Calculate the total current I flowing across 120-2 resistor. 30 V Si 120 2 Vour 81=100 02= 100 1.2 ko V2 = 10V Vag = 0.7 V RL= 30 2 A 149.17 mA B 158.59 mA 177.77 mA

Q: 4.5 Voltage-Divider Bias Configuration 15. For the voltage-divider bias configuration of Fig. 4.125,...

A:

Q: QI. Estimate the power consumed by the lamp shown in Figure 5. Battery E = 18 V Lamp R=30 Figure 5

A: This question belongs to circuit theory . It is based on the concept of power consumption in the bul...

Q: A 415 V, 50 Hz, 3-phase supply is connected to a star-connected balanced load. Each phase of the loa...

A: Solve the problem

Q: 40 2 j20 2 V 6 /30° A :-j 30 2 50 2 + 120 -15° V (±

A:

Q: A coal fired Power plant with 30,000 kw rated capacity costs P 15,000 per kw installed. Annual opera...

A:

Q: a) Find the voltage Va as marked on the circuit. b) Find the power delivered by the current dependen...

A:

Q: Fl in the resulting register values in the figure below Source register R5 0000 1111 1111 1100 0001 ...

A:

Q: Assume SP=0XE99D, R16=0×E2, R17=0x25, R01=0XFC, R15=0×1F and the following memory information. Addre...

A:

Q: Calculate the relative permeability of an iron ring has mean diameter of 15 cm, a cross section of 1...

A: Given: Diameter, d=15 cm=0.15 m Cross section, A=1.4 cm2=1.4×10-4 m2 Length of air gap, lg=0.4 mm=0....

Q: 5. What will be the output of the following code? for i=1 : 3 i=i-1 end a) i will be printed thrice ...

A:

Q: E2.27 Find V, in the circuit in Fig. E2.27. I + 2VA A 4 kN 6 V(+ 8 kN Vo Figure E2.27

A:

Q: For the following function: F(a, b, c.d) = E (4,6, 12, 14, 9), d (1, 15) a. Find the minimum sum of ...

A: The minimum sum of product for the given function can be obtained by using k-map and the same can be...

Q: 9) Does this switch (in the open state) have a Low resistance or a high resistance between its termi...

A: In this question,  We need to determine and check the resistance low or high as per given the open c...

Q: The differential-mode input voltage, Vair, is the voltage difference between v* and v 3 Pdiff = Vin ...

A:

Q: total powe

A: When bulb in parallel voltage is same for all. When bulb is in series current is same for all bulb.

Q: ) Figure Q.3.2 shows a 3-bit ripple-carry-adder for S= A + B. Modify the adder to perform the subtra...

A:

Q: 1. If Vep=0 (the "bridge" is balanced), determine the resistance of R2, given R3 Rx 40 30 R1=48N, R3...

A: Determine the value of R2  if VBD = 0V and R1 = 48 ohm, R3 = 12 ohm and Rx = 3 ohm ?

Q: Question 1 /Soalan 1] (а) A cylindrical metal wire with a diameter of 1.5 mm is needed to carry a cu...

A:

Q: An ammeter (instrument that measures current) carries 0.05 A and is in parallel with a shunt resisto...

A: (a) Consider the KCL suggest that the total current that enters the node is equal to the current tha...

Q: 6. A circuit takes a current of 8 A at 100 V, the current lagging by 30° behind the applied voltage....

A:

Q: 21.84 • CALCA semicircle of Figure P21.84 radius a is in the first and second y quadrants, with the ...

A: The given figure is shown below, The radius of the semicircle is a.The positive charge(+Q) is distr...

Q: Q3: Find I, in the network in fig.(3) using superposition. YA

A:

Q: 3. An inductive coil having a resistance of 15 Q takes a current of 4 A when connected to a 100-V, 6...

A:

Q: Calculate the zero point fluctuation in Voltage VZPF for an LC oscillator circuit where L= 50 nH and...

A: Voltage fluctuations can be classified into two types: • voltage changes in steps, whether regular o...

Q: 13.10 The switch in the circuit in Fig. P13.10 has bee PSPCE closed for a long time. Att = 0, the sw...

A: In this question,  Find the current io and voltage vo as shown in the circuit?  We are solving this ...

Q: 2.12 Reduce the block diagram shown in Fig. P 2.12 and obtain the over all transfer function. G4 C(s...

A: Given: The block diagram of a system is: To find: The overall transfer function of the system using...

Q: A three-phase Y-connected alternator delivers a unity power-factor load at 220 volts. If the synchro...

A: The solution is given below 

Q: 2- In a certain Townsend discharge the primary cathode emission is 2 X 10'A and the first ionization...

A: Given: Primary cathode emission, I0=2×10-11 A First ionization coefficient value, α=1.5 cm-1 Electro...

Q: 1. Answer letters a and b. Fill-in the box with the correct answer. The 2V source is known to be sup...

A:

Q: Design a 7.5-V zener regulator circuit using a 7.5-V zener specified at 10 mA. The zener has an incr...

A:    

Q: what is the demand load contribution for a commercial laundry with ten 5-kva clothes dryers and ten ...

A: Given data, Number of commercial laundry = 10 Number of cloth dryers = 10 Rating of commercial laund...

Q: If A = ax + 3a, and B = 5ax + 2ay - 6az, find 04B-

A:

Q: 1. Determine the output voltage (Vo) and the diode current (Ip) for the circuit shown below, +8 V 1....

A: Given

Q: Question 1: a - How many branches are in this circuit? b- How many nodes are in this circuit? c - Ho...

A: Note: As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost ...

Q: Question 2 For the circuit shown in Figure 2, calculate: a) The circuit resistance b) The circuit cu...

A:

Q: In the circuit shown, compute for the phase angle of the branch current, Id

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's voltage law and ...

Q: Consider a step up converter with a resistive load of value R5 Ohms. It is supplied by a DC power so...

A: First calculate ripple current and than find the new value of ripple current . using new value of ri...

Q: A magnetic circuit consists of an iron ring of mean circumference 80 cm with cross-sectional area 12...

A:

Q: Determine I, RT, I, I. 8r 30V 20n

A:

Q: is absorbing an average power of 7.5kW and +7KVAR; Load 2 is absorbing an average power of 2.1kW and...

A:

Q: 3-bit counter for the sequence

A: Excitation table of D flip flop- Qn Qn+1 D 0 0 0 0 1 1 1 0 0 1 1 1 From the table- Qn+...

Q: delta-connected circuit having a load of resistance 12Ω and 31.83mH in series is supplied by 3 , 40...

A: GIVEN:                        f=60Hz              road resistance=                                  ...

Q: 2. Determine the value of the current given the forward voltage drop of the diode is 0.7V and R=50 N...

A: Determine the value of current given the forward voltage drop of the diode is 0.7 and R = 50 ohm.  

Q: What's the primary disadvantage of using copper conductors? A. Weight B. Durability C. Cost D. Ava...

A:

Q: (i) Compute the capacitance of the capacitor. [Hitungkan kemuatan bagi kapasitor.] (ii) Compute the ...

A:

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to ...

A: This question belongs to circuit theory . It is based on the relation between voltage , current and ...

Q: 3. Determine the value of the current given the forward voltage drop of the LED is 2.1V and R=100 Ω(...

A: Voltage drop across LED = 2.1 V Battery voltage = 9 V Therefore, voltage drop across resistance = 9 ...

Q: Analog and digital communication systems (ii) Digital modulation and digital transmission.

A:

Q: A. A Wien-Bridge oscillator with a lead-lag circuit is shown in Figure 1. 6.8 V 6.8 V Ry 47 k 100 ki...

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for...

Q: Consider the following amplitude modulated signal: S (t) = cos (2000 t) + 4 cos (2400 nt) + cos (280...

A: The solution can be achieved as follows. 

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.