certain Y-connected generator produces phase voltages of 30V. The magnitude of the line oltages are Vhen the turns ratio of a transformer is 25 and the primary ac voltage is 6V, the secondary roltage is If 10W of power are applied to the primary of an ideal transformer with a turns ratio of 7, the power delivered to the secondary load is

certain Y-connected generator produces phase voltages of 30V. The magnitude of the line oltages are Vhen the turns ratio of a transformer is 25 and the primary ac voltage is 6V, the secondary roltage is If 10W of power are applied to the primary of an ideal transformer with a turns ratio of 7, the power delivered to the secondary load is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.54P: An infinite bus, which is a constant voltage source, is connected to the primary of the...

See similar textbooks

Similar questions

A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
An infinite bus, which is a constant voltage source, is connected to the primary of the three-winding transformer of Problem 3.53. A 7.5-MVA,13.2-kV synchronous motor with a sub transient reactance of 0.2 per unit is connected to the transformer secondary. A5-MW,2.3-kV three-phase resistive load is connected to the tertiary Choosing a base of 66 kV and 15 MVA in the primary, draw the impedance diagram of the system showing per-unit impedances. Neglect transformer exciting current, phase shifts, and all resistances except the resistive load.
Three single-phase transformers, each rated 10MVA,66.4/12.5kV,60Hz, with an equivalent series reactance of 0.1 per unit divided equally between primary and secondary, are connected in a three-phase bank. The high-voltage windings are V-connected and their terminals are directly connected to a 115-kV three-phase bus. The secondary terminals are all shorted together. Find the currents entering the high-voltage terminals and leaving the low-voltage terminals if the low-voltage windings are (a) Y-connected and (b) - connected.
ََQ/ 400/200 V, single-phase transformer is supplying a load of 50A at a power factor of 0.866 lagging. The no-load current is 2A at 0.208 p.f. lagging. .. Find The primary current is ...... A * The primary power factor is ........ lagging *
12. A 600 kVA, 1-ph transformer has an efficiency of 92 % both at full-load and half-load at unity powerfactor. Determine its efficiency at 60 % of full load at 0.8 power factor lag.
A 500 kVA, 1100/400 V , Dy1 transformer takes 730 W on no-load and 3,1 kW on short circuit. The transformer supplies a balanced load of Z = 0,8 +j 0,6 ohm per phase connected in Delta. Calculate: a) The Power Factorb) Power and Reactive power of the Loadb) The transformer efficiency at this loadc) The equivalent transformer resistance in secondary terms.
a 100 kva, 1100/220 v, 50 hz, single-phase transformer has a leakage impedance of (0.1 +0.40) ohm for the h.v. winding and (0.006 + 0.015) ohm for the l.v. winding. find the equivalent winding resistance, reactance and impedance referred to the h.v. and l.v. sides.
Two single-phase transformers whose phase electrical equivalent circuits are given below are connected in parallel and ZL= 0.8+j0.6 ohm is feeding a worth of load. Idle operating voltage of Transformer 1 is 220 V and Transformer 2 idle operating voltage is 240V. a.) Find the currents flowing from transformers to the load. b.) Find the active powers that transformers transfer to the load.
A 1-ph transformer 25kVA, 330/110 V, 50Hz, Req2 = 0.045Ω and Xeq2 = 0.065Ωdraw the Kapp regulation diagram referred to primary then use the diagram tocalculate the regulation up at full-load and power factor of 0.8 lag and lead, 0.6 lagand lead.
4) A 2300/230V , 60Hz transformer takes 0.5A at a power factor of 0.25 on open circuit when supplied at 230V. (A) find the resistance representing the core loss in ohms, (B) find the magnetizing reactance of the core in ohms, (C) find the magnetizing current in amperes,(D) fine the core loss components of current in amperes Subject Electrical Apparatus and Devices
A small industrial plant draws an average load of 122 A at 0.73 power factor lagging from thesecondary of its 2300/208 V, 60 kVA, star-delta transformer bank. Find: (iv) the rated transformer phase currents of the delta secondaries(v) percent of rated load on the transformers(vi) primary line and phase currents(vii) the kVA rating of each individual transformers
A Wye-Delta transformer is connected t0 66 kV input three-phase transmission line. Each transformer is rated at 1000 kVA and has step-down ratio of 8.1_ The bank supplies balance load having powel factor of hag with load current of 70 Assume idea transformer; determine_ The primary line and phase voltages The secondary line and phase voltages The secondary line and phase currents The apparent and active power at the load Total kVA capacity of the transformer