Consider an IP packet with a length of 4,500bytes that includes a 20-byteIPv4 header ans 40-byte TCP header. The packet is forwarded to an IPv4 router that supports a Maximum Transmission Unit (MTU) of 600bytes. Assume that the length of the IP header in all the outgoing fragments of this packet is 20bytes. Assume that the fragmentation offset value stored in the first fragment is 0. The fragmentation offset value

Consider an IP packet with a length of 4,500bytes that includes a 20-byteIPv4 header ans 40-byte TCP header. The packet is forwarded to an IPv4 router that supports a Maximum Transmission Unit (MTU) of 600bytes. Assume that the length of the IP header in all the outgoing fragments of this packet is 20bytes. Assume that the fragmentation offset value stored in the first fragment is 0. The fragmentation offset value

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter8: Network Infrastructure And Troubleshooting

Section: Chapter Questions

Problem 8TC

See similar textbooks

Similar questions

Consider 2 hosts, Host A and Host B, transmitting a large file to a Server C over a bottleneck link with a rate of R kbps. To transfer the file, the hosts use TCP with the same parameters (including MSS and RTT) and start their transmission at the same time. Host A uses a single TCP connection for the entire file, while Host B uses 9 simultaneous TCP connections, each for a portion (i.e. a chunk) of the file. Describe the relative transmission rates achieved by each host at the beginning of the file transfer?
P14. Consider sending a 2400-byte datagram into a link that has an MTU of 700 bytes. Suppose the original datagram is stamped with the identification number 422. How many fragments are generated? What are the values in the various fields in the IP datagram(s) generated related to fragmentation?
(ESP) Consider that we protect a TCP SYN packet using the ESP in the transport mode. A TCP SYN packet just comprises a TCP header which is 20 bytes (i.e., without TCP option). The IP packet header is also 20 bytes long (i.e., without IP option). Moreover, the block size for encryption is 256 bits (e.g., using AES-256), and the hash output’s size for message authentication is 512 bits (e.g., using SHA-1). What is the minimum amount of padding required?
Consider transferring an enormous file of L bytes from Host A to Host B. Assume an MSS of 536 bytes.a. What is the maximum value of L such that TCP sequence numbers are not exhausted? Recall that the TCP sequence number field has 4 bytes.b. For the L you obtain in (a), find how long it takes to transmit the file. Assume that a total of 66 bytes of transport, network, and data-link header are added to each segment before the resulting packet is sent out over a 155 Mbps link. Ignore flow control and congestion control so A can pump out the segments back to back and continuously.
Consider transferring an enormous file of L bytes from host A to host B. Assume an MSS of 1460 bytes.a. What is the maximum value of L such that TCP sequence numbers are not exhausted? Recall that the TCP sequence number field has four bytes.b. For the L you obtain in (a), find how long it takes to transmit the file Assume that a total of 66 bytes of transport, network, and data-link header are added to each segment before the resulting packet is sent out over at 10 Mbps link. Ignore flow control and congestion control so A can pump out the segments back to back and continuously.
Host A is sending an enormous file to Host B over a TCP connection. Over this connection there is never any packet loss and the timers never expire. Denote the transmission rate of the link connecting Host A to the Internet by R bps. Suppose that the process in Host A is capable of sending data into its TCP socket at a rate S bps, where S=10·R. Further suppose that the TCP receive buffer is large enough to hold the entire file, and the send buffer can hold only one percent of the file. What would prevent the process in Host A from continuously passing data to its TCP socket at rate S bps? TCP flow control? TCP congestion control? Or something else? Elaborate.
Consider the following scenario in which host A is sending a file to host B over a TCP connection. Assuming that the sequence number of the first data byte sent by A is 0 and every segment always includes 1000 bytes of data, excluding the TCP header. At some point of time, bytes up to 6400 have been written into the sender’s buffer. Bytes up to 4999 have been sent out but the segment which contains bytes 2000~2999 has not arrived at host B yet. At the receiver’s side, all bytes up to 3999 have been received except for bytes 2000~2999. Bytes up to 499 have been read from the buffer by the application. Assume that the maximum size of the sender’s buffer is large enough. Consider the sliding window algorithm in TCP and answer the following questions. 1) What are the values for LastByteAcked, LastByteSent, and LastByteWritten? 2) What are the values for LastByteRead, NextByteExpected, and LastByteRcvd? 3) Assuming that the maximum size of the receiver’s buffer is 4000 byte, what would…
Consider the pattern of red and green packet arrivals to a router’s output port queue, shown below. Suppose each packet takes one time slot to be transmitted, and can only begin transmission at the beginning of a time slot after its arrival. Indicate the sequence of departing packet numbers (at t = 1, 2, 3, 4, 5, 6, 7) under Priority scheduling, where red packets have priority over green packets.. Match each time unit (t=1, t=2, t=3 ....) with the number of the packet that was transmitted and thus "departs" at that time unit.
Consider sending a file of F bits over a path of Q links. Each link transmits at R bits per second (bps). The network is lightly loaded so that there are no queueing delays. When a form of packet switching is used, the F bits are broken up into packets, each packet with L bits, of which h bits of it are header. Propagation delay is negligible. Let F = 5x104, Q = 20, R = 1 Mbps, L = 1000, and h = 10. b) Suppose the network is a packet-switched datagram network and a connectionless service is used. How long does it take to send the file?
Consider sending a 2400-byte datagram into a link that has an MTU of 700 bytes. Suppose the original datagram is stamped with the identification number 522. Write down the values of the following IP header fields for each of the generated fragments and also length, ID, fragflag, offset?
Consider the pattern of red and green packet arrivals to a router’s output port queue, shown below. Suppose each packet takes one time slot to be transmitted, and can only begin transmission (at the earliest) at the beginning of a time slot after its arrival. Indicate the sequence of departing packet numbers (at t = 1, 2, 3, 4, 5, 6, 7) under Priority scheduling, where red packets have priority over green packets. Match each time unit (t=1, t=2, t=3 ....) with the number of the packet that was transmitted and thus "departs" at that time unit.
Suppose an HTML file references two very small objects on the same server (total 3 object including the HTML file). Neglecting transmission times, how much time elapses for all objects to be loaded/received in a non-persistent connection scenario. Assume that the round-trip delay is 10ms for each back and forth communication (even for establishing TCP connection)