Chapter 27, Problem 076 GO In the figure the ideal batteries have emfs &₁ = 18.5 V, E2 = 9.23 V, and E3 = 4.60 V, and the resistances are each 1.50 2. What are the (a) size and (b) direction (left or right) of current i₁? (c) Does battery 1 supply or absorb energy, and (d) what is its power? (e) Does battery 2 supply or absorb energy, and (f) what is its power? (g) Does battery 3 supply or absorb energy, and (h) what is its power? f Ez www #F + foo - 1&₂

Chapter 27, Problem 076 GO In the figure the ideal batteries have emfs &₁ = 18.5 V, E2 = 9.23 V, and E3 = 4.60 V, and the resistances are each 1.50 2. What are the (a) size and (b) direction (left or right) of current i₁? (c) Does battery 1 supply or absorb energy, and (d) what is its power? (e) Does battery 2 supply or absorb energy, and (f) what is its power? (g) Does battery 3 supply or absorb energy, and (h) what is its power? f Ez www #F + foo - 1&₂

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 40P: A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V....

See similar textbooks

Similar questions

A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V. (a) What average current does the phone draw from its battery? (b) Calculate the energy stored in a fully charged battery if the phone requires charging after 5.00 hours of use.
In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
(a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss the difficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P=I2 RP = .)
A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?
A car battery with a 12-V emf and an internal resistance of 0.050 is being charged with a current of 60 A. Note that in this process the battery is being charged. (a) What is the potential difference across its terminals? (b) At what rate is thermal energy being dissipated in the battery? (c) At what rate is electric energy being converted to chemical energy? (d) What are the answers to (a) and (b) when the battery is used to supply 60 A to the starter motor?
Unreasonable Results A 1.58-V alkaline cell with a 0.200- internal resistance is supplying 8.50 A to a load, {a) What is its terminal voltage? (b) What is the value of the load resistance? (c) What is unreasonable about these results? (d) Which assumptions are unreasonable or inconsistent?
In the circuit shown in the figure, both capacitors are initially charged to 45.0 V.a. How long after closing the switch S will the potential across each capacitor be reduced to10.0 V?b. What will be the current at that time?
Hi, here's my question. 26.51: In the figure, C=5.90 mF, e=28.0 V, and the emf has negligible resistance. Initially, the capacitor is uncharged, and the switch S is in position 1. The switch is then moved to position 2, so that the capacitor can begin to charge. (a) What will the charge on the capacitor be a long time after S is moved to position 2? (b) After S has been in position 2 for 3.00 ms, the charge on the capacitor is 110 mC. What is the resistance R? (c) How long after S is moved to position 2 will the charge of the capacitor be 99.0% of the final value found in part (a)?
(I) An electric car has a battery that can hold 16 kWh ofenergy (approximately 6x107 J ). If the battery is designedto operate at 340 V, how many coulombs of charge wouldneed to leave the battery at 340 V and return at 0 V to equalthe stored energy of the battery?
The human body can exhibit a wide range of resistancesto current depending on the path of the current, contactarea, and sweatiness of the skin. Suppose the resistance acrossthe chest from the left hand to the right hand is 1.0 x 106 Ω.(a) How much voltage is required to cause possible heartfibrillation in a man, which corresponds to 500 mA of directcurrent? (b) Why should rubber - soled shoes and rubbergloves be worn when working around electricity?
A 70 μF capacitor is fully charged by a 15 V battery. It is then disconnected form the battery and discharged thruh a 180 olhm resistor. If we define a capcitor to be fully discharged when ther is less than one elementary charge e on it, then how long does it take to fully discharge this capacitor?
Describe the Simple RC circuits (Section 28.6, charging/discharging a capacitor)?