Consider an electrical circuit comprising a battery with voltage V that provides a current I through a resistor network with resistor R1 in series with the parallel combination of R2 and R. Calculate the value of R if: V I R1 R2 2.40E+01 2.40E-01 7.50E+01 5.00E+01 Make sure to express your answer in scientific notation with 2 decimal points.

Consider an electrical circuit comprising a battery with voltage V that provides a current I through a resistor network with resistor R1 in series with the parallel combination of R2 and R. Calculate the value of R if: V I R1 R2 2.40E+01 2.40E-01 7.50E+01 5.00E+01 Make sure to express your answer in scientific notation with 2 decimal points.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 19PQ

See similar textbooks

Similar questions

Consider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?
A child's electronic toy is supplied by three 1.58-V alkaline cells having internal resistances of 0.0200 inseries with a 1.53-V carbon-zinc dry cell having a 0.100- internal resistance. The load resistance is 10.0 . (a) Draw a circuit diagram of the toy and itsbatteries, (b) What current flows? (c) How much power is supplied to the load? (d) What is the internal resistance of the dry cell if it goes bad, resulting in only 0.500 W being supplied to the load?
A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
A lightbulb is connected to a variable power supply. As the potential across the bulb is varied, the resulting current and the filaments temperature are measured. The data are listed in Table P28.38. a. Find R for each entry in Table P28.38, and then plot R as a function of T. b. Assume that room temperature is at 293 K. Find R0 (resistance at room temperature). Comment on your result.
1. 9. In the circuit shown in the figure above, a power supplier of 50 V is connectedacross a resistance network. If R1 = 20 Ω, R2 = 10 Ω, R3 = 10 Ω, and R4 = 40 Ω. Whatis the equivalent resistor of the circuit? 2. 10. What is the current flowing through the R4 resistor in the circuit shown in Problem 9? 3. 11. What is the voltage across the R1 resistor in the circuit shown in Problem 9? 3.
Consider the circuit shown in the figure below. Here, R1 = 2.00 Ω, R2 = 10.00 Ω, R3 = 5.00 Ω, R4 = 4.00 Ω, R5 = 3.00 Ω, and emf = 8.00 V. (d) Combine the equivalent resistance found in part (c) with the R1 = 2.00 Ω resistor. (e) Calculate the total current in the circuit. (f) What is the voltage drop across the R1 = 2.00 Ω resistor?
In the circuit below, if the battery in the circuit below is 5.9V, resistor R1=76.03ΩΩ, and resistor R2=77.61ΩΩ, what is the magnitude of the current that passes through R1? Give your answer in units of milli-Amps (mA).
A student set up the circuit shown for her electronics class. Assuming E = 7.50 V and R = 6.00 Ω, find the following quantities. (a) the current in the 2.00 Ω resistor (Enter the magnitude in mA.) ????? mA (b) the potential difference (in V) between points a and b Vb − Va = ????? V
A circuit with a resistance R = 88 Ω is connected to a battery with potential difference across the terminals of ΔV = 6.5 V. a. Input an expression for the current passing through the circuit, I. (b) What is the current in milliamps, mA? (c) If the resistance of the circuit was increased by a factor of ten, Rnew = 10R, what is the new current in milliamps, mA?
The circuit of the figure below shows a capacitor, two ideal batteries, two resistors, and a switch S. Initially S has been open for a long time. If it is then closed for a long time, what is the change in the charge on the capacitor? Assume C = 11 μF, ℰ1 = 1.0 V, ℰ2 = 5.0 V, R1 = 0.30 Ω, and R2 = 0.30 Ω. __________μC (please show the units when working through the problem so that I can follow it easier)
A 12-volt battery of internal resistance r of 0.05 ohm is to be recharged by a 50-volt dcsource at the rate of 8 amperes.a. What resistance R is to be connected in series with the circuit? ANSWER:_________b. What is the terminal voltage of the battery? ANSWER:_________c. How much energy in joules is dissipated in the resistor in one hour ?ANSWER:_________
A current of I = 4.6 A passes through the circuit shown, where R = 21 Ω. a) In terms of R, I, and numeric values, write an expression for the voltage of the source, V. b) voltage?