Check all that are true In a reversible process: (For some reason I am not able to get the right answers every time, so I need your help!) entropy may decreaseentropy transfer vanishesO entropy stays constantentropy must increaseentropy generation vanishesentropy transfer is proportional to heat transfer

Entropy is the loss of available energy to do work. Entropy refers to the randomness in the system.…

Answered: Check all that are true In a reversible…

Check all that are true In a reversible process: (For some reason I am not able to get the right answers every time, so I need your help!)

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter6: Forced Convection Over Exterior Surfaces

Section: Chapter Questions

Problem 6.12P

See similar textbooks

Related questions

Q: energy in a closed systems is equal to heat transferred if the Change in inter reversible process…

Q: 02: One mole of air at Pi and temperature T, is compressed at constant volume till its pressure…

A: Given, No. of moles, n=1 State 1-2 (Isochoric compression) P2=2P1 V2=V1 State 2-3 (Isothermal…

Q: Example 3.15: A fluid at 4.15 bar is expanded reversibly according to a law PV = constant to a…

Q: 4. During the execution of a reversible non-flow process the work is -156.2 KJ if V1=0.845 and the…

Q: Find the change of internal energy in Btu if a closed gaseous system undertakes a reversible process…

Q: Q1) Can the entropy of a closed system decrease during a reversible process ? Write down what needs…

A: Entropy Entropy is the measure of disorder in the system i.e. more the disorder entropy increases.…

Q: Air is compressed steadily by a reversible compressor from an inlet state of 100 kPa and 300 K to an…

A: The inlet pressure of the air at the compressor is P1=100 kPa The exit pressure of the air at the…

Q: One kg of a fluid is compressed reversibly according to a law pv = 0.25 where p is in bar. The final…

A: Mass of fluid, m = 1 kg PV = 0.25 Let initial Volume, = V1 m3/kg Final Volume, V2 = 0.25 V1 m3/kg

Q: hats the value of Helmholtz free energy and bbs free in reversible processes ???

Q: 5 kg of water vapor per minute enters a heat exchanger as saturated steam at 1 MPa pressure and…

A: At 1MPa from the saturated steam table, sfg=4.4462kJ/kg-K Given mass flow rate =5kg

Q: A closed gaseous system undergoes a reversible process during which 25 BTU are rejected, and the…

A: Answer: The change in internal energy is 2.7635 BTU.

Q: Water is heated in a boiler. The inlet water enters as a saturated liquid at 5000 kPa and exits at…

Q: 3. Consider that 1 kg of air has a decrease of internal energy of 21.7 kJ while its temperature is…

Q: Prove that the “cycle” consisting of only two adiabatic steps (reversible expansion and then…

Q: A Carnot engine operates between 37 Cand347C. If the engine produces 620 kJ of work, the entropy…

A: The heat supplied can be determined as,

Q: Methane is compressed in a two-stage, double-acting compressor which is electrically driven at 165…

A: Calculate the pressure ratio of the compressor.

Q: If you had an uninsulated air compressor which required W(in)= 400 kW to take air from a state at 80…

A: Given data as per the question W(in)= 400 kW Initial pressure =80 kpa Initial temperature =200 c…

Q: 4) Air is compressed in a steady-state compressor from 150 kPa and 16 °C to 650 kPa. The mass flow…

A: Given: -At the compressor inlet -The air pressure P1= 150 kPa -The air temperature T1= 16oC -Mass…

Q: Consider the system shown in the figure. When the pins fall away, the gas expands against a constant…

A: Number of moles of the gas, n=10 Initial pressure Pi= 5atm External Pressure Pext = 1 atm T = 300 K…

Q: Multiple Choice: Determine the cycle if the Clausius inequality is -0.185 BTU / R is it? a.…

A: It is required to determine whether given cycle is reversible, irreversible or impossible

Q: Consider a closed system going through an irreversible process that includes heat transfer with the…

A: Since the heat is transferred to the surroundings from the system therefore the entropy of the…

Q: Superheated steam originally at P, and T, expands through a nozzle to an exhaust pressure P.…

A: Given:

Q: Find the ratio of work done during an adiabatic reversible process to that done during isothermal…

Q: How to show that for reversible cycles ,the heat transfer also ratio QH/QL can be replaced by the…

A: Reversible heat engines are those engines that operate between the two heat reservoirs and have the…

Q: execution of a reversible nonflow process, the work is 216 kJ. If the initial pressure and volume…

Q: A: Derive the steady flow energy equation and reduce it for a. A turbine (Reversible Process) b. A…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Q1/ Find the equation for the work of a reversible, isothermal compression of 1 mol of gas in a…

A: Given data: - The number of moles is n = 1 mol. The molar volume of the gas is V=RTP+b.

Q: Steam at 4 MPa and 400?C is throttled adiabatically through a partially open valve to a pressure of…

A: In throttling, the pressure of the flowing fluid reduces. In the give situation, steam pressure will…

Q: For any irreversible process the net entropy change is Zero positive O negative O infinite O unity O

A: Option b is correct.

Q: Isochoric: A reversible non-flow, constant volume process decreases the internal energy by 316.5 KJ…

Q: and abc. Determine the work done by an ideal gas executing these reversible processes if P, 2P, and…

Q: Can saturated water vapor at 200 kPa be condensed to a saturated liquid in an isobaric, closed…

A: On using a steam table, the properties of saturated water vapor at 200 kPa are given as, The heat…

Q: When two systems are in contact, the entropy transfer from the warmer system is equal to the entropy…

A: Yes, the above statement is absolutely true. Entropy is a thermodynamic quantity that derives its…

Q: Derive the reversible steady-flow work relations.

A: During a steady flow extensive(dependent on mass) or intensive(independent on mass) property of…

Q: Nitrogen at 825 kPa and 450°C enters a steady-flow nozzle with a low velocity (0.45 m/s) and leaves…

A: Write the given data. Pin=825 kPaTin=450 °Cvin=0.45 m/sPex=125 kPa

Q: Argon (3 kg) is compressed adiabatically in a piston-cylinder device from 0.41 m³, 0.1 MPa and 27…

A: Solution.

Q: Show that the entropy remains constant in a reversible process but increases in an irreversible…

Q: During an isothermal process at 88°F, the pressure on 8 lbm of air drops from 80 psia to 5 psig. For…

Q: A curious blacksmith forge 1 kg of iron then dropped it to an insulated container that contains 50…

A: Givenmass of iron mi=1 kgInitial temperature of iron ,Ti=500οCSepecific heat capacity of iron Ci=0.5…

Q: It is well known that the actual work between the two specified states depends on the path followed…

A: When an outer force acts on the surface, and it gets displaced from its original position, then the…

Q: The equation of work done in a reversible process for a closed sysfem can be expressed as:

A: A closed system is a system that interacts with the surroundings and only transfers the heat and…

Q: A gas expands from an initial volume of 0.2 m3 to a final volume of 0.4 m3 in a reversible steady…

Q: 1- It is possible to transfer heat from cooler place to a hotter one, show how with sketch? 2- Why…

A: Given questions: 1. It is possible to transfer heat from cooler place to a hotter one, show how with…

Q: Ammonia gas(k=1.32) flows isentropically from100kPa and 130C to 400kPa with required input…

Q: Exercise 6-1 Consider an ideal gas that undergoes an isothermal reversible change from pressure p,…

A: Reversible isothermal process: A reversible process is one whose route stays consistent in both…

Q: A piston/cylinder arrangement contains 2 kg of ammonia at a temperature 132.45 ℃ and a pressure 5…

A: A thermodynamic cycle (state I → state f ) is supposed to be reversible in the event that the…

Q: A refrigerator transfers 1kJ of heat from a cold region at -20°c to hot region at 30°c. If COP of…

A: Data given QL = 1 kJ TL = -20°C = 253 K TH = 30°C = 303 K COP = 4

Concept explainers

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.

Question

Check all that are true In a reversible process: (For some reason I am not able to get the right answers every time, so I need your help!)

entropy may decrease
entropy transfer vanishes
O entropy stays constant
entropy must increase
entropy generation vanishes
entropy transfer is proportional to heat transfer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

We take a 33 kg chunk of ice (Temp is 0°C) and submerge it in an isolated container. This container has 6 kg of water, and the water is 7°C. Answer the following: 1) How much ice from the block melts (in grams)? 2) What is the change in entropy for the entire system?
Four pounds of air gain 0.491 Btu/R of entropy during a nonflow isothermal process. If p1=120 psia and V2=42.5 ft3, find (a)V1 and T1, (b) W, (c) Q and (d) change of internal energy.
Brine enters a cooler at the rate of 50 m3/hr at 15°C and leaves at 1°C. Specific heat and specific gravity of brine are 1.07 kJ/kg–K and 1.1 respectively. Calculate the heat transferred in kW. With step by step explanation.
A tub that contains 1 kg of gasoline at 29 oC received 100 kJ of heat. Calculate the extensive entropy change of the system (tub of gasoline). Report your answer in units of kJ/K using three decimal places. You may assume the process is isobaric, and CP of gasoline is 2.22 kJ/(kg · K)
If you know that dU = – P dV + T dS (P is pressure, V is volume, S is entropy and T is temperature), use the Legendre differential transformation to prove that dA = – P dV – S dT.
P88#1. a perfect gas has a value of R=58.8 ft.lbf/lbm degree Rankine and K=1.26. if 20 Btu are added to 5lbm of this gas at constant volume when the initial temperature is 90degree farenheit, find (a)T2, (b) enthalphy, (c)entropy, (d)internal energy and (e) work for nonflow process.
A glass of 450.0 g water at 20 ∘∘C is chilled using a 10.0 g icecube at 0 ∘∘C. Assume that the mixing happens under constant pressure and sufficiently fast so that no heat is exhanged between the content of the glass and its surroundings. Calculate the entropy change of the universe (water and icecube) as result of the mixing process.
Choose correct answer: In a system, mass interaction is equal to zero, energy interaction is equal to zero, then the system is __________ A. reversible B. open C. closed D. isolated
p88#5. while the pressure remains constant at 689.5 kPa the volume of a system of air changes from 0.567m^3. what are the (a)internal energy,(b) enthalphy ,(c) Q, (d) entropy, (e) if the process is nonflow and internally reversible,what is work?
Q15: Oxygen (molecular weight 32) is compressed reversibly and polytropically in a cylinder from 1.05 bar, 15°C to 4.2 bar in such a way that one-third of the work input is rejected as heat to the cylinder walls. Calculate the final temperature of the oxygen. Assume oxygen to be a perfect gas and take mathcal C V=0.649 kJ/kg K K.
Define “entropy” and discuss some of its implications;
1 atm = 2116 lb/ft2 = 1.01 × 105 N/m2. Just upstream of a shock wave, the air temperature and pressure are 288 Kand 1 atm, respectively; just downstream of the wave, the air temperatureand pressure are 690 K and 8.656 atm, respectively. Calculate the changesin enthalpy, internal energy, and entropy across the wave.