Car A moves in a straight line while Car B moves along a curve having a radius of curvature of 200 m. Car A moves at a rate of 45 m/s and has an acceleration equal to 3.5 m/s, while Car B has a velocity of 34.545 m/s. Determine the velocity and acceleration which Car B appears to have from Car A's perspective.

Q: Data taken from a stress-strain test for a ceramic are given in the table. The curv is linear betwee...

A:

Q: A cylindrical water tank of 10 m high is to be filled with water. The tangential and longitudinal st...

A:

Q: . What is the longitudinal stress developed in

A: To find Longitudinal stress

Q: Heat flows through a wall at a rate of 3x 10° kJ/hr. The temperatures of two faces of the wall are 3...

A: We already know that heat passes through a wall.The temperature of two of the wall's faces is 327 de...

Q: 5. When unloaded, bars AB and AC are each 36 - in long and have a cross-sectional area of 2 in. Thei...

A:

Q: 1. A vibration isolation unit consists of two blocks of hard rubber bonded to plate AB and to rigid ...

A:

Q: 2.18 The rigid bar AB is supported by two rods made of the same material. If the bar is horizontal b...

A:

Q: A force of 5o kN has two components, F1 30 kN and F2 60 kN. Determine the angle that F, makes with t...

A: Given that: The force F = 50 kN has two components, F1 = 30 kN and F2 = 60 kN. It is required to det...

Q: 2. A train moving with constant acceleration travels 24 ft during the 10th sec of its motion and 19 ...

A:

Q: Block A has a mass mA and is attached to a spring having a stiffness k and unstretched length l0. If...

A:

Q: Determine the internal stresses developed in bars JH and HY when bar JH experiences a change in temp...

A:

Q: 1. In a Rankine cycle, steam enters the turbine at 2.5 MPa and condenser at 50 kPa, what is the ther...

A: Answer: The thermal efficiency of the cycle is 25.54%.  

Q: determine the temperature distribution along the fin surface. The thermal conductivity of the heat f...

A:

Q: 1-A 60 Hz generator supplying 60% of Pmax to an infinite bus trough a reactive network. A fault occu...

A: Let  p m be the max power  that can be discribedpmsinδ0=0.6 =psδ0=36.86°=0.643 radians durms the fau...

Q: The car is traveling at a speed of 57 mi/hr as it approaches point A. Beginning at A, the car decele...

A:

Q: A nylon material has a fracture toughness K1c = 2.1 MPa.m1/2 It follows a Paris Law for fatigue with...

A: Given : K = 2.1 Mpa.m1/2 C = 4 x 10-8 n = 3.2 N = 63387 To find a

Q: 2 m 1m 2 m This is not your wproperty so do www any 1.5 m kaC kpD 1.5 s In the assembly shown, sags ...

A: However our examination of the wavering of a glorified on a level plane moving mass on a spring was ...

Q: rce which has an amplitude F, = 20 N and itial conditions are xo = 4 cm, and x, = 0. of the mass aft...

A: data provided normal frequency wn =k/m =2700/3 =30 rad/s M = 3 kg K =2700N/mc =18 N.s/mF0 = 20 N wf ...

Q: A rigid vessel as shown in figure below contain three different gases separated by diaphragms. If di...

A:

Q: Problem (5.3) The outlet angles of the nozzle and blades of a two-row impulse turbine are in success...

A:

Q: Consider a belt drive that transmits 10 kW of power between two parallel shafts. The center-to-cente...

A: Given: kW=10 C=2 m N2=100 rpm N1=240 rpm D1=2R1=2*300=600 mm =.6 m μ=.2 wb=150 mm tb=12 mm N2N1=D1D2...

Q: 20. Assume that the valve timing diagram of a Cadilac engine shows the intake valve opened for a per...

A: Given data Intake valve is opened for a period of 290° Diameter of flywheel = 18"

Q: PROBLEMS FOR SOLUTION 1.6.5 Resolve a 100-kN force into components acting at 20 deg and 40 deg woth ...

A:

Q: Q2) A boom 20m long supports a load of 1200 kg as shown in the below figure. The cable BC is horizon...

A: The given load and cable and the FBD is as shown below,   T1=mgT1=12009.81T1=11.772 kN

Q: a. Determine the magnitue of P and F (in N) if the resultant of the five forces shown is 1000 N dire...

A:

Q: 1. Replace the loading acting on the beam by an equivalent force and a couple moment at point O.   ...

A:

Q: What will be max. height that the water tank that may become full if the max. tangential stress is S...

A:

Q: Consider the compound shaft KC which is composed of a 1200mm long solid rod fitted snuggly into an e...

A:

Q: The car is traveling at 48 km/h when the traffic light 90 m ahead turns yellow. The driver 1. takes ...

A:

Q: 3. Bars AB, CD, and EF each have a cross-sectional area of 25 mm and modulus of elasticity E= 200 GP...

A:

Q: MAKE A SIMPLE SKETCH OF CENTRALIZED AIR CONDITIONING SYSTEM, HOT AND COLD COMBO

A: Centralized  air conditioners  systems course cool air through an arrangement of supply and bring pi...

Q: The particle P starts from rest at point A at time t = 0 and changes its speed thereafter at a const...

A:

Q: RELEVANCE OF IST AND SECOND LAW OF THERMODYNAMICS

A:     The first law of thermodynamics is a adaptation of the concept of conservation of energy, differ...

Q: -2 m 1m 2 m This is not your owproperty so do osty any 1.5 m 37 yon ww Www 1.5 s ww

A: Given:  the value of s=0.842m Because vertical distance between B and D=1.5s+1.5=1.5×0.842+1.5=2.763...

Q: (^2\)4. A ship being launched slides down the ways with a constant acceleration. She takes 8 sec to ...

A:

Q: 2. Determine the resultant internal torque acting on the cross sections through poin B and C. 600 lb...

A: It is required to determine internal torque acting on point B and C

Q: What would be the analysis of the given table or graph

A: Given Data We have to analyze the graph and data table 

Q: 12. The 20-mm-diameter 2014-T6 aluminum rod is subjected to the uniform distributed axial load. Dete...

A:

Q: 2-Explain the concepts a) Small disturbance (small signal) stability b) Large disturbance (Transient...

A: a) Small Disturbance (small signal ) stability Definition : Small Signal stability its also called a...

Q: Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 MPa and – 10°C...

A:

Q: The displacement of a particle is given by s = 4t3 - 54t2 + 105t - 49 where s is in feet and t is in...

A:

Q: For a given actual Rankine Cycle, the actual enthalpy at the end of the isentropic expansion can be ...

A:

Q: A particle moves along a straight line with a velocity in millimeters per second given by v = 410 - ...

A:

Q: In an air conditioning unit, 3.5 m³/s of air at 27°C dry bulb temperature %RH at 100.325 kPa baromet...

A:

Q: A wood beam with a rectangular cross section(see figure) is simply supported on a span oflength L. T...

A: Given data as per question b = 80 mm, h =140 mm, L =1.75 m, α = 22.580 q = 7.5 kN/m. Calculations M...

Q: (1.13 The natural frequency of vibration of the following system is El = 200 Nm for the beam] rad/s....

A:

Q: 1. A stone is dropped down a well and 5 sec later the sound of the splash is heard. If the velocity ...

A: Time of splash sound, T=5 secVelocity of sound, V=1120 ft/sec

Q: 6. A 2kg box slides down a ramp a distance of two meters before it reaches the ground. The ramp has ...

A: Work done is defined as the product of force in displacement direction and displacement of body.

Q: An unknown hydrocarbon fuel, burned in air, has the following Orsat analysis: Carbon Dioxide 12.5% C...

A: Given data Carbon dioxide percentage = 12.5%Carbon Monoxide percentage = 0.3%Oxygen percentage = 3.1...

Q: S" sin?t cos*t dt

A: None of the choices

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.