(2) 10' 12' 11' ↓ Pu ↑ Pu H →Þ. 33' ↑ Pu H A992 W 14 x 82 PDL = 2 PLL What is PLL = ? GiveN = Ag = 24.0 in ² √x = 6.05" ry= 2.48

Q: 2. Determine the design strength P of an A992 W18x50 connected by bolts on plates on both flanges as…

A: Answer  From AISC Manual Table 1-1 W shape properties W 18 x 50 ( A = 14.7 in2 , bf = 7.50 in, tw =…

Q: 9. For the three-hinged arch shown, determine the reactions at A and B. The vertical distance…

A:

Q: Question- Highway Materials Bulk sp. Gravity of a bituminous mix is 2.35 and theoretical specific…

A: Given data- Bulk sp. gravity Gb=2.35, Theoretical sp. gravity Gt=2.45, Bitumen content=6%, To Find-…

Q: Write the V and M equation of the beams loaded as shown and the diagram. Then repeat the method…

A:

Q: 10. A quarter-circular plate is pinned at A and rests on a smooth support at B. If the tank and…

A:

Q: The following table presents a historical series of maximum annual rainfall in a hydrographic basin.…

A: Given table which represents a series of maximum annual rainfall in hydrographic basin. Year Max.…

Q: The slope of a bending beam at pin support is: minimum O maximum O zero None of the above

A: This question is related to the Strength of the material from Civil Engineering  This is realated to…

Q: Determine the correct length of a line reduced to the mean sea level when the recorded length with a…

A: Answer  Correct length of a line is given by Correct length = Measured length - Total corrections…

Q: A container of volume 3 x 103 m³ weighs 10 N. Dry sand was poured to fill the container. The…

A:

Q: A compressive load P = 100 kN is applied, as shown in Fig., at a point 70 mm to the left and 30 mm…

A:

Q: Two traffic signals are attached to the 36-ft support cable at equal intervals as shown. Determine…

A: Given, L = 36 ft  w1 = 100 lb w2 = 215 lb

Q: Q4. Determine the joint displacements, support reactions, and member axial forces for the 3D truss…

A:

Q: 2- When the bearing of a line was measured with a compass, it came to be N42°15′W. If the

A:

Q: At an elevation of 22 m and 642 m from the ground surface, the temperature is 23.75°C and 16.25°C…

A: Given data: An elevation of 22 m and 642 m from the ground surface. The temperature is 23.75 oC and…

Q: From the given truss, find the force of member AB, Load 1 = 30 kN, Load 2 = 60 kN Solve this using…

A:

Q: 1- Due to the moving loads, determine maximum moment at C.

A: We have to detemine the maximum moment at point c. So we have,

Q: Question A pile of 0.50 m diameter and of length 10 m is embedded in a deposit of clay. The…

A:

Q: 19. A layered soil is shown in the figure. Given the following: H₁ = 1.5 m k₁= 105 cm/sec H₂ = 2.5 m…

A: Given: H1=1.5m,H2=2.5m, H3=3.0m, K1=10-5 cm/sec, K2=3.0*10-3 cm/sec, K3=3.5*10-5 cm/sec

Q: Solve the problem with complete and neat solution. Draw the figure. Situation 1. Determine the…

A: Given: Required: Support reaction

Q: angular section shown is subjected to a load of 400 kN and is connected to the column with 6-22 mm…

A: Answer  We are given Number of bolt= 6 Bolt diameter = 22 mm Allowable shearing stress = 152 Mpa…

Q: 9.6 For the beam of Problem 8.10, determine the maximum pos- itive and negative shears and the…

A: Given: Concentrated live load= 150KN UDL Live load = 50 KN/m  UDL dead load = 25KN/m  Required:…

Q: A conical funnel has radius 4 cm and height 8 cm. A liquid is draining from the funnel at a constant…

A:

Q: Write the V and M equation of the beams loaded as shown and the diagram. Then repeat the method…

A: Given: Required: Shear and moment equation and diagram

Q: 3(b) The cantilever beam has a constant El along its length. Transverse loading is triangularly…

A: A cantilever beam fixed at one end, subjected to a triangular loading, such that the free has 0 and…

Q: A leaf spring of semi-elliptical type has 11 plates each 9 cm wide and 1.5 cm thick. The length of…

A:

Q: For a broad gauge railway track on a horizontal curve of radius R (in m), find the equilibrium cant…

A:

Q: Example: For the three hinged arch shown in figure below, find the support reactions and axial force…

A:

Q: An annual flood series contains 100 years of flood data. For a return period of 200 years the…

A:

Q: Write the V and M equation of the beams loaded as shown and the diagram. Then repeat the method…

A:

Q: 20 KN 15 m 5 kN/m 25 kN

A:

Q: Express the internal shear and moment in the beam as a function of x and then draw the shear and…

A:

Q: 1. The distance travelled by a vehicle during perception-reaction time is 55.56m. If this vehicle is…

A:

Q: If the radius of a circular curve is 176.25 feet and one full station is 200 feet, what is its…

A: To determine: The value degree of curvature. Given Data: Radius of circular curve=176.25 feet One…

Q: Given the following, solve for the radius of the curve: • E-58.324m • 1-30.549 NOTE: Solution not…

A:

Q: In a railroad layout, the centerline of two parallel tracks are connected with a reversed curve for…

A:

Q: What is the distance required to stop an average passenger car when brakes are applied on a 2%…

A:

Q: Given the following, solve for the length of the curve: R = 884.499m • 1 = 47° NOTE: Solution not…

A:

Q: Problem 5 Given the deflection angle of a 6-side closed traversed. Find the Bearings of each course…

A:

Q: 3. From constant head permeability test on fine sand, the following Length of sample = 16 cm…

A:

Q: 26. Refer to Figure 8 Design 1A attached. For the design of a 4-lane interstate highway, the damage…

A:

Q: Write the V and M equation of the beams loaded as shown and the diagram. Then repeat the method…

A: Given:   A determinate continuous beam  Required: Sheat and moment equation and also use area method…

Q: 4. Estimate the profile of vertical effective stresses for Zw= 100m and for Zw=3000m. Compare…

A:

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A:

Q: Which of the following statements is true? O Engineers do not need to worry about the sustainability…

A: Sustainable development- Development that is sustainable is one that satisfies current needs without…

Q: 5. Pumping test was carried out in a layer of soil extending to a depth of 28 m. The initial…

A:

Q: A conical funnel has radius 4 cm and height 8 cm. A liquid is draining from the funnel at a constant…

A: Solution is attached below as

Q: R AH 8Bject and a plane of reflection are shown on the left below. Select the reflected image from…

A:

Q: Given the following, solve for the middle ordinate: • D = 5° 1 = 40.038° NOTE: Solution not required

A:

Q: 2. 3. An object and a plane of reflection are shown on the left below. Select the reflected image…

A: In above question , only by visual inspection we can find the answer . In above problem reflected…

Q: The difference of water level between the upstream and downstream side of sheet pile of length 9 m…

A:

Measuring carpentry and miscellaneous items

The modification of planning and drawing of the construction project into the various descriptions and quantities to estimate the value, cost, and price of the project is known as measurement. The quantity supervisor produces the details of the quantities to the contractor or subcontractor to measure the cost of the work and determine the profit of the contractor or subcontractor. The measurement of the construction work depends on its type, usage, and stages in the project. In the early stage of the project, the details of the project depend on the general parameters. As the work starts, more information is searched and the details are dependent on the elemental estimates of the work.