O d. of themThe Thermistor is a special type of variable capacitive elementthat changes its physical capacitive reactance when exposed tochanges in temperatureSelect one:O a. TrueOb. Falsetor B describes the gradient of the resistive (R/T)

Thermistor is useful for measuring temperature.

Answered: changes its physical capacitiv ges in…

Engineering

Electrical Engineering

changes its physical capacitiv ges in temperature t one:

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: between Find the equivalent capacitance "a" and "b" for the combination of capacitors. shown: (Note:…

Q: A semiconductor Hall device at T=300 K has th and L=10' cm. The following parameters are meas

Q: In a given parallel plate capacitor with a capacitance of "C" Farad, if the distance between the…

Q: A 10 mH inductor has voltage v=100 sin (2000f) volts. What is the voltage at t=0.05s?

A: In this question, What is value of voltage at t= 0.05s if voltage across the inductor v(t) =…

Q: What is the unknown inductance L in the circuit if the equivalent inductance Le=28H at AB terminals…

A: In this question , we will find unknown inductance L from given equivalent inductance...

Q: 10 Ω 10 Ω ww 5 µF 1 H +) V.(t)

Q: Item 1 of 10 An inductor carries 2 A dc. If its inductance is 100 µH, then what is its inductive…

Q: For the circuit shown below the voltage across the capacitor is 102 -j100 2 (10+ j0) V ) j100 2

Q: Practice Problem The current through a 100-uF capacitor is it) 50 sin 120t mA. Calculate the voltage…

A: This question belongs to circuit theory . It is based on the concept of voltage across the capacitor…

Q: A capacitor of 0.15 mF has a voltage of 80 sin(400t). The energy stored in it at t = 4 ms is: Select…

A: Given: Capacitance of capacitor, C=0.15 mF Voltage, vc=80sin400t Time, t=4 ms

Q: A capacitor have an area and length of 80mm² and 1.75mm. The energy stored of the capacitor is…

A: We need to find out voltage across capacitor

Q: A capacitor of 0.01 μF was charged by connecting to a 1000 V DC source in series with a 100 kΩ…

A: For source free circuit, voltage across capacitor is VC(t)=V0e-tς For with source circuit, voltage…

Q: In a purely inductive circuit, the current will lead the applied voltage by an angle 90 degrees.…

A: If the purely inductive load applied to the voltage source then current will be lead Is this…

Q: Find the capacitance (in units of pF) of a parallel plate capacitor that is made of two parallel…

A: Given, A parallel plate capacitor with Area of plates, A=7.6×104 m2 Separation of plates, d=2.4 mm…

Q: A 50-µF and 100-µF capacitors are connected in series and across a 100 sin (wt + 30o) voltage.…

A: In this question we need to choose a correct option

Q: 15 Kh 30v d. How many tíme constants will it take for tue soltage to reach 23 v? C. Gweng that the…

A: As per company guidelines we can solve only first question kindly post another question separately

Q: between 11 Find the equivalent capacitance "a" and "b" for the combination of capacitors shown:…

A: given here a combination of capacitors and asked to find the capacitance between the terminal a and…

Q: A 150 µF and 100 µF capacitors are connected in series and across a 100 sin (wt + 30') voltage.…

A: For the given circuit we need to find current.

Q: 40 uF 10 uF 10 uF 35 µF 5 µF 20 uF 15 uF 15 µF

Q: For the inductor in the figure, find the inductance L in henries. 1 = 100 mm Air core d = 5 mm 200…

A: This is a basic problem of electromagnetism. The solution is shown in the next step

Q: wo element R=5 ohm and c=100 uF are connected in series at t=0. Initial capacitor voltage is 2 V.…

A: Fig: RC circuit without source. Given data R= 5 ohm C= 100 micro farad V0 =2V

Q: Calculate the voltage across a capacitor of 2.5 mF at t = 0.13 s if the current through it is 50…

A: Voltage across capacitor at t= 0.13s

Q: 2MF ㅔ C₁ THMF 24V 2MF 1. TOTAL CAPACITANCE- C4 똬 2mF -HICO AMF

Q: The figure shows the voltage across C = 300µF, then the current through th capacitor between 1 st<3…

A: the figure shows the voltage across C=300 micro farad. then the current through the capacitor…

Q: 9) The voltage across a 12-mH inductor is v= 24cos (200t – 10°) V. Find the instantaneous through…

A: In this question we have given voltage across inductor ....We have to find out current through it...

Q: A capacitor of 0.3 mF has a voltage of 25 cos(250t). The energy stored in it att = 10 ms is: Select…

Q: Solve for the equivalent capacitance if C1 = 22 micro Farad and C2 = 60 micro Farad. Note: All…

A: In this question we will find equivalent capacitance...

Q: What capacitance must be placed in series with an inductance of 0.05 H so that at 100 Hz, the…

Q: A coil having an inductance of SormH and resistance 1o2is cannected in 5 eri e5 with a 25 uF…

A: In RLC circuit at resonance the inductive reactance is equal and capacitive reactance. At resonance…

Q: Determine the value of the unknown capacitance C in ( µF) , which would balance the AC Bridge in…

A: For balancing of the bridge ,the multiplication of cross bridge components should be equated. (i.e…

Q: The voltage across a 12-mH inductor is v= 24cos (200t − 10˚) V. Solve the instantaneous current…

Q: The value of the Inductance can be determined by (W - is energy stored in inductor, I- current) O a.…

A: w = energy stored in inductor I = current L = inductance

Q: 1) Consider the voltage waveform, applied across a 30-µF capacitor. i) Do the necessary calculations…

A: Fig: Given waveform of voltage across capacitor Given that C= 30μF (a) It…

Q: A capacitor of 1uF is connected to a 50 Hz supply. The capacitiv O 10/n kilo ohms 50 mcga ohms O…

Q: In a given parallel plate capacitor with a capacitance of "C" Farad, if the distance between the…

Q: (b) The voltage applied across a 0.5 µF capacitor has the waveform shown in Figure Qlb). (V) 10- 2 4…

Q: 4.For the following pair of voltage and current, indicate whether the element involved is a…

Q: For the given circuit of FIGURE 2: Calculate the capacitor voltage for t 2 F + v – | = 0 42 ( 2 A +…

A: Before t = 0, v = v1 + v2 , where 1 v is due to the 12 -V source and 2 v is due to the 2 -A source.…

Q: A capacitor has a reactance of 35 ohms when operated on a 5 KHz supply. Determine the value of the…

Q: A direct current (DC) of 4A flows into a previously uncharged 20 µF capacitor for 3 ms. Determine…

A: Given: Direct current, I=4 A Uncharged capacitor of capacitance, C=20 μF Time, t=3 ms

Q: Determine the total capacitance. 4F 12F 3F 6F 4F

Q: Determine the voltages across all capacitors v₁.₂ & v₂ for t> 0. 2 ΚΩ t=0 1mF E 1kΩ + V₂ HH 8 mF - 1…

Q: For the circuit given below , show and explain what is the value of capacitor voltage before switch…

Q: Solve for the equivalent capacitance if C1 = 22 micro Farad and C2 = 60 micro Farard. Note: All…

Q: What capacitance must be placed in series with an inductance of 0.05 H so that at 100 Hz, the…

A: For impedance become resistive , capacitive impedance = inductive reactance…

Q: Question 3 A current source in a linear circuit has i(t) = 12 cos (100nt – 15°) A Determine the…

Q: The figure shows the voltage across C = 300µF, then the current through the capacitor between 1 st<3…

A: given data:

Q: Find the maximum charged value of the capacitor of the circuit below during the positive half cycle.…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

O d. of them
The Thermistor is a special type of variable capacitive element
that changes its physical capacitive reactance when exposed to
changes in temperature
Select one:
O a. True
Ob. False
tor B describes the gradient of the resistive (R/T)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor domain.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Clear solutions pls. Thank you Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 1 ohms R2 = 10 ohms C1 = 0.007 Farad C2 = 0.008 Farad Vs = 9 Volts Frequency = 6 Hz What is the Total Reactance in ohms?
Number 9 Please show your detailed solution. Number 9 Please show you detailed solution. A 50-ohm resistor is in series with a 40-?F capacitor across a constant potential source of 180 volts. Determine frequency that will give current of 3.13 amp. A. 250 Hz C. 160 Hz B. 200 Hz D. 140 Hz
An inductive coil and a non-inductive resistance R ohms are connected in series across an a.c. supply. Deriveexpressions for the power taken by the coil and its power factor in terms of the voltage across the coil, theresistance and the supply respectively. If R = 12 Ω and the three voltages are in order, 110 V, 180 V and 240 V,calculate the power and the power factor of the coil.
Give me right solution according to the question. Determine Rout (in kΩ) for the figure.
(c) Measure the voltages of the resistor and capacitor and calculate the current using Ohm's Law (d) Calculate the energy stored by the capacitor. Please answer in typing format please ASAP for the like please clear the