Consider a Lapple conventional cyclone with an inlet height of 1 m and width of 0.5 m. Standard air (viscosity = 0.0011 kg/m-min) flows into the cyclone at 600 m3/min. The PM in the airstream has a density of 1100 kg/ms. The cyclone cut diameter, in pm, is most nearly:a. 10 pmb. 13 pmc. 16 pm d. 20 pm

Q: Two tanks A and B have 80 m difference in water levels, and are connected by a pipe 0.3 m diameter…

A: Friction factor f = 4F = 4×.002 = .008 Total inflow = Total net flow at junction CQ1 = Q2 + Q3Q1 =…

Q: I A pump impeller is 37.5 cm in diama and discharges water with velocity components of 2 m/s and 12…

A:

Q: 1. Water at 41 "C flows through an inclined plane. Determine the velocity and direction of the flow…

A:

Q: Q.47 In order that a droplet of water at 20°C (o = 0.0728 N/m) has an internal pressure 1 KPa…

A: Given data- Water droplet-surface tension σ=0.0728 N/mdifference in pressure intenal and…

Q: A 50 mm diameter circular sharp-edged orifice at the side of a tank discharges water under a head of…

A: Given: The diameter of the orifice is 50 mm. The head is 3 m. The coefficient of contraction Cc is…

Q: For a fully developed laminar flow of water (dynamic viscosity 0.001 Pa-s) through a pipe of radius…

A: Given data- fully developed laminar flow-dynamic viscosity μ=0.001 Pa-sradius of pipe R=5 cm=0.05…

Q: Q5) Flow net in Fig.(1), pressure head h, at point A and B are (18.5,15.5) m respectively, find the…

A: Equipotential line:  The equipotential line is the line joining points of equal total head. The…

Q: Air flows in a 3cm smooth tube at a rate of 0.015m^3/s. If T=20 degrees C and p=110kPa absolute,…

A: Given :

Q: Water flow in a pipe of diameter 600mm having a length of 2200 m at a velocity of 2m/s. At the end…

A:

Q: A 1.2 m diameter pipe, 700 m long has a celerity of the pressure wave which is 950 m/sec. The flow…

A:

Q: For a fully developed laminar flow of water (dynamic viscosity 0.001 Pa-s) through a pipe of radius…

A: Given data- dynamic viscosity μ=0.001 Pa-sRadius R=5 cmpressure gradient ∂P∂x=-10 Pa/mradial…

Q: A fluid of dynamic viscosity 2×10^-5 kg/ms and density 1 kg/ m² flows with an average uvelocity of 1…

A:

Q: Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe…

A:

Q: 23. The ratio of the momentum correction factor to the energy correction factor for a laminar flow…

A: given- Laminar flowpipe flow

Q: For a two-dimensional viscous dominated flow between two parallel plates, distance 0.9 m apart,…

A:

Q: m³ 3 S Water flows at a rate of 0.035 in a horizontal pipe whose diameter is reduced from 15cm to…

A:

Q: Consider a flow of SAE 30W oil through a 3-cm-diameter pipe. For SAE 30W of take p=891kg/m³.0.29…

A:

Q: Q1: Water flows over a dam spillway at a rate of 4m /s as shown. If both the lake and spillway have…

A: Given data- Discharge , Q = 4 m3/s h0= 5.11 m b = 4.99 m Head loss, h' =0.2 ho = 0.2 * 5.11 =1.022 m…

Q: Consider flow from a water reservoir through a circular hole of diameter D = 0.16m at the sidewall…

A: Given data Diameter of hole D = 0.16m Vertical distance of sidewall from free surface = H = z1…

Q: A pipe carrying oil (5G = 0.877) change in size from 150mm diameter in point 1 to 450mm diameter in…

A: Given data,  Oil SG = 0.877 Diameter of pipe in section 1 = 150 mm Diameter of pipe in section 2 =…

Q: The velocity components in the x and y directions for an incompressible flow are given as u = (-5 +…

A: Given:  velocity component in x direction= u= -5+6x Velocity component in Y direction = v= -(9+6y)…

Q: Two tanks A and B have 80 m difforence in water levels, and are connected by a pipe 0.3 m diameter…

A: area    A=π4×d2=π4×0.32=0.07065 m2and friction loss for first half pipe length  hf1=8fQ12L2π2gD5and…

Q: A 1m diameter hemispherical bowl is full of seawater. It is rotated about its vertical axis at a…

A: Given, N= 30 rpm Diameter= 1 m height of hemisphere = r = 0.5 m

Q: Figure 8-24 shows a pump drawing water from a reservoir and discharging it into the air at point B.…

A: Pressure at point A, pA=10 in Hg (vacuum) Pressure at point B, pB=0 (discharging into atmosphere)…

Q: The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air at this…

A: Part a. Following is the formula for drag force     FD =12CfρAV2   →eq(1)calculate density of air as…

Q: A fluid of specific gravity 0.8 and dynamic viscosity 15 x 10-Pa s is flowing in a 15mm diameter…

A: Given that specific gravity of fluid is 0.8 Dynamic viscosity of fluid is 15×10-4Pa.s Diameter of…

Q: A reservoir contains water has a vertical circular orifice 25.2mm diameter and is first plugged up…

A: Given : H = 2.785m QL = 141 lt/min = 2.35 × 10-3 m3/sec   Cc, Cv, and Cd are the hydraulic…

Q: The ratio of the momentum correction factor to the energy correction factor for a laminar flow in a…

A: Given- Laminar flown pipe It is needed to find the ratio of kinetic energy correction factor &…

Q: Compute the pressure drop in kPa per km of a horizontal 600  mm  diam.  steel  pipe  carrying  450…

A:

Q: Air flows steadily along a streamline from point (1) to point (2) with negligible viscous effects.…

A: condition At point 2:  at point 2 velocity of floe is zero so point 2 is situated in a large area…

Q: A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev.…

A:

Q: Refer to the trapezoidal channel as shown in the figure. When the depth of water is 1m, the flow is…

A:

Q: Air of M =2 and P = 75 kPa flow on a wedge (total angle 20°). Calculate the two oblique shock angles…

A:

Q: The velocity profile for the steady laminar flow of water through a 0.4-m-diameter pipe is defined…

A: IT IS GIVEN THAT -

Q: Orifice under a constant head of 1.3m issues a jet which hits a point 5 m below the centerline of…

A:

Q: For a fully developed flow of water in a pipe having diameter 10 cm, velocity 0.1 m/s and kinematic…

A: Given data- Diameter of pipe D=10 cm=0.10 mVelocity of flow V=0.1 m/sKinematic viscosity v=10-5…

Q: s [p15. The velocity of the water jet discharging from the orifice can be obtained from v = V2 gh,…

A:

Q: A closed cylindrical tank 1.845m high and 0.945m in diameter contains water of height 1.35m. When…

A:

Q: Q.2.A.The closed tank in figure is at (20°c) (specific weight of air =0.0118 kN/m³). If the pressure…

A:

Q: A 50 mm diameter siphon discharges water from a reservoir (Point 1 elev = 20m) into open air (Point…

A: To find :- Velocity in the siphon in m/s

Q: Q: In a rough pipe of diameter 500mm and length 3500m, water is flowing at the rate of 0.5 m/s. If…

A:

Q: For a fully developed laminar flow of water (dynamic viscosity 0.001 Pa-s) through a pipe of radius…

A:

Q: Water (p =1000 kg/m , p=1.59×103 kg /m.s) is flowing with the velocity of 0.25 m/s through a smooth…

A: i. The diameter of pipe is 1 cm = 0.01 m initially and then changed to 1 m. So it is the case of…

Q: The elbow flow passage volume is 0.4 m. The water volume flowrate at the inlet is 0.4 m/s and the…

A: Apply energy and momentum conservation principles

Q: Q: In a rough pipe of diameter 500mm and length 3500m, water is flowing at the rate of 0.5 m'/s. If…

A:

Q: Derive the appropriate shallow water eq For a single moving layer of fluid of densit a rigid floor,…

A: Draw the figure The vertical momentum equation is just the hydrostatic equation, ∂P∂z=-ρog…

Q: Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe…

A: Given information: Water is flowing in a pipe at the pressure=PF=102400 MPa Water is flowing in a…

Q: Q5) Flow net in Fig.(1), pressure head h, at point A and B are (18.5,15.5) m respectively, find the…

A:

Q: A flow of water of 100 lt/sec flowing through rectangular tube of width 600 mm and having adjustable…

A: Discharge, Q = 100 l/s Width, W = 600 mm Depth, H = 300 mm C = 56

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?