Answered: Calculate the temperature of 0.39 mole…

Engineering

Civil Engineering

Calculate the temperature of 0.39 mole of Xenon gas that occupies 9850 millimeters under a pressure of 631 torr.

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter20: Hydrogen

Section: Chapter Questions

Problem 7P

See similar textbooks

Related questions

Q: An atomizer forms water droplets 45μm in diameter. Determine the excess pressure within these…

A: Given, Diameter of water droplets D= 45μm Therefore, radius r = D/2 = 45/2 = 22.5μm = 22.5×10–⁶m…

Q: An increase in pressure of a liquid from 7.5 MPa to 15 MPa results into 0.2 percent decrease in its…

A: Given: The increase in pressure of a liquid is 7.5 MPa to 15 MPa. The decrease in volume is 0.2%.

Q: An ideal gas has its pressure (1.7) times and mass density (2.9) times increased. If the initial…

Q: Calculate the dynamic and kinematic viscosities of water at 350 degrees Kelvin

A: Given data, Temperature= 350 degree kelvin to find dynamic and kinematics viscosities

Q: A cylinder that contains 0.068 kg of carbon dioxide (with molar mass 44 kg/kmol), occupying a volume…

A: A temperature is a unit of the average kinetic energy of the particles in an particle. When…

Q: 7. What is the potential energy of the 100-N block? 3 2 m Datum a. 50 J b. 100 J

A: Weight of the block = mg = 100 N . Height above datum = h =2 m . The potential energy depends upon…

Q: Required information Experimental data for the density of n-pentane liquid for high pressures, at…

A: We have to use linear interpolation between pressure 20700kPa and 34310 kPa because the given…

Q: A solid sphere (diameter 6 mm) is rising through oil (mass density 900 kg/m3, dynamic viscosity 0.7…

Q: Carbon dioxide at 30 °C and 325 kPa absolute pressure expands isothermally to an absolute pressure…

A: To find out the final density of the gas.

Q: QUESTIONS AND PROBLEMS: 1. If 5.6 mm3 of oil weighs 46,800 N. Calculate its density and its specific…

Q: Q1/ A tank contains 400 liter of brine in which 10 kg of salt are dissolved. Fresh water runs into…

Q: Select all fluids that would exhibit vapor pressure at STP. Water O Hydrogen O Air O Mercury

A: The pressure exerted by vapour phase is called vapour pressure. Vapour pressure of liquid or solid…

Q: 10 kg of gaseous CO2 contained in a closed system undergoes a reversible at a constant pressure.…

Q: 3. A metal sphere cools at the rate of 3 degrees Celsius per minute when its temperature is 50…

Q: What is the equivalent value of T58 in degrees Fahrenheit, Rankine, and kelvin

A: Given temperature = 58 oC

Q: certain fluid has an enthalpy 1800 KJ/kg and 500 KJ/kg work flow. Find the internal energy.

Q: A volume of 0.03 m' of O, mi larally at 220 F and pressure 4 bar is compressed reversibly at…

A: The given data is as follows: Initial volume of O2=0.03 m3Temperature of O2 gas=220 FInitial…

Q: Calculate the change in 5 m long copper wire when its temperature changes by 60∘C. State your…

Q: Find the total weight of a 10 ft' tank of oxygen if the oxygen is pressurized to 500 psia, the tank…

A: V=10ft3 P=500psia

Q: 2. With an initial pressure of 30x105 Pa and constant operating temperature of 200°K in a 40 m³-tank…

A: Given data:- Initial pressure =30×105 Pa Operating temperature =200°K Volume of tank =40 m3 Length…

Q: Water at 68 has a dynamic viscosity of 1 centipoise. Compute its dynamic viscosity and kinematic…

A: The viscosity is defined as the measure of the resistance developed in the fluid against the flow.…

Q: Solve the density of liquid ethanol at 180°C and 200 bar.

Q: y 30 kPa el.30 m alcohol From the figure shown, the alcohol surface is subjected to of 30 kPa.…

Q: Determine the gauge pressure of the water in the bulb. The densities of mercury and water are 13,600…

Q: A sample of air analysed at 0ºC and 1 atm pressure is reported to contain 0.02 ppm (parts per…

A: Given data: k=22.4 liters per mole M=46 gm

Q: 3.5 kg of an ideal gas is heated at constant temperature from 15 m3 and 4.0 atm to 35 m3 at…

Q: Several liquids are layered inside a tank with pres ized air at the top. If the air pressure is 3.2…

A: To find pressure at bottom of tank

Q: A brass rod and an aluminum rod are 90.00 cm and 90.06 cm, respectively, at 20°C. At what common…

A: At what common temperature will the two rods be exactly the same length?

Q: EXAMPLE 1 A perfect gas has molecular weight of 26 and a value of y = 1.26, ?Calculate the heat…

Q: 88.18 liters of a distinct liquid weig ermine its density ( D0 liter = 1 m3

A: Given data- Mass(m) = 417.91kg Volume(V)= 388.18 lit 1 m³ = 1000 lit Volume(V)= 388.18 lit =…

Q: In the Figure, if the local atmospheric pressure is 755 mm of mercury (specific ity 13.6),…

Q: Lauren has worker building her house on a hot summer day. She prepares a drink for them by adding a…

Q: The specific volume of a certain gas is 320-cu.ft/slug a. Determine its density b. Calculate its…

Q: A tank having a volume of 0.85 m3 initially contains water at 260 oF and x = 0.7. Saturated vapor…

A: A branch of thermal engineering that deals with transmission and conversion of thermal energy…

Q: calcujate the reading of o barometer în mm of mercury 97.9 kPa corres ponding to an atmospheric…

Q: What is the pressure in Kpa 1.20 m below the surface of a liquid of sp. gr. 1.20 if the gas pressure…

Q: The following information is given for n-pentane at 1 atm:boiling point = 36.20°C ΔHvap (36.20°C) =…

A: A type of elastic collision in which two objects of equal mass initially move in the same direction…

Q: vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m…

A: Given:- h=30m d=6m t=4.5m unit weight =0.12N unit weight increases by 7.5 percent every 2 meters.…

Q: 4.15 A gas-condensate reservoir has an areal extent of 200 acres, an average thickness of 15 ft, an…

A: Gas condensate is the blend of low-boiling hydrocarbon liquids which are obtained by the process of…

Q: to a depth of 100mm and rest with air. What is the pressure at the bottom of the periphery of the…

Q: Empty weight of pycnometer + fully filled water : 1387 grams what is the value of W2 ?

A: Given : Specific gravity GS= 4.45 Empty weight of pycnometer W1=529 g Empty weight of pycnometer +…

Q: PART III. PROBLEM SOLVING Instruction: Solve the following problem. Show your solutions neatly and…

A: X=3kg

Q: What isthe weight of a 10ft cube tank of oxygen if the oxygen is pressured ti 400 psia, the tank…

A: The given data is as follows: Volume of tank=10ft3 Pressure of oxygen=400 psia Weight of tank=100…

Q: The dimensionless Henry's constant of hydrogen sulfide (H2S) at 20°C is 0.38. 1) convert it to the…

A: Answer:-

Q: - A certain gas a value of R = .18896 KJ/kg°K and K = 1.288. Calculate the value of Cp and Cv.

Q: One pound of an ideal gas undergoes and isentropic process from 95.3 psig and a volume of 0.6 ft to…

A: bSpecific heat…

Q: A certain gas initially at 0.050 L undergoes expansion until its volume is 0.50 L. Calculate the…

A: A type of elastic collision in which two objects of equal mass initially move in the same direction…

Q: If the freezing temperature of water is 0 degrees Celsius, 32 degrees Fahrenheit and the boiling…

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

Calculate the temperature of 0.39 mole of Xenon gas that occupies 9850 millimeters under a pressure of 631 torr.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

3.5 kg of an ideal gas is heated at constant temperature from 15 m3 and 4.0 atm to 35 m3 at Determine the work done
calculate the density and specific weight of carbon dioxide at an absolute pressure of 300 kN/m^2 and 60 degree celsius
Fluid Mechanics Last Fall, researchers using an unmanned submarine discovered a coral reef at the unprecenented depth of 1/2 mile. The density of seawater at the surface of the ocean is 1025kg/m3 and the bulk modulus of elasticty of seawater is 2.34*109 Pa. A volume of air is taken downward to the coral reef. Assuming an absolute air pressure at the ocean surface of 1 atm, and that the air taken to the reef behaves as an isothermal gas. Find the pressure of the air at that depth. Find the fractional change in denisity and volume of the air at that depth.
Oil is subjected to a pressure of 300 kpa at A, where its velocity is 7m/s. Determine the pressure at B. Density of oil= 940kg/m3
1. If the work done 10000 cal, and the initial pressure 100 atm, when the ideal gas | expand isothermally and reversibly from the initial l volume (V1) to the final volume (10 V1), R = 1.987 cal/mole.K. ~ (A) calculate V1. (B) If there are - 2 moles from ideal gas what is the temperature.
A certain gas initially at 0.050 L undergoes expansion until its volume is 0.50 L. Calculate the work done (in joules) by the gas if it expands (a) against a vacuum and (b) against a constant pressure of 0.20 atm. (The conversion factor is 1 L ⋅ atm = 101.3 J.)
The following information is given for n-pentane at 1 atm:boiling point = 36.20°C ΔHvap (36.20°C) = 357.6 J/g melting point = − 129.7°C ΔHfus (−129.7°C) = 116.7 J/g specific heat gas = 1.650 J/g ⋅ °C specific heat liquid = 2.280 J/g ⋅ °C A 26.10-g sample of liquid n-pentane is initially at −51.40°C. If the sample is heated at constant pressure (P = 1 atm), how many kJ of energy are needed to raise the temperature of the sample to 65.30°C?
0.05 kg of steam at 1.5 MPa is contained in a rigid vessel of volume of 0.0076 m^3. A. What is the temperature of the steam? B. If the vessel is cooled, at what temperature will the steam be just dry and saturated? C. Cooling is continued until the pressure in the vessel is 1.1 MPa, calculate the amount of vapor at this point. D. Calculate the amount of heat rejected between the initial and the final state. E. Draw the Ts diagram of the whole process.
A balloon filled with hydrogen gas has a volume of 5200 cubic centimeters at 44 degrees Celsius and 9.0 x 104 Pa. What volume (in liters) does the H2 occupy at standard temperature and pressure(STP).
at 38 degrees celsius and 218 kpa gage, the specific weight of a certain gas was 15.0 n/m^3. determine the gas constant of this gas in j/(kg-kelvin).
FLUID MECHANICS-WATER HAMMER: A valve at the end of a gasoline pipeline is rapidly closed (assume instantaneously). If the gasoline velocity was initially 12m/s, what will be the water hammer pressure rise? The bulk modulus of the gasoline is 715 MPa, and the density of the gasoline is 680 kg/m3.
A circular cylinder 400 mm in diameter and 750 mm long has 600 mm of its length submerged in kerosene (S.G. = 0.823). What is the specific weight of the cylinder? a. 1.86 KN/m° C.) 0.608 kN/m3 b. 6.45 kN/m3 d.) 0.805 kN/m3