Answered: Compute the power generated by a hydro…

Compute the power generated by a hydro power plant with 1,980 hr/s flow rate of water and if the head net is equal to 72.45% and efficiency 82.15%? A) 10.36 KW B) 11.56 KW c) 12.75 KW D) 14.82 KW

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 3. Determine the torsion on the rigid supports and the maximum shearing stress developed in each…

Q: Determine the largest allowable value of P if the bending stress for simply supported beam (shown in…

Q: When combusting octane (C8H18) with air, what is the main reactant within the air mixture? O Methane…

A: What is the main reactant in combustion of octane with air.

Q: A given power plant has the following data: 3.5MW average load 1,500 residence P10.20 kw-hr 67,500…

A: ◆ The maximum demand is 49,950 kW•hr. ◆ Therefore, the correct answer is option (C).

Q: If , m = 0.5 kg, b = 0.8 m, and h = (1 + 1/10)m, and if the velocity of the %3D collar as it strikes…

Q: A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty…

Q: A machine working on a Carnot cycle operates between -13°C and 32°C. Determine the C.O.P. when it is…

A: INTRODUCTION : The refrigerator and heat pump both are working under the Clausius statement which…

Q: For the beam with shown loading, show that the equation of the elastic curve is Wo 7w,L3 + x3 y = EI…

Q: A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty…

A: what is 3a) and 3b) is not mentioned hence solving only 1st part Given : m=150 lbm/min=2.5…

Q: The n ve. f graph below is for a newly discovered material. Please note that the metric prefie…

A: 1)The pure solid substance will be absorbing heat from 140 oC to 160 oC. Here phase change does not…

Q: A power plant operating on a Rankine cycle has steam entering the turbine at 500 °C and 2 MPa. The…

A: Given data Conditions of steam entering the turbine = 500° C and 2 MPaTurbine efficiency = 85%Pump…

Q: 41. Find the average value of the periodic waveform of Fig. 94 over one full cycle.

Q: flywheel described in part (a) (r1 = 0.55 m, mass m1 = 16 kg, v = 45 m/s at the rim) is spinning…

Q: A geothermal power plant was installed at the rear side cliff of Mayon Terrain that generates…

Q: at is the angle of incidence of the radio wave signal as it moves from air to glass (relative…

A: The angle of incidence of radio wave (I) = 600 Critical electron density (NCR.) = 60X109/cm3 =…

Q: An ideal reheat rankine cycle is characterized by a steam generator pressure of 11 MPa and a…

Q: 2. The hollow shaft used in A the system has the following conditions: В E Outer Ø: 110 mm Ø…

A: Given data Outer diameter of shaft = 110 mm = 0.11 m Allowable shearing stress = 85 MPa

Q: A certain toy “helicopter” or “whirlybird” consists simply of a propeller attached to a shaft that…

A: Given : Length - L Mass - m Angular speed - ω0 Moment of Inertia - 112mL2 To find : (a) Based on…

Q: A circular aluminum tube of L=600mm is loaded in by compressive forces at its ends. The outside and…

A: Answer: (a) The load P is 74.1353 kN. (b) The shortening of the tube is -0.4686 mm and the percent…

Q: Consider a mass-and-spring system containing two masses m, = 1 and m2 = 1 whose displacement…

Q: Q2:- Find the natural frequency and the steady state amplitude of vibration for the system shown in…

Q: lateral displacement equation in each segment using coordinates x1 and x2 shown. EI The member is…

Q: Find the coordinates of the centroid (to the nearest 0.01 in.) of the uniform flat-plate machine…

Q: 1.calculate the tension in each cable if the tension is in equilibrium 2.calculate the combined…

A: Fttgg

Q: working principles of the AM-3DP

A: FDM's solid-based 3DP technology works in a similar way as SL in that it creates models layer by…

Q: A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty…

Q: 1. Calculate the work done by gravity as a 3.2 kg object is moved from point A to point B in the…

A: Given data mass of object = 3.2 kg The paths given are: 1,2 and 3. [ Note : According to…

Q: For the beam with shown loading, determine the deflection at C when E = 200 GPa,I = 26.9 × 106 mm*.

Q: The double pulley consists of two parts that are attached to one another. It has a weight of 31 lb…

Q: A Kaplan turbine develops 1500 kW under a head of 6 m. The turbine is set 2.7 m above the tailrace…

Q: upper face of a rectangular block is .5mx.5m The lower face is fixed. The height of the block is…

A: Given, l = 0.5 m, b= 0.5m & h= 1 cm = 0.01 m Displacement ∆ = 0.015 mm Modulus of rigidity, G=…

Q: A an airship executes a velocity vector roll at a rate of 10 deg/s while flying at 10 m/s and an…

A: Given, at the instant shown: The potential energy due to gravity, PE = 36 J; The kinetic energy, KE…

Q: Find the motor size needed to provide the forced draft service to a boiler that burns coal at the…

Q: Consider a two-degrees of-treedom system shown below What is the amplitude of vibration of mass 2 at…

A: Solution: Given Data: To Find: Amplitude of vibration of 2nd mass.

Q: 9.5 Determine the value of the critical speed of rotation for the outboard motor shaft loaded as…

Q: All of the rotated axes shown pass through the origin and only one of them is principal. Identify…

A: Answer: Major principal axis - O

Q: Air enters through a duct of a fan with a velocity of 4m/s and an inlet pressure of 2cm of water…

A: Calculate the total head. h=Pd-Pssρg+vd2-vs22g Here, Pd is the discharge pressure, Ps is the suction…

Q: Instructions: Identify the wheel cylinder parts in the drawing. Place the identifying letter next to…

A: Cup - C Cylinder - D Piston - B

Q: A pitot tube directed into a water stream having velocity 2,3 m/sec. Its gauge difference of 30 cm…

A: Pitot tube is used to measure the velocity of flowing fluid in a pipe/tube. When pitot tube is…

Q: If a gas is governed by the equation of state: RT a P = V – b T²v Where a, b, and R are constants:…

Q: p is equal to

A: Given: The maximum shear strain in the rod is p×10-3, then p is equal ?Where, Cylindrical rod of…

Q: is necessary to start the system of blocks moving to the right? The coefficient of friction is 0.10…

Q: If the viscosity of water at 70 °C is 0.0042 poise and its specific gravity is 0.97, determine its…

Q: Seaside wind power generates total power of 418 KW with 12 wind turbine installed, what is the…

Q: The ASME evaporation units of a boiler is 24,837,500 KJ/hr. The boiler auxiliary consumes 1.5MW.…

Q: A horizontal tension member is to be constructed of two pieces of plastic glued along the incline pq…

Q: To mixer design, estimate the power requirement (kw/m³), agitation type for homogenous reaction…

Q: Find the diameter of a pipe of length 6 km when rate of flow of water through the pipe is 250…

A: When the rate of water flow through the pipe is 250 litres per second and the head loss due to…

Q: A simplified heat utilization system of a Geothermal Power Plant provides the following data: Mass…

Q: A STAR WHEEL ADJUSTER RETURN SPRINGS ANCHOR PLATE E ANCHOR PIN PLATE SPRING SPRING STAR WHEEL…

A: Backing plate - C Shoe - D Wheel cylinder - A

Question

Compute the power generated by a hydro power plant with 1,980 hr/s flow rate of water and if the head net is equal to 72.45% and
efficiency 82.15%?
A) 10.36 KW
B) 11.56 KW
c) 12.75 KW
D) 14.82 KW

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A man pays P 114,100 every end of the quarter for a car bought on installment terms. If the man wishes to pay every end of the month instead of every end of the quarter, how much should he pay if the interest is 12% compounded monthly? pls answer 10 mins deadline
engineering economy 2.) What is the accumulated value of a payment of P12,500.00 at the end of each year for 9 years with interest at 5% compounded annually?
The farmer wanted to know the number of hills per hectare in his rice production, if row is 15 cm apart and the hills is 15 cm apart.
Ellen borrowed P100,000 from a local bank at 10% annually. She must pay back the loan in five years with uniform payments due on the first day of each month. How much is her monthly payment?
A retail flower shop in Metro Manila, called Floreau, sel ls arranged flowers. The shop can make beautiful arrangem ents that consists of 12 flowers for a cost of P1,800. Thi e cost of materials of each bouquet is P2,500. and other cost is P650. The shop has a fixed cost of P6900 includin g the rents and miscellaneous. If a bouquet costs P69,00 0, how many pieces of flowers must be sold to break even?
A man has deposited ₱50 000 in a retirement income plan with a local bank. This bank pays 8.75 % per year, compounded annually, on such deposits. What is the maximum amount the man can withdraw at the end of each year and still have the funds last for 12 years?
Deposited P110,000 for 31 days. The net interest after deducting 20% withholding tax is P 795.67. Find the rate of return annually.
Determine the principal remaining after 38 monthly payments have been made for a 5-yearloan of P40,000? Rate of interest is 8% compounded quarterly. Show the cash flow diagram and complete solution Subject : Engineering Economy
The maintenance cost for a new heavy-duty diesel engine is P20,000 two years after its purchase, P40,000 at the end of the fourth year and P80,000 at the end of the eighth year. Determine the semi-annual maintenance cost if money is worth 10% compounded annually Please show the cash flow diagram.Thank you very much
The will of a wealthy family philantrophist left P5,000,000 to establish a perpetual charitable foundation.The foundation trustees decided to spend P1,200,000 to provide facilities immediately and to provide P100,000 of capital replacement at the end of each 5 year period.If the invested funds earned 12% per annum what would be the year end amount available in perpetuity from the endowment for charitable purposes ?
Electricity generated from the system is a saving, as this amount of electricity is not going to be purchased from the utility company (or, if it’s a grid-connected system, electricity can be sold back to the utility company). How do you compute the annual dollar amount of the saving? Do the panels decline in efficiency each year?
A house has an area of 195 m^2. What is its area in: dm^2