DC Power Supply = 20 VR1 = 10 ohmsR2 = 25 ohmsR3 = 125 ohms Computed (Show complete solutions.)1. Using the value of the DC power supply as the theoretical value of the total voltage, computeand record the total current and the currents flowing in each resistor using Ohm's Law.2. Calculate the summation of the currents flowing in each resistor and compare with the totalcurrent.MeasuredComputedTotalTable 3.2 Data and ResultsVoltageR₁R₂R₁TotalCurrentR₁R₂R3 Parallel CircuitMeasured (Provide all necessary pictures/screenshots from the software.)1. Connect three resistors in parallel across DC power supply.2. Measure and record total voltage, voltages across each resistor, total current, and currentsflowing in each resistor.3. Calculate the summation of the currents flowing in each resistor and compare with the totalcurrent.4. Explain the values of the voltages across each resistor

Given DC Power Supply(Vs) = 20 V R1 = 10 ohms R2 = 25 ohms R3 = 125 ohms All the resistors are…

Computed (Show complete solutions.) 1. Using the value of the DC power supply as the theoretical value of the total voltage, compute and record the total current and the currents flowing in each resistor using Ohm's Law. 2. Calculate the summation of the currents flowing in each resistor and compare with the total current. Measured Computed Total Table 3.2 Data and Results R₂ Voltage R₁ R₂ Total Current R₁ R₂ R₂

Computed (Show complete solutions.) 1. Using the value of the DC power supply as the theoretical value of the total voltage, compute and record the total current and the currents flowing in each resistor using Ohm's Law. 2. Calculate the summation of the currents flowing in each resistor and compare with the total current. Measured Computed Total Table 3.2 Data and Results R₂ Voltage R₁ R₂ Total Current R₁ R₂ R₂

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter19: Special-purpose Outlets-water Pump, Water Heater

Section19.2: Water Heater Branch Circuit

Problem 16R

See similar textbooks

Similar questions

Discuss the types of oil circuit breakers. Please write more answer
A housing estate is being built and the electrical system for each house from a range of 2 to 20-bedroom houses from single floor apartments to 3 storey buildings are on offer throughout the estate. There are commercial buildings to be constructed for shopping purposes as well. What risks exist and what are the components and methods we use to mitigate these risks both at the substation and at the consumer/ residential side. Describe how these would all fit together.
Please answer the following questions Describe how solar chimney power plant operates. Give into details how solar water heater and solar oven operate Please answer all the questions
How does the amount of leaking electricity consumption compare with the total amount of electricity used in your household? Can you think of ways to reduce the leaking (stand-by) electricity use?
a. What circuit supplies the workshop lighting? ________________ b. What circuit supplies the plug-in strip over the workbench? ________________ c. What circuit supplies the freezer receptacle? ________________
What is the total current consumption of the track lighting and recessed luminaires above the fireplace? Show your calculations.
True or False: A heating and air-conditioning service technician can usually troubleshoot heating and air-conditioning systems without the voltage being supplied to the equipment.
Describe the principles of power system protection and the various protective devices used.
Can you finish the Background including a synopsis of the relevant information of this this example "electrical maintenance and repair" And please cite an article or paraphrase of author. Thank you! The electrical wiring and electrical devices in the houses that are installed may have failure so the inspection is designed to definitely perform the clear capabilities. These electrical devices are...
Part 2: Analysis and selection of the Wind Turbine.The team decides at install a 30 MW wind farm. The turbine that has been selected by the local contractor is an Enercon wind turbine. The specifications of all the available Enercon wind turbine is shown in the attached datasheet. 1. What are the two closed loop control systems that are used generally in wind turbines? How do they work? 2. Calculate the power density of the input power from the wind when the wind is blowing at the rated wind speed at the turbine height. Clearly show your steps in details.
Explain how to do a continuity check on an electrical appliance plug. Explain how to test for circuit capacity.
List and describe the different types of lighting classes available on the market. Discuss the different types of lights available for these classifications, say 5 key types of light bulb/ fitting per class. In addition, what types of lighting would be used in long car tunnels in comparison to a set of offices, or even streetlights? What factors would dictate the type of light used in each scenario? For the lights you think are most suitable for a tunnel and streetlight, discuss the construction of such lights and what materials need to be considered to make them suitable for their intended use.