Calculate the stress distribution with depth below the center of the dam, and the stressdistribution 5 m below the dam5 m1:310 m1:2.5

Answered: Image /qna-images/answer/7ac6f8a5-7a96-49fe-bf91-d671e747a8b5.jpg

Answered: Calculate the stress distribution with…

Calculate the stress distribution with depth below the center of the dam, and the stres distribution 5 m below the dam 5m 1:3 10 m 1:2.5

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter10: Stresses In A Soil Mass

Section: Chapter Questions

Problem 10.13P: Repeat Problem 10.12 for q = 700 kN/m2, B = 8 m, and z = 4 m. In this case, point A is located below...

See similar textbooks

Related questions

Q: Soil Exercise The flexible area shown in Figure is uniformly loaded. Given that q = 300kN/m?…

A: Solution: Given q=300 kN/m2 Z= 3m 8 meter wide Vertical Pressure due t o a A line Load: σZ=…

Q: Q.3) Determine the increase in vertical stress at a depth 4 m below point A due to surface loads…

A: The Stress at a Depth z below Surface ,Due to a Point Load is Given by Boussinesq's Formula , Stated…

Q: An embankment shown in the figure is constructed. Compute and plot the distributions of the vertical…

Q: 2. The ground water level in a thick, very fine sand deposit is located 2.0 m below the ground…

Q: Determine the stress increase due to the embankment load at point A as shown in Figure 2. The unit…

A: Given data Unit weight Depth Dimensions To find Stress at point A

Q: 6m 19m y'=2.5y 3 mi 4 m -11 m

Q: 0,90m 1m Sand e= 0.47 Gs 2.68 6m

A: Sand e= 0.7 Gs=2.68 To find Saturated Unit weight of soil and total pressure, pore pressure,…

Q: ) a. Consider the upward flow of water through a layer of sand in a [Seepage] (** tank shown below.…

Q: An embankment load on a silty clay soil layer as shown below. Determine the stress increase under…

Q: q= 21,358 kN/m² H1= 1,871 m B Yn= 18,557 kN/m³ H2=1 m Yn= 19,557 kN/m³ H3= 5,871 m Yn= 20,557 kN/m³…

A: Pore water pressure :- It is the pressure generated around the soil particles due to the presence…

Q: Plot the distribution of total stress, effective stress, and pore- water pressure with depth for the…

A: Following is the given soil profile: Given: For soil up to the depth of 4.5 m (A-B): Void ratio,…

Q: 2. The ground water level in a thick, very fine sand deposit is located 2.0 m below the ground…

Q: Ex: For a uniformly loaded area having R=3 and load q= 100 kN/m², estimate the increase in the…

Q: Calculate the effective stress at A. 25 m Sand and- Gravel Water Table Unit Weight (y) = 20.72 kN/m…

A: Following is the given soil profile:

Q: 5. Consider the embankment profile shown below. Determine the stress increase at points A and B.…

A: As both points A and B are at same depth hence the increase in stress level will be same as the…

Q: Question 2/ The soil profile shown in Figure (2) subjected to downward seepage calculate the…

A: Soil subdivision can be done in many ways and there are many types of soils such as clay, dust, etc.…

Q: B 6.0 m 6.p m 5.0 m Figure for Problem6

Q: A borehole at a site reveals the soil profile shown below. Calculate the effective stress (σ’) in…

Q: a. Calculate the variation of o,u ,and o' with depth. b. If the water table is rises to the top of…

A: The given figure shows the soil profile. It is required to calculate the variation of effective…

Q: 4. A 10 m thick layer of shift, saturated clay is underlain by a layer of sand. The sand is under…

Q: PISBILM N8. For the embankment shown in Figure below, determine the vertical stress increases at…

Q: 2m Dry zone Soil properties: Gs = 2.68 A e = 0.85 В 1.8 m Saturation zone (capillary rise) 0.9 m D…

A: The soil properties are given Specific gravity of solids, Gs = 2.68 Void ratio, e =0.85 The total…

Q: Ex2: An embankment shown in the figure is constructed. compute the vertical stress increment under…

A: Calculating q q=γ1Hq = 19.2x6q = 115.2 kN/m2 σz = ql5σz=qπB1+B2B1α1+α2-B2B1α2 Here,…

Q: 3 m 1 m A seepage flow condition is shown in the figure. The saturated unit weight of the soil Yar…

Q: Question 1: (10) For the soil profile shown below where H1 = 5 m and H2 = 5 m: a) Calculate the…

A: Solution in Dry Sandrd = G1+erw = 2.681+0.6x9.81rd = 16.431 kN/m3in ClayrSat = G+e1+e rw =…

Q: (Use The Figure (10.20) to find the solution of this question) An embankment load on a silty clay…

A: We need to measure the stress increase beneath the embankment at sites A and B, which are located at…

Q: Consider a circularly loaded flexible area on the ground surface. Given: radius of the circular…

A: The increased in stress under the soil is happen by lots of situation like excess load over the…

Q: P2039 kg/m 10 m 15 m P- 1888 kg/m Saturated clay L Sand

A: Given data Depths Water level Saturated densities Sand Saturated clay

Q: 12m 4m 12m 6m Sm 9m 14m

Q: The sand layer shown is subjected to a downward flow of water. (52.58, 0.436, 14.36) In flow 0.70 Z…

Q: 4. A lake with a water depth of 12m in underlain by a soil with a saturated unit weight of 18.2…

Q: 04) From the figure below, calculate the increment stress (Ao) at depth(z=1 )meter under the point B…

A: To find :- The increase in stress due to two point load applied at points A and B 5 m apart at Z = 1…

Q: ts The value of effective stress at 4 m depth for the subsoil condition as shown in figure is…

A: Given; Depth of soil Void ratio Specific gravity of soil To find: Effective stress

Q: Qi! For the soil profile shown in the figure (1): 1- Calculate total vertical stress at the middle…

Q: A layer of soil profile in a tank with upward seepage is shown in Figure Q1. Calculate the total…

Q: b. Consider the downward flow of water through a layer of sand in a tank shown below. For the sand,…

Q: An aquifer is overlain by 15 m of jointed rock. The density of the rock is 2500 kg/m. The density…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: 3. | Calculate the change in total vertical normal stress (o) and in effective stress (6') au a…

A: given data: water content, w = 35% = 0.35 Depth, h = 10 ft Degree of Stauration, S = 100% Specific…

Q: For the soil profile shown in the figure (1): 1- Calculate total vertical stress at the middle of…

Q: 9.) For linear stress variation over the base of the dam of Fig. 47, find where the resultant…

Q: An earth embankment is shown in the figure. Determine the stress increase at 2. point A due to the…

A: Given that...

Q: An embankment shown in the figure is constructed. Compute and plot the distributions of the vertical…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: calculate the vertical stress increase at depth 2m 3m 4m 5m along a vertical plane passing through…

A: Given data : Q1=400 kN Q2=400 kN DISTANCE BETWEEN LOAD, r=50 m suppose the vertical plane passes…

Q: Problem 1: Point loads of magnitude 100, 200, and 400 kN act at A, B, and C, respectively. Determine…

Q: An earth embankment is shown in the figure. Determine the stress increase at point B due to the…

A: Consider the given diagram.

Q: The area shown in the figure carries a uniform pressure of 200 kPa. Find the total vertical…

Q: total effective stress acting at point A,

A: Given data: Unit weight of soil = 20.15 KN/m3 Specific gravity = 9.81 KN/m3

Q: Calculate the effective stress at A. 25 m Sand and- Gravel Water Table Unit Weight (y) = 20.72 kN/m?…

A: Following is the given soil profile:

Q: The value of effective stress at 4 m depth for the subsoil condition as shown in figure is (Assume…

A: Given data- depth of sand above and below water table d=2 mGs=2.60e=0.60unit weight of water=γw=10…

Q: Calculate the effective stress at A. 25 m Sand and- Gravel Water Table Unit Weight (y) = 20.72 kN/m…

A: Given: The unit weight of water is 9.81 kN/m3. Consider the diagram,

Question

Calculate the stress distribution with depth below the center of the dam, and the stress
distribution 5 m below the dam
5 m
1:3
10 m
1:2.5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Lateral earth pressure distribution against retaining walls

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the vertical stress at a depth of 50 ft below a point 10 ft oubide the corner (along the longer side) of a rectangular loaded area 30 x 80 ft carrying a uniform load of 2500 lb/ft2 .
Refer to Figure 10.47. A exible rectangular area is subjected to a uniformly distributed load of q 5 330 kN/m2. Determine the increase in vertical stress, Dz, at a depth of z 5 6 m under points A, B, and C .details about me sending through pictures
How should the groundwater table move to have an effective stress of 95kPA, 2m from the bottom of the profile? For specific gravity, Gs = 2.68.
A masonry dam (sp.gr. = 2.4) of trapezoidal cross-section is 20 m high. It has a thickness of 2 m at the top and 14 m at the bottomas shown in the figure.Coef. of friction under the foundation is 0.80 and assuming there is hydrostatic upliftthat varies linearly from one-half the hydrostatic head at the upstream edgeof the dam to zero at the downstream edge.Determine
A strip load of q =53 kN/m^3 is applied over a width B =11m. Determine the increase in vertical stress in kPa at point A located z = 4.6 m below the surface. x = 8.2m
A single rectangular opening 10 ft (3.0 m) in height is driven in rock having strengths of fc = 18,000 lb/in2 (124 MPa) and ft=1500 lb/in2. (10.3 MPa).Rock specific gravity is 2.3.The opening is located at depth of 2000 ft (610 m) in a stress field of no lateral pressure and has a fillet ratio of h .a. Determine if the opening will fail when its width is 20 ft (6.1 m).b. Is there any benefit to reducing the width to 10 ft (3.0 m)? To 5 ft (1.5 m)?c. What is the maximum safe width of opening?
A pole is held vertically on a soil surface by three equally spaced wires tied to the top of the pole. Each wire has a tension of 1 kN and is inclined at 45 degrees to the vertical.Calculate The increase in vertical stress in kPa at a depth 1 m below the surface. a. 3 b. 4 c. 2 d. 1
5. A thick layer of stiff saturated clay is underlain by a layer of sand under artesian pressure. A deep cut is made in the clay layer as shown in the attached figure. Determine: [2] a. The total stress at point A. b. The factor of safety against heaving at point A, if the effective stress is 12% of the total stress.
Soil with a unit weight of 16.97 kN/m^3 is loaded on the ground surface by a uniformly distributed load of 300 kN/m^3 over a circular area 4 m in diameter. Compute the total vertical stress increment due to this uniform load at a depth of 5 m below the center of the circular area. a.60 b.144.8 c.232.49 d.714
A circular area having a radius of 3 m carries a uniformly distributed of 90 kPa is applied to the ground. Compute the total vertical stress in kN/m^2 increment due to this unifrom load if the unit weight of soil is 18.40 kN/m^3 at point 6 m below the edge of the circular area. a. 18.62 b. 137.66 c. 115.17 d. 129.02
Calculate the vertical stress increases occurring at points A1 and A2 under a long earth fill shown in the figure. Unit weight of the earth ɣ=17.5kN/m3
How far apart must two 20 m diameter tanks be placed such that their combined stress overlap is not greater than 10% of the surface contact stress at a depth of 10 m?