CI 6). Tre dentical capacitor are connected in delta to 430 Volts, = 50 Hz, 3 phase suppy.If th line curent is 10 A. Calculate its eactance and capacitance valuéReactance Xc isThe capacitance of each capacitor, C

Answered: Image /qna-images/answer/3ce76efb-87d8-44ec-8fbb-6c1a66477e99.jpg

CI (). Tre dentical capacitor are connected in delta to 430 Volts, = 50 Hz, 3 phase supply.If th line curent is 10 A. Calculate its eactance and capacitance valué Reactance Xc is The capacitance of each capacitor, C

CI (). Tre dentical capacitor are connected in delta to 430 Volts, = 50 Hz, 3 phase supply.If th line curent is 10 A. Calculate its eactance and capacitance valué Reactance Xc is The capacitance of each capacitor, C

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.44P: Consider the line of Problem 4.25. Calculate the capacitive reactance per phase in mi.

See similar textbooks

Related questions

Q: 3-phase 132 kV, 100 km, 50 Hz, single circuit line has horizontal spacing with 3.5 m between…

A: Given three phase line with132 kv,100 km,50HzThe conductor diameter d=1.2 cmraduis r=d2=0.6…

Q: A Single-Phase Transmission Line has two parallel conductors 2.25 meters apart. The radius of each…

A: We need tell about capacitance per unit length of parallel line .we will use direct formula.

Q: C1 (ii). Three Identical capacitors are connected in star to 410 Volts, F = 50 Hz, 3 phase supply.…

A: Capacitor are connect in star Voltage 410V Line Current = 12A Reactance and capacitance?

Q: A 240 kV, 3-phase, 50 Hz, 400 km transmission line has a capacitance to earth of 0.04 µF/km per…

A: We have a 3-phase transmission line having, Line voltage (V) = 240 KV = 240 * 103 V frequency (f) =…

Q: 435 volts, F = 50 Hz, 3 phase supply. If the line current is 38 A. Find the following below:…

A: For star connected system line current is equal to phase current ,phase voltage =line voltage 3…

Q: 23. A 150- microfarad capacitor is connected to a 220 V, 60- cycle source. Calculate a. The…

Q: Three identical capacitors of 25 micro farad are connected in star across a 420 volts, 50HZ, 3-…

A: NOTE: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: 3. A 3-phase 80 km long single circuit 66 kV transposed overhead line has horizontal spacing with 5…

Q: Conductance is always expressed as a real number and comprised the real part of admittance equation.…

A: we need to determine whether given statement is true or not.

Q: In 132 kV transmission system, the phase to ground capacitance is 0.01micro F. The inductance being…

A: A powerful thermionic current that flowed between the electrodes ignited the arc. The resistance of…

Q: An impedance coil having a resistance of 30 ohms and a 50 cps inductive reactance of 33.3 ohms is…

A: In this question, We need to determine the value of capacitance C for the unity power factor. And…

Q: Example 8.11. Each line of a 3-phase system is suspended by a string of 3 indentical insulators of…

Q: Three identical capacitors are connected in Delta to a 415V, 50Hz, 3-phase supply. If the line…

A: For delta connection , phase voltage =Line voltage and phase current=Line current3 Capacitive…

Q: Three identical capacitors of 15 micro farad are connected in delta across a 435 volts, 50Hz, 3-…

A: Given Data: C=15μFV=435Vf=50Hz

Q: A 150 – microfarad capacitor is connected to a 220 – volt, 60 – cycle source. Calculate (a) the…

Q: A single circuit three phase 50 Hz, 55 km transmission line consists of three conductors arranged in…

A: GMD=d1×d2×d33 capacitance=2×π×∈lnGMDr F/m reactance=12×π×total capacitance×frequency

Q: 34. A 200- ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in a parallel…

Q: A three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A 3-phase 50 km long single circuit 66 kV transposed overhead line has horizontal spacing with 3 m…

Q: Three identical capacitors of 25 micro farad are connected in delta across a 420 volts, 50HZ,…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A 127 uf capacitor is connected to a 125V 50 cycle source . Calculate (a) the capacitive reactance…

Q: The conductors of a 66 kV, 50 Hz three phase transmission line are suspended horizontally as shown…

A: Given l=300km r=0.05m spacing =0.2m d=3m

Q: Define Five of the following Heliostats, Primary energy, capacity factor, commercial energ;…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides A=3 m, B=2 m,…

A: In this question we will find capacitance per phase....

Q: Two insulator discs of identical capacitance value C make up a string for a 22 kV, 50 Hz…

Q: In a balanced star connected system, three coils each having resistance 6Ω and inductance 12.58 mH…

Q: Transform 4A to independent voltage source and then determine the voltage drop at 2ohms

A: According to the question, we need to find the voltage drop across 2 Ω resistor by using current…

Q: DISCUSSION: 1. Does the change in amplitude or frequency of supply Voltage affect the performance of…

A: 1) Voltage is defined in basic electric principles as the potential difference that pushes a current…

Q: .A single phase line has two parallel conductors 3m apart. The radius of each conductor is 1cm.…

A: Given r=1 cmd=3 m Calculating capacitance per phase per km C=2πε0εrlndrC=2π×8.8.5×10-12×1ln31×10-2…

Q: SECTION 10 Ss Assessment Student Handouts MODULE 4: INDUCTANCE AND CAPACITANCE Date: Student Name:…

A: Given two capacitance are connected in parallel. Parallel combination of capacitance is: CT=C1+C2

Q: The conductor of a single phase, 60 Hz two wire line is a solid round aluminium wire having a…

A: Given the conductor of a single phase two wire line is a solid round aluminum wire having, Diameter,…

Q: Three identical capacitors of 5 micro farad are connected in star across a 415 volts, 50HZ, 3-phase…

A: Given 3 identical capacitors of 10 micro farad are connected in star connection VS=415 VLL rmsf=50…

Q: An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henry is connected in…

A: Given -: All the resistance, inductance & capacitance are connected in series hence the same…

Q: For a 152 kV, 60 Hz system, the capacitance up to the location of the circuit breaker is 0.020…

Q: A single circuit three phase 50 Hz, 40 km transmission line consists of three conductors arranged in…

A: According to question: a) Deq is calculated as…

Q: 3. For a parallel circuit of 20 ohms resistor and a 10 ohms inductor, is connected to a 110/60 cps…

A: We need to find out current for given circuit

Q: The capacitance of a single phase two-wire transmission line depends on: Select one: O a. All the…

A: Capacitance of a Single Phase Two Wire Line consisting of two parallel conductors A and B spaced d…

Q: Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides A=2 m, B=3 m,…

A: In this question we need to find a capacitance per phase for the given arrangement.

Q: Which the following parameters are considered for analysis of AC distribution system? O a.…

A: In ac we need to analyse active and reactive power consumption by the distribution system, and we…

Q: Three identical capacitors of 10 micro farad are connected in delta across a 415 volts, 50HZ,…

Q: Capacitors draw leading Current that neutralizes the lagging reactive components in the Electrical…

Q: A three phase, 50 Hz, 55 kV overhead line conductors are placed in a horizontal plane as shown in…

A: We will use standerd expression for calculating capacitance per phase per meter. Capacitance per…

Q: A single-phase 60 miles 69kV transmission line consist of two 000-AWG solid copper conductors spaced…

A: According to question: Circuit diagram: The capacitance of the line is calculated as…

Q: Find total impedance, Reactive power, capacitane, power factor and resistive current Given:…

Q: Which of the following statement is wrong for single phase AC distribution system? 1the drop is the…

A: We need to comment which statement for single phase ac distribution system is wrong.

Q: A three-phase overhead transmission line is being supported by three-disc suspension msulators, the…

A: First we will derive relation between voltage across units. Line voltage=3× voltage across string.…

Q: Represents values in rectangular and polar form. Having positive reactance. Having negative…

A: We need to select correct option for given statement

Q: Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running…

A: The following conditions must satisfy while replacing the running capacitors. A. Voltage of the new…

Question

CI 6). Tre dentical capacitor are connected in delta to 430 Volts, = 50 Hz, 3 phase suppy.If th line curent is 10 A. Calculate its eactance and capacitance valué
Reactance Xc is
The capacitance of each capacitor, C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running capacitor? a. 35 microfarad, 330 volt b. 35 microfarad, 390 volt c. 30 microfarad, 440 volt d. 40 microfarad, 370 volt
A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
Consider the line of Problem 4.25. Calculate the capacitive reactance per phase in mi.
Which of the following capacitors or combination of capacitors could be used to replace an 88-microfarad, 250-volt starting capacitor? 180 microfarad, 250 volt 180 microfarad, 330 volt 150 microfarad, 120 volt 150 microfarad, 250 volt
How many degrees are the current and voltage out of phase in a pure capacitive circuit?
Three identical capacitors of 5 micro farad are connected in star across a 430 volts, 50Hz, 3-phase supply. What value of capacitance must be connected in delta to take the same line current and line voltage? Phase current in star Phase current in delta Value of Xc in delta Capacitance in delta
Three identical capacitors are connected in STAR to a 420V, 50Hz 3-phase supply. If the line current is 22A determine the capacitance of each of the capacitors?
Three Identical capacitors are connected in star to 435 volts, F = 50 Hz, 3 phase supply. If the line current is 38 A. Find the following below: Phase Voltage, VP in Volts Phase current, Ip in A Capacitive Reactance, Xc in ohms The capacitance of each capacitor, C in Farad
A series circuit consisting of a 50 – ohm resistor, 0.5 – henry inductor, and a 100 – microfarad capacitor is connected to a 110 – volt, 50 cycle source. Calculate the following: a.) TOTAL IMPEDANCE b.) CURRENT c.) VOLTAGE DROP ACROSS THE RESISTOR d.) VOLTAGE DROP ACROSS THE INDUCTOR e.) VOLTAGE DROP ACROSS THE CAPACITOR f.) AVERAGE POWER g.) APPARENT POWER h.) REACTIVE POWER i.) POWER FACTOR j.) POWER FACTOR ANGLE DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES
Derive and analyse relation of capacitance for 3 core cables.
An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henryis connected in series with a variable capacitor. If a 117 volt 60 cps source isconnected to the circuit, what will be the capacitance of the capacitor and the current(a) when the circuit has a power factor of 0.866 leading and (b) when the voltagedrop across the coil is equal to the voltage drop across the capacitor?
A 150 – microfarad capacitor is connected to a 220 – volt, 60 – cycle source. Calculate (a) the capacitive reactance, (b) the current in the circuit, (c) the average power taken by the capacitor, and (d) the maximum power delivered to the capacitor. DRAW THE PHASOR DIAGRAM IF POSSIBLE. ROUND OFF TO FOUR DECIMAL PLACES