retained on each sieve as a cumulative procedure: total mass=500g. Mass retained on No.4sieve=9.7g. Mass retained on No.10 sieve=39.5 g

Calculate the percent passing by starting with 100% and subtracting the percent retained on each sieve as a cumulative procedure: total mass=500g. Mass retained on No.4sieve=9.7g. Mass retained on No.10 sieve=39.5 g

Fundamentals Of Construction Estimating

4th Edition

ISBN:9781337399395

Author:Pratt, David J.

Publisher:Pratt, David J.

Chapter9: Pricing Construction Equipment

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: A Cone shape container was filled with a mixture of 35% 0.4 m sandstone powder and 65% concrete. The…

Q: SITUATION: From the given figure, determine the following: Determine the percent retained at Sieve…

A: The answer is found to be Mass retained on sieve no 100 = 36.4% For explanation please refer the…

Q: A cube of material is 4 in. on a side and floats at the interface between kerosene (SG=0.82) and…

Q: Calculate the biological oxygen demand (BOD) in mg/L, given the following information Initial…

Q: QI/ A tank is initially filled with ( 250 gal) in which 50 lb of salt are dissolved. salt Fresh…

Q: water containing 1 pounds of salt per gallon runs in at the rate of 2 gal/min and the well-stirred…

A: Amount of salt after 30 min: x= 74.04 lb

Q: 1. Calculate the individual percent at pan Individual Cunulative Seive (nn) Weight Retained Percent…

A: Given table-

Q: Problem 3.25 The acrylic plastic rod is 200 mm long and 25 mm in diameter. Figure 1 of 1 200 mm Part…

Q: A merchant wishes to mix two grades of peanuts costing $3 and $4 per pound, respectively, with…

Q: Half cubic meter of solid waste container is full of solid waste. The weight per fraction is…

A: The given table is shown below:

Q: Tomato juice flowing through a pipe at the rate of 100 kg/min is salted by adding saturated salt…

Q: Apply concept of equivalent weights Convert the following from mg / L to mg/L as CaCO3, 280.00 mg /L…

A: Given: The concentration of CaO is 280 mg/L. The concentration of Ca(HCO3)2 is 85.05mg/L.

Q: An unknown metal (530 g) is added into a cylindrical container (inside diameter: 5 cm) containing…

Q: alculations You must plot the data correctly,(the material weight = gm ) Sieve Mass Retained Percent…

A: in this question curve between percentage passing and sieve size is being asked . and we have to…

Q: A sample of water contained the following salts in mg/litre. Ca(HCO3)2= 40.5,MgS04 = 30 CaS04 = 34…

Q: . Using Excel create a graph (x-y scatterplot) showing the relationship between moisture content and…

A: Soil subdivision can be done in many ways and there are many types of soils such as clay, dust, etc.…

Q: The following is a tabulation of volumes of cut and fill. The shrinkage factor of the material is…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: results shown in the Table below, Calculate the percent passing through each sieve. Plot percent…

A: Calculate the percentage of soil retained over each sieve, % retained = Weight of soil…

Q: laste composition has been measured for two cities. The results are summarized in the given table.…

Q: 1. Copy and complete the table below (show in your solution paper) and input the Percentage Passing…

Q: ENVIRONMENTAL ENGINEERING-WATER POLLUTION: The attached figure shows a plot of BOD remaining versus…

A: Find the value of ultimate BOD as follows:Refer the given graph:The BOD at the starting is 40 mg/L…

Q: Ten pints of a 5% solution are diluted with 30 pints of diluent, what is the percentage strength of…

Q: Q57: In Figure below, calculate Fx and Fv per unit width of the cylinder cylinder Water

A: assume the width of the the curved surface is unit (i.e.=1 m). force in the horizontal direction is…

Q: What is the mass fraction of Sugar (C12H22O11) in a 0.6 molality (mol/kg) solution? How much more…

Q: Samples of sizen=5 are taken from a manufacturing process every hour. A particular quality…

A: The given data is as follows:

Q: 1. Convert the following moisture content as indicated. Show your solutions. a. 18% wb to MCdb b.…

A: To determine: 18%wb to MCdb 26%wb to MCdb 15%wb to MCdb

Q: The first task you are assigned in your summer laboratory job is to prepare a concentrated NaOH…

Q: Specific gravity is calculated by the formula: S.G. = density of sample/density of water at a given…

A: Given data: t [°C] ρH2O [g/cm3] 4 1 20 0.99820 25 0.99705 It…

Q: 1. Given the results of an Atterberg limit test. Complete the test report which will include filling…

Q: SITUATION: From the given figure, determine the following: Determine the percent finer at Sieve No.…

A: Weight retained along with sieve size is given and it has been asked to determine determine…

Q: A 4.9 cubic feet of water are compressed to 5000 psig. What is the percentage of volume decreased if…

A: Given, Volume of water, V = 4.9 ft3 Pressure, P = 5000 psi Modulus of elasticity, E = 311000 psi…

Q: What is the equivalent value of 6.2 pints in L? Round your answer to 1 decimal of a L. US UNIT…

Q: Complete the table if the oven dried mass is 161.42 grams. Make sure you show your solutions and…

Q: Problem 3.46 Each spring has an unstretched length of 2 m and a stiffness of k = 330 N/m.(Figure 1)…

Q: A student weighs out 0.3333 g Na2CO3, dissolves it completely in 30 mL of deionized water, and…

Q: A tank contains a mixture of acid and water. If 30 liters of acid are added the mixture will be 70%…

A: Initial Acid in tank = x Initial Water in tank = y Equation 1 : [(x+30)/y] :: [70/30} 3x + 90 = 7y…

Q: Q.1(a) What is water sweetening and softening? Discuss the lime-soda process of water softening with…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Calculate the B.O.D. of a reference sample given that 1ml of seed material was used in the reference…

Q: Q. 4. 1 ppm CaC03 equivalent hardness is meant by A : 10 mg CaC03 equiv. Per litre B : 100 mg CaC03…

A: The accumulation of mineral salts like Ca2+, Mg2+, Al3+, Iron, as well as other heavy metals causes…

Q: Total solids Suspended solids Volatile suspended solids Fixed suspended solids 4000 mg/L 5000 mg/L…

A: Total Solids : It is a composition of all suspended ,colloidal and dissolved solids in any type of…

Q: What is the molar concentration of 196 mg/L sulfate acid (H2SO4)? Use mol/L or mmol/L as the unit in…

Q: Situation 3 - A 325 L of carbon tetrachloride weighs 4905 N. What is its unit weight in kN/m3? Round…

A: Given data in question Volume Weight To find out Unit weight

Q: Consider a tank with volume 100 liters containing a salt solution. Suppose a solution with 2…

A: Solution: Given: Let us suppose Initial salt in tank=yo=20kg Inflow =2kg/l Rate of inflow=Rate of…

Q: Question Porosity is a measure of the void or empty spaces in a material and is a fraction of the…

Q: A river water was taken for analysis. The results for anions and cations analysis are shown below,…

A: Given data- Concentrations of different cation and anions are given-

Q: c) The chlorine residuals measured when various dosages of chlorine were added to a sample of water…

A: in this question a table of chlorine residue jar test is given and we are asked to find amount of…

Q: What is the value of DG? 2. What is the value of EG? 3. What is the value of DF

A: To find force in member DG,DF,EG

Q: What size of sample, expressed as a percent, is required if the 5 d BOD is 650 mg/L and total oxygen…

A: BOD or biological oxygen demand is the measure of amount of oxygen required by microorganisms for…

Question

Calculate the percent passing by starting
with 100% and subtracting the percent
retained on each sieve as a cumulative
procedure: total mass=500g. Mass retained
on No.4sieve=9.7g. Mass retained on No.10
sieve=39.5 g

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

ASAP, ANSWER CORRECTLY PLS. donot round off initial values, round off only in final ans plsz ty
If the five-day BOD of a waste is 220mg/L and the ultimate BOD is 320mg/L, what is the rate constant?A.0.142/day B. 0.178/day C. 0.210/day D. 0.233/day
What is the volume of coal in the stockpile in cubic feet? Recall stockpiles are cone shaped
Convert 22.3 mL to (a) liters, (b) cubic inches, and (c) quarts.
Determine the volume of borrow and the volume of waste.
1.What is the value DE? 2. What is the value DF? 3. What is the value CE?
Given the following problems, give illustrations; provide solutions using proper equations and variables; convert figures if necessary; and reduce answers to appropriate significant figures up to two decimal places only: 1. Convert the following moisture content as indicated. Show your solutions. 18% wb to MCdb 26% wb to MCdb 15% db to MCwb 20% db to MCwb 24% db to MCwb 2. Determine the weight loss of a ton of paddy at 24% if dried to 14%. Correspondingly, determine the price at different level. Considering price difference of P2.00/kg between wet and dry. Make your conclusion from the above figures. 3. From a one hectare farm, 150 bags (50kg/bag) of palay were harvested with moisture content of 26%MVwb. If it will be dry to 14%MC, determine how much water will be removed from drying? 4. One hundred (100) bags of freshly harvested palay was dried to 14%MC and became 90 bags. Determine the fresh moisture content before drying. 5. Two tons of paddy with 22% moisture content on wet…
GIVEN: diameter of sewer pipe = 1.8mDepth of water = 1.6mQ = 2.5m3/sCompute the velocity. Use 3 decimal places all throughout the solution. Box/underline your finalanswer.
The maintenance cost of a new boiler are estimated as follows: $600 per year for the first 3 years, $ X at the 4th year, and $ 1800 per year starting at the 5th year up to the end of its 10-year life. If the present value of all the maintenance is $ 20000, find the value of X. Money is 6% compounded annually.
How do I convert 10649 KWh into (KWh/(m2-yr)?
10. Compute the total volume in cubic meter using Average-End Area Method. Solution must be in Basket Method. The answer should be Round off to two decimal places. Draw the figure.
Define liquidity index.