Can I have a detailed, step-by-step explanation for the following question? Thank you very much! Four channels are multiplexed using TDM(Time-division multiplexing). If each channel sends 100 bytes/second and we multiplex 1 byte per channel. Find the; (i) Size and duration of the frame (ii) frame rate (iii) bit rate for the link

Q: Four channels, two with a bit rate of 120kbps and two with a bit rate of 880kbps, are to be…

A: Required: Four channels, two with a bit rate of 120kbps and two with a bit rate of 880kbps, are to…

Q: Four channels, two with a bit rate of 200 kbps and two with a bit rate of 150 kbps, are to be…

A: Firstly here giving four channels  Two with a bit rate of 200 kbps Two with a bit rate of 150 kbps…

Q: Exercise (3): The Bandwidth of a voice signal is 3000HZ, what is bit rate required to send this…

A: I have answered the question in step 2. bandwidth w = symbol rate= bit rate / divided by the number…

Q: Exercise (3): The Bandwidth of a voice signal is 3000HZ, what is bit rate required to send this…

A: I have answered the question in step 2. Bit rate = Bandwidth * log2(bit/sample)

Q: Four channels, two with a bit rate of 200 kbps and two with a bit rate of 150 kbps, are to be…

A: Given:   Two-channel with a bit rate of 200 kbps. Two-channel with a bit rate of 150 kbps.…

Q: Find the new durations for a) the input bit duration, b) the output bit duration, c bit rate, and d)…

A: When there are four channels then each frame will carry 2 bytes from each Channel  A)Therefore 2byte…

Q: For the following stream of digital signal which is being transmitted by bit rate 5 Kbps:…

A: a. Draw waveform for all line code is self synchronized or not.

Q: What is the maximum data rate of a channel with a bandwidth of 200KHZ if we use four levels of…

A: This question explains about the maximum data rate of a channel with a bandwidth of 200KHz if we use…

Q: Mention two (2) advantages that infrared communication has against microwave b. List and briefly…

A: This has two advantages:First, infrared communications will be additional simply secured against…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A:

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: To find (a) The input bit duration, (b) The output bit duration, (c) The output bit rate,   (d) The…

Q: 2. (a) Suppose a radio channel occupies a bandwidth of 11 kHz. We need to multiplex 14 radio…

A: a) Bandwidth occupied by radio channel =11 KHzNeed to multiplex 14 radio channels with guard binds…

Q: A digital signaling system is required to operate at 512 Kbps. a. If an 8-bit word is used to encode…

A: For the given digital signaling system which operates at 512 Kbps. Need to find :  a. If a 8 bit…

Q: A digital signaling system is required to operate at 512 Kbps. a. If an 8-bit word is used to encode…

A: The Answer is in given below step

Q: A digital signaling system is required to operate at 512 Kbps. a. If an 8-bit word is used to encode…

A: The Answer is in given below

Q: Discuss any three transmission media used for the transmission of data in computer networks. State…

A: In terms of data transmission, the media is a physical path between the transmitter and the…

Q: ) List and briefly define important factors that can be used in evaluating or comparing the various…

A: Q1  Advantages of IR communication: Security: Infrared communication has high directionality and…

Q: Q6: Suppose the carrier waveform illustrate below with assuming a group of 10 information signals xi…

A: ANSWER:-

Q: Assignment #1 For the following stream of digital signal which is being transmitted by bit rate 5…

A: For the following stream of digital signal which being transmitted by bit rate 5 Kbps.…

Q: 6) You are trying to calculate what the theoretical maximum throughput is on a given communication…

A: Given Bandwidth (B) = 15kHz = 15000 Hz Number of signal levels (M) = 2 Theoretical Maximum…

Q: 1. In a parallel communication, each bit requires a transmitter and receiver. a) True b) False 2.…

A: Note : As per bartleby guidelines we are allowed to solve first question only.

Q: 6) You are trying to calculate what the theoretical maximum throughput is on a given communication…

A: A music signal is characterized by a rms voltage of 2 V and a bandwidth B of 15 kHz. A noise process…

Q: Consider a geostationary satellite-based system. Earth stations are multiplexing digital information…

A: Given ,A geostationary satellite-based system .And a earth station is multiplexing the digital data…

Q: In digital transmission, the receiver clock is 0.2 percent slower than the sender clock. Answer the…

A:

Q: Suppose, you have 6 voice channels, each of 60MBPS. You have to use synchronous TDM to multiplex…

A: As per guidelines, i can answer only three subparts of any question , you can post other parts again

Q: Assume having a low-pass channel that spans from a Frequency of 0Hz to 110Hz, to attain a bit-rate…

A: please upvote for my efforts ! answer: shannon's  channel capacity formula: bit rate = bandwidth *…

Q: Consider a camera producing an HD video at a frame rate of 30 fps and frame resolution of 1280 x…

A: First We Need to Find Pixels Per Frame  = 1280*720 = 921600 pixels. And we know that 8 bits = 1 byte…

Q: Question 56: How many 8-bit characters can be transmitted per second over a 9600 baud serial…

A: Solution.

Q: What is the difference between "Simplex", "Half Duplex" and "Full Duplex" when describing a…

A: Simplex: Sender can send the data but that sender can't receive the data. Half-Duplex: Sender can…

Q: We need to use Synchronous Time Division Multiplexing to combine 17 different channels, where 10…

A: Can allocate ten 300 Kbps sources into five 600 Kbps => 12 total 600 Kbps sources. Each output…

Q: 06: Suppose the carrier waveform illustrate below with assuming a group of 10 information signals xi…

A: ANSWER:-

Q: Discussion: 1. State some applications of PSK modulation. 2. What are the advantages and…

A: 1) Applications  Local Oscillator.  Optical Communications.  Multi-channel WDM.  Deferral and add…

Q: Cn =2 H log2 V Cs = H log2 (1 + S/N) Suppose we are sending a signal using 3 bits over a 8 kHz…

A: Signal to Noise ratio is the measure of signals strength relative to the Background Noise  So,…

Q: Q.1: A binary symmetric channel with error probability of 0.3 and marginal entropy H(y)= 0.97095…

A: For answer (i) Attached image below:

Q: 1- The bandwidth of the SSB signal is compared to DSB signal A. Triple B. Double C. Same D. Half E.…

A: DSB  is double sideband suppressed carrier modulation and SSB is single sideband suppressed carrier…

Q: Two channels one with a bit rate of 190Kbps and another with a bit rate of 180 Kbps are to be…

A: Given: Two channels:  1) One with a bit rate of 190Kbps. 2) Another with a bit rate of 180 Kbps.…

Q: Suppose, you have 6 voice channels, each of 60MBps. You have to use synchronous TDM to multiplex…

A: As per guidelines, i can answer only three subparts of any question , you can post other parts again

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: (a) Input bit duration           As the data rate of each input connection is 1Mbps .  106 bits…

Q: 1. (c) Eight sources, six with a bit rate of 100kbps and two with a bit rate of 200kbps are to be…

A: Given:   Eight source , six bit rate of 100 kbps and two bit rate of 200 kbps.

Q: An analogue sensor has a bandwidth which extends from very low frequencies up to a maximum of 14.5…

A: Sampling Theorem: The Nyquist–Shannon sampling theorem is a theorem in the field of signal…

Q: 2. (b) We need to use Synchronous Time Division Multiplexing to combine 17 different channels, where…

A: Here we solve it: ========================================================================

Q: In 8 bit data transmission system the transmitted data X, Y and Z after adding an EVEN Parity. The…

A: Given 8 bit transmission system the transmitted data X,Y,Z after adding an EVEN parity and we need…

Q: 110. Bandlimited signal is a. transmission of signals without modulation b. simultaneous…

A: A signal whose energy contained within finite range

Q: An analog signal is first encoded in binary PCM before being transformed to a multilevel signal for…

A:

Q: Determine the minimum bandwidth, baud rate and bandwidth efficiency for the following bit rates and…

A: The Answer is

Q: 3. Draw the QAM analog signal that transmits the following bit stream: 0 1010010 1 0 0 1 1 0 1 1 1 1…

A: The Answer is

Q: Q1) Given an OFDM system with bandwidth 10 MHz and number of subcarriers N=1024. The cyclic prefix…

A:

Q: DSL is a combination of what two types of multiplexing? a. FDM and TDM b. FDM and FM c. AM and…

A: Digital subscriber line is technique to send or receive data from telephone lines.

Q: DSL is a combination of what two types of multiplexing? a. FDM and TDM b. FDM and FM c. AM and…

A: DSL (Digital Subscriber Line) is a method which is used for sending as well as receiving data…

Q: DSL is a combination of what two types of multiplexing? a. FDM and TDM b. FDM and FM c. AM…

A: DSL (Digital Subscriber Line) is a technology that allows you to send and receive data over phone…