Answered: Confirm that the units nRT of are those…

Confirm that the units nRT of are those of energy for each value of R : (a) 8.31 J/mol.K, (b) 1.99 cal/mol.K, and (c) 0.0821 L. atm/mol).K.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 64P: Consider 0.40 mol of dilute carbon dioxide at a pressure of 0.50 atm and a volume of 50 L. What is...

See similar textbooks

Related questions

Q: What thickness of (a) concrete, (b) brick wood have the same insulating ability as 10 cm of glass…

A: Since the rate of heat transfer is proportional to the temperature difference and the area and…

Q: How much work in Joules is required to compress 7 moles of air (y =1.4) at 27°C and 1 atm to 1/3 of…

Q: / Mixture of a hydrocarbon gas has (g = 0.718). Assuming a real gas behavior, %3D determine the…

A: The isothermal gas compressibility is defined as α =-1V∂V∂PT where P is pressure, V is volume, T is…

Q: A bicyclist consumes 9.0 L of water over the span of 3.5 hoursduring a race. Making the…

A: Given, Mass of water, mH2O=9.0 L And, here latent heat of vaporization at room temperature, Lv=585…

Q: When can we use the ideal-gas equation, PV = nRT?

A: The combination of the three laws namely Boyle's law, Charles law, and Avogadro's law give the ideal…

Q: Answer the following. (a) How much energy is necessary to heat 1.5 kg of water from room…

A: (a) The specific heat of water = 4218 J/kgK The boiling point of the water is 100 degree C Calculate…

Q: 11AP.O63. A ber of gold (her 4) is in thermal contact with aber of iron (ber ) of the same lengh and…

Q: (I) Solar cells (Fig. 15–26) can produce about 40 W of elec- tricity per square meter of surface…

A: Given: The electricity produced is 40 W. The requirement is 24 kWh/day.

Q: Answer the following. (a) How much energy is necessary to heat 7.5 kg of water from room…

A: (a) The amount of energy required to raise the temperature of mass m by ∆T is; Q=mS∆T Here, S is…

Q: Compute Cp and Cv for a diatomic gas with a molar mass 28.02 kg/kmol, at a temperature 0oC

Q: for 0.0061 moes of The Figure s hows a pV-dagram an ideal gas that undergoes Ehe process from state…

A: no. Of mole of gas (n) = 0.0061 Value of gas constant (R) =0.08206 L.ATM/mol.k Part 1 From ideal gas…

Q: How much lead can 500 J of energy heat by 20 degrees C?

A: Given: Heat energy given to lead, ∆Q = 500 J Rise in temperature of the lead, ∆T = 200C To Find:…

Q: dvestier number-t A gold mueDcoon (vradivrr) is represented y the gm "A. Takng as the premitiot, a…

A: The answer is given below

Q: How much energy (in J) is required to evaporate 25% of 4g of water currently at 100 degrees C? The…

Q: Some incandescent light bulbs are filled with argon gas. What is vrms (in m/s) for argon atoms near…

A: Given data: Temperature (T) = 2900 K

Q: next 5 questions are inter-related. A jet fighter is flying at 40.000 ft at M-0.9. The intet pres is…

A: Height, h = 40000 ft M = 0.9 Inlet pressure, P = 2.73 psia Temperature, T = -69.7° F

Q: Geothermal steam at 172°C condenses in the shell side of a heat exchanger over the tubes through…

A: Given,temperature of the steam, Ts = 172 °Cdiamete of the tube, d = 4 cmlength, L = 9.5 mtemperature…

Q: The heating element of a 1200 Watt electric stove can reach temperatures of 860 °C when turned all…

Q: 3. In dealing with PV work, the P in PAV always refer to the external pressure- the pressure that…

A: As there is not mentioned to which question should be answered therefore according to Bartleby…

Q: Isotherm Adiabat V (em) O 1000 2000 3000 2 mol of nitrogen gas follow the two proce ow much heat is…

A: Solution:

Q: Confirm that the units of nRT are those of energy for each value of R : (a) 8.31 J/mol ⋅ K , (b)…

Q: 20. . Show that 1.00 mol of ideal gas under STP occupies final 20. *. a volume of 0.0224 m³ = 22.4…

A: Given, Number of moles of ideal gas, n = 1.00 mol Under Standard temperature pressure condition,…

Q: A walrus transfers energy by conduction through its blubber at the rate of 150 W when immersed in…

A: The rate of heat conduction is given by P=Qt=kA∆Td Rearranging the equation gives d=kA∆TP

Q: A, B end C ere int s st rest. MA = 7hq. Mg=3ke, Me=9 kp. Determne the accelerotuan %3D of moss B,…

Q: Q1/ In a process, we need to decrease the temperature of 5 mol/hr of methane from 673.15 K to 432.56…

Q: The brass bar and the aluminum bar in the drawing are each attached to an immovabl wall. At 24.2 °C…

A: GivenTemperature, T=24.2°CThe air gap between the rods, L=1.29×10-3 m

Q: Find v* for N2 gas in air (a) on a cold day at T = 15°C and (b) on a hot day at T = 35°C.

A: Given- N2 gas in air, Mass of N2 gas is- 1 amu = 1.67377 x 10 -27 Kg Mass of N is 14.00674 amu Mass…

Q: 5. 10 moles of ideal gas initially at 10 atm and 250 K is expanded isother- ally and reversibly to a…

A: In isothermal process temperature remains constant. It follows Boyle's law.

Q: A 1.82 m wide by 1.11 m high metal plate must be insulated to prevent contact burn injuries. If the…

Q: For the water heater in the previous question, how muc does it cost to run t month? Assume a month…

A: GivenPower, P=4500 WTime, t=2 hrs/dayV=220 VCost of electricity=$0.21 /kW-hr

Q: The pressure in solid copper of mass 100 kg is increased quasi-statically and isothermically at 0°C…

Q: Answer the following. (a) How much energy is necessary to heat 8.0 kg of water from room temperature…

A: Given that quantity of water is 8 kg room temperature is 20degree celsius rate of cost 54$ kWh we…

Q: A monatomic ideal gas is held in a thermally insulated containerwith a volume of 0.0750 m3. The…

A: Initial volume, V = 0.075 m3 initial pressure, P = 101 kPa final pressure, P' = 145 kPa…

Q: Would you be willing to financially back an inventor who is marketing a device that she claims has…

Q: 10) The figure shows a pV diagram for 0.0061 mol of ideal gas that undergoes the process 1-2-3. What…

A: From given diagram - T2 = 2926 K V2 = 300 cm3 = 300 × 10-3 L And also give that, n = 0.0061 mol…

Q: How much work in kJ is necessary to compress air in an insulated cylinder from 0.215 m to 0.035 m?…

A: To solve this we generally make a few necessary assumptions. They are: The gas is ideal gas It is…

Q: An inventor claims to have invented an adiabaticsteady-flow device with a single inlet–outlet that…

A: For this case, the pressure ratio and the coefficient k value get from the table A-2. The final…

Q: How much work in Joules is required to compress 7 moles of air (y =1.4) at 20°C and 1 atm to 1/7 of…

Question

Confirm that the units nRT of are those of energy for each value of R : (a) 8.31 J/mol.K, (b) 1.99 cal/mol.K, and (c) 0.0821 L. atm/mol).K.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An infrared heater for a sauna has a surface area of 0.050 m2 and an emissivity of 0.84. What temperature must it run at if the required power is 360 W? Neglect the temperature of the environment.
(a) If the partial pressure of water vapor is 8.05 torr, what is the dew point? (760 torr = I atm 101, 325 Pa) (b) On a warn day when the air temperature is 35 and the dew point is 25 , what are the partial of the water in the air and the relative humidity?
One process for decaffeinating coffee uses carbon dioxide ( M=44.0 g/mol) at a molar density of about 14,0 mol/m3 and a temperature of about 60 . (a) Is CO2 a solid, liquid, gas, or supercritical fluid under those conditions? (b) The van der Waals constants for carbon dioxide are a=0.3658 Pa m6/mol2 and b=4.286105 m3/mol. Using the van der Waals equation, estimate pressure of CO2 at that temperature and density. `
Consider 0.40 mol of dilute carbon dioxide at a pressure of 0.50 atm and a volume of 50 L. What is the internal energy of the gas?
Under what circumstances would you expect a gas to behave significantly differently than predicted by the ideal gas law?
A 100-g piece of copper, initially at 95.0C, is dropped into 200 g of water contained in a 280-g aluminum can; the water and can are initially at 15.0C. What is the final temperature of the system? (Specific heats of copper and aluminum are 0.092 and 0.215 cal/g C. respectively.) (a) 16C (b) 18C (c) 24C (d) 26C (e) none of those answers
A certain steel railroad rails 13 yd in length and weighs 70.0 lb/yd How much thermal energy is required to increase the length of such a rail by 3.0 mm? .Note: Assume the steel has the same specific heal as iron.
A car tile contains 0.0380 m3 of air at a pressure of 2.20105 Pa (about 32 psi). How much more internal energy does this gas have than the same volume has at zero gauge pressure (which is equivalent to normal atmospheric pressure)?
In an ultrahigh vacuum system (with typical pressures lower than 10-7 pascal), the pressure is measured to be 1.00 1010 torr (where 1 torr = 133 Pa). Assuming the temperature is 300 K, find the number of molecules in a volume of 1.00 m3.
A construction worker uses a steel tape to measure the length of an aluminum support column. If the measured length is 18.700 m when the temperature is 21.2C, what is the measured length when the temperature rises to 29.4C? Note: Dont neglect the expansion of the tape.
Can carbon dioxide be liquefied at room temperature (20 If so, how? If not, why not? (See the phase diagram in the preceding problem.)
The excess internal energy of metabolism is exhausted through a variety of channels, such as through radiation and evaporation of perspiration. Consider another pathway for energy loss: moisture in exhaled breath. Suppose you breathe out 22.0 breaths per minute, each with a volume of 0.600 L. Suppose also that you inhale dry air and exhale air at 37C containing water vapor with a vapor pressure of 3.20 kPa. The vapor comes from the evaporation of liquid water in your body. Model the water vapor as an ideal gas. Assume its latent heat of evaporation at 37C is the same as its heat of vaporization at 100.C. Calculate the rate at which you lose energy by exhaling humid air.