Consider a system with Bode plot shown below. Magnitude (dB) Phase (deg) 0 -10 -20 -30 -48 -45 -90 10-² Bode Diagram 10-1 If the input signal to this plant is given by x(t) = 10 cos(2t + 55°) and the steady-state output is given by Yss (t) = A cos(wt + p) what is the amplitude A of yss (t)? 10⁰ Frequency 10¹ (rad/s) 10² 103

Consider a system with Bode plot shown below. Magnitude (dB) Phase (deg) 0 -10 -20 -30 -48 -45 -90 10-² Bode Diagram 10-1 If the input signal to this plant is given by x(t) = 10 cos(2t + 55°) and the steady-state output is given by Yss (t) = A cos(wt + p) what is the amplitude A of yss (t)? 10⁰ Frequency 10¹ (rad/s) 10² 103

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A series R L C circuit is operating in a resonance mode. The input voltage signal is: u (t ) =150square root of 2 sin (1000 t - 45deg), V . Find the capacitance C, the characteristic impedance ρ, the quality factor Q, the effective (RMS) values of the voltage drops across the passive elements. Given are: R = 10 Ω, L=100 mH. Use the condition for voltage resonance.
21. Plot the magnitude frequency response for the system G(S)=1/(S(1+0.5S)(1+0.1S))). Also determine gain cross over frequency.
A series RLC Circuit, shown in the Figure, is energized by a 100 V/4 kHz AC supply.The capacitance of the circuit is adjusted until resonance occurs, producing a qualityfactor of 50. Given that the impedance at the half-power points is 70.71 ohms, determine a. the power dissipated at resonance b. the inductance at resonance c. the lower -3dB frequency and the magnitude of the current at the upper -3dB frequency
Sketch the asymptotic magnitude and phase Bode plots to scale for the transfer function? H(jω) = 10(1 − jω/100)/(1 + jω/100)
Characteristic equation of a system is given by, s2+3s+31=0 The value of resonant frequency is: Answer
Consider the angle modulated signal: v(t) = 10 cos [2πx108t + 3 cos(2πx103t)] Assume that the signal is PM. Find the bandwidth using Carson’s rule of the PM signal when themessage frequency is (a) doubled, (b) halved, but all else remains constant.
Consider the open loop transfer function of a system to be a constant value, i.e., G(s)H(s)=50. Using Bode Plots, draw its magnitude and phase response separately.
A mass-spring-damper system is shown below and its transfer function is given. Find the spring constant, mass, and damper constant k,m,c of the system according to the Bode diagram given below. Reminder: The starting point of the red line corresponds to -26dB. ζ=0.32. The frequency corresponding to the sloping peak of the red line ω=ωn =3.2
a-) Determine the zero and poles of the circuit given above by obtaining the transfer function as H(s) = Vout(s) / Vin(s) (Assume the initial values of the energy storage elements are zero). b-) Using the transfer function obtained in the previous option, draw the approximate total amplitude response graph of this function with the help of BODE curves. In these drawings, the total amplitude response equations of the system, the amplitude response graphs of each component in these equations, and the frequency values in the total graphs drawn should be included.
An angle modulated signal with carrier frequency ωc = (2π*106 ) is described by the equation, Φ(t) = 10 cos (ωc t + 0.1 sin 2000 πt) (a) Find power in modulated signal (b) Find frequency deviation Δf (c) Find phase deviation Δφ (d) Estimate bandwidth of Φ(t)
a) Obtain the transfer function Vo/Vs for Vs=Vmcosωt.b) Draw the amplitude response and the phase response.c) According to the value of ω/ω0 as 0, 1, 2, 3, 10, 20, 100 and ∞, calculate the H and ϕ.d) Use LTSPICE to plot frequency response for Vm=10 V, R=4.7 Ω and L=4.7 mH
A series circuit contains an inductance of 0.1062 mH, a capacitance of 106 pF and aresistance. At resonance, the impedance is 10 Ω. Determine the Q-factor and thebandwidth at resonance. ANSWER ASAP