Consider a system containing permanent electric dipoles Pe. The infinitesimal work done on the system in increasing an applied electric field Ee is given as dW = -VPedEe, where V is the volume of the system (assuming V keeps constant). Please obtain the fundamental relation for such system of electric dipoles from the first law of thermal physics.

Consider a system containing permanent electric dipoles Pe. The infinitesimal work done on the system in increasing an applied electric field Ee is given as dW = -VPedEe, where V is the volume of the system (assuming V keeps constant). Please obtain the fundamental relation for such system of electric dipoles from the first law of thermal physics.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter7: Electric Potential

Section: Chapter Questions

Problem 75P: The probability of fusion occurring is greatly enhanced when appropriate nuclei are brought close...

See similar textbooks

Similar questions

if the heat capacitance for a Container of Aluminum is 270 J/Co and the specific tempreture of Aluminum is 900 J/kg.Co , find the Container mass
How much time is needed for a surgical cauterizer to raise the temperature of 1.00 g of tissue from 37.0ºC to 100ºC and then boil away 0.500 g of water, if it puts out 2.00 mA at 15.0 kV? Ignore heat transfer to the surroundings. How do I check my work for this probelm?
Since the q is negative, shouldn't the answer be positive? (-q = -1.602 x 10-19C). Would it not be option C?
Electric circuits are affected by heat as well. Assume that in its initial state at 20 °C, the capacitor is made of two square pieces of aluminum foil, each 10 cm on a side, and separated by 0.1 mm of teflon. The thermal expansion coefficient of aluminum at 20 °C is given in the text's table 13-1; the linear expansion coefficient for teflon is 120 × 10−6 °C−1, and its dielectric constant (see section 17-8 in the text) is 2.1 (the latter does not change appreciably in this temperature regime). The resistor in the circuit initially has a resistance of 10 kΩ, but its resistance changes with temperature according to ?(?)=?0(1+?(?−?0)), R ( T ) = R 0 ( 1 + σ ( T − T 0 ) ) , where σ = 75 × 10–6 Ω °C–1 and T0 is 20 °C. Compute the difference in the time constant when the circuit components are at 60 °C; you must make a clear statement about whether the time constant becomes larger (the circuit "runs slower") or smaller (the circuit "runs faster"). estimate the change in the time constant…
Why do we need to be careful about work done on the system versus work done by the system in calculations?
You have a pure copper electrical wire with a diameter of 0.205cm and an electrical resistance of 0.0053Ω/m. The wire is exposed to uniform convection of T_inf = 22.0°C, h_inf = 15.0 W/(m2-K). At steady-state conditions the wire carries 21.0 amps of current through it. Determine both the surface temperature and the maximum temperature of the wire.
Assume that the internal diameter of the Geiger– Mueller tube described is 2.50 cm and that the wire along the axis has a diameter of 0.200 mm. The dielectric strength of the gas between the central wire and the cylinder is 1.20 x 106 V/m. Use the result of that problem to calculate the maximum potential difference that can be applied between the wire and the cylinder before breakdown occurs in the gas.
In a conductor, electrons area. Free to move a macroscopic distance across the material b. Completely immobile c. Free to reposition themselves slightly to create a microscopicimbalance, but still bound to their original nucleus d. None of the above
Show that, according to the free-electron model of electrical conduction in metals and classical physics, the resistivity of metals should be proportional to where T is the temperature in kelvins.
When a metal rod is heated, not only its resistance but also its length and cross-sectional area change.The relation R = rL/A suggests that all three factors should be taken into account in measuring r at various temperatures. If the temperature changes by 1.0 C°, what percentage changes in (a) L, (b) A, and (c) R occur for a copper conductor? (d) What conclusion do you draw? The coefficient of linear expansion is 1.70 * 10-5 K-1.
question 47. can u explain step by step
In about 5 sentences can you please explain to me that is the Heat Current “H” the same or different when someone is sitting on the metal or wooden bench?