Complete the following statement: The sum of the magnitudes of the currents directed into a junction equals the sum of the magnitudes of the currents directed out of the junction. O equals the current that is directed along one of the lines out of the junction. O is divided equally among the number of lines directed out of the junction. O is greater than the total current directed out of the junction. O is less than the total current directed out of the junction.

Complete the following statement: The sum of the magnitudes of the currents directed into a junction equals the sum of the magnitudes of the currents directed out of the junction. O equals the current that is directed along one of the lines out of the junction. O is divided equally among the number of lines directed out of the junction. O is greater than the total current directed out of the junction. O is less than the total current directed out of the junction.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter21: Current And Direct Current Circuits

Section: Chapter Questions

Problem 16P

See similar textbooks

Similar questions

Residential building codes typically require the use of 12-gauge copper wire (diameter 0.205 cm) for wiring receptacles. Such circuits carry currents as large as 20.0 A. If a wire of smaller diameter (with a higher gauge number) carried that much current, the wire could rise to a high temperature and cause a fire. (a) Calculate the rate at which internal energy is produced in 1.00 m of 12-gauge copper wire carrying 20.0 A. (b) Repeat the calculation for a 12-gauge aluminum wire. (c) Explain whether a 12-gauge aluminum wire would be as safe as a copper wire.
The potential difference across the filament of a light-bulb is maintained at a constant value while equilibrium temperature is being reached. The steady-state current in the bulb is only one-tenth of the current drawn by the bulb when it is first turned on. If the temperature coefficient of resistivity for the bulb at 20.0C is 0.004 50 (C)-1 and the resistance increases linearly with increasing temperature, what is the final operating temperature of the filament?
Consider a square rod of material with sides of length L = 3.00 cm with a current density of J=J0eaxk=(0.35Am2)e(2.1103m1)xk as shown below. Find the current that passes through the face of the rod.
A conductor carries a current that is decreasing exponentially with time. The current is modeled as I=I0et/ , where I0= 3.00 A is the current at timet = 0.00 s and =0.50 s is the time constant. How much charge flows through the conductor between t = 0.00 s and =3 ?
While taking photographs in Death Valley on a day when the temperature is 58.0C, Bill Hiker finds that a certain voltage applied to a copper wire produces a current of 1.000 A. Bill then travels to Antarctica and applies the same voltage to the same wire. What current does he register there if the temperature is 88.0C? Assume that no change occurs in the wires shape and size.
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
Consider positive and negative charges all moving horizontally with the same speed through the four regions in Figure 17.2. Rank the magnitudes of the currents in these four regions from lowest to highest. (Ia is the current in Figure 17.2a, Ib the current in Figure 17.2b, etc.) (a) Id, Ia, Ic, Ib (b) Ia, Ic, Ib, Id (c) Ic, Ia, Id, Ib (d) Id, Ib, Ic, Ia (e) Ia, Ib, Ic, Id (f) None of these Figure 17.2 (Quick Quiz 17.1)
The batteries of a submerged non-nuclear submarine supply 1000 A at full speed ahead. How long does it take to move Avogadro’s number (6.02 1023) of electrons at this rate?
Calculate the drift velocity (in m/s) of electrons in a 15 gauge silver wire (which has a diameter of 1.449 mm) carrying an 18.4 A current, given that there is one free electron per silver atom. The density of silver is 1.05 ✕ 104 kg/m3. (Indicate the direction with the sign of your answer.) m/s
A 22 gauge aluminum wire is connected in series to a 30 gauge copper wire. Each of the wires is 0.75 m long. A current of 0.300 A flows through the wires. The number density of charges in aluminum is 2.1 × 1029 m−3 and in copper it is 1.1 × 1029 m−3. The charge associated with each charge is equal to the electron’s charge (though it is really a hole in Aluminum, and so positive in that case...) The gauges given in the problem refer to the American Wire Gauge Standard. You will need to look up the diameter of each of the specified gauges (charts of gauge specifications are all over the web and also on our PHY 205 Moodle page.) Other data that you need for this problem can be found in tables in your text. (a) Find the current density in each wire. (b) Find the drift speed of the electrons in each wire. (c) What is the voltage across each wire? (d) Explain how it is that copper, which has a lower density of conduction electrons than aluminum, can have a higher conductivity than aluminum.
A 14-gauge copper wire has a diameter of 1.628 mm. What magnitude current flows when the drift velocity is 1.00 mm/s? (See below example for useful information.) Calculate the drift velocity of electrons in a 12-gauge copper wire (which has a diameter of 2.053 mm) carrying a 20.0-A current, given that there is one free electron per copper atom. (Household wiring often contains 12-gauge copper wire, and the maximum current allowed in such wire is usually 20 A.) The density of copper is 8.80 x 103 kg/m3 .