Consider steady heat transfer between two large parallel plates at constant temperatures of T1=300 K and T2=200 K that are L= 2cm apart. Assuming surfaces to be black (emissivity = 1), determine the rate of heat transfer between the plates per unit surface area assuming the gaps in between the plates are filled with atmospheric air (k=0.0219 W/m.C). %3D

Consider steady heat transfer between two large parallel plates at constant temperatures of T1=300 K and T2=200 K that are L= 2cm apart. Assuming surfaces to be black (emissivity = 1), determine the rate of heat transfer between the plates per unit surface area assuming the gaps in between the plates are filled with atmospheric air (k=0.0219 W/m.C). %3D

Name: Consider steady heat transfer between two parallel plates at a constan
Uploaded: 2022-11-23T16:32:12.000Z
Channel: Bartleby
Description: Consider steady heat transfer between two parallel plates at a constant temperature Consider steady heat transferbetween two large parallel plates atconstant temperatures of T1=300 Kand T2=200 K that are L= 2cm apart.Assuming surfaces to be black(emi

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter3: Transient Heat Conduction

Section: Chapter Questions

Problem 3.33P

See similar textbooks

Similar questions

8.15 A mercury bath at is to be heated by immersing cylindrical electric heating rods, each 20 cm tall and 2 cm in diameter. Calculate the maximum electric power rating of a typical rod if its maximum surface temperature is .
Determine the rate of heat transfer per meter length from a 5-cm-OD pipe at 150C placed eccentrically within a larger cylinder of 85 magnesia wool as shown in the sketch. The outside diameter of the larger cylinder is 15 cm and the surface temperature is 50C.
An 8-m-internal-diameter spherical tank made of 1.5-cm-thick stainless steelAISI 302 is used to store iced water at 0°C. The tank is located in a roomwith temperature 25°C. The outer surface of the tank is black (emissivity, ε= 1), the heat transfer between the outer surface of the tank and thesurroundings is by natural convection and radiation. The convection heattransfer coefficients at the inner and the outer surfaces of the tank are 80W/m2K and 10W/m2K, respectively; and the outer surface temperature of thetank is 5°C. Draw the equivalent thermal circuit of the system. Determine the total heat transfer rate to the iced water in the tank and the total amount of ice at 0°C that melts after 24 hours.
A 3 m internal diameter spherical tank made of 1 cm thick stainless steel (k =15 W/mK) is used to store water at 4℃, as shown in Figure 2.2. Inner surfaceof the tank is 4℃, while the outer surface of the tank is painted with blackcolour paints with emissivity, ? = 0.88 measured at temperature 5℃. It islocated outdoor at 40℃ and is subjected to wind at 25 km/h. Determine the total heat transfer rate to the ice water.
The emissivity of galvanized steel sheet, a common roofing material, is ε = 0.13 at temperatures around 300 K, while its absorptivity for solar irradiation is αS = 0.65. Would the neighborhood cat be comfortable walking on a roof constructed of the material on a day when GS = 750 W/m2, T∞ = 16°C, and h = 7 W/m2 · K? Assume the bottom surface of the steel is insulated.
A horizontal pipe with a diameter of 18 cm and a length of 10 m, which contains hot oil and has a surface temperature of 383.8 ° C, has an atmospheric pressure of 760 mm Hg. It is located in an environment (open air) where the temperature is 25 °C. Determine the rate of heat transfer from the pipe to the air (the heat transferred by radiation will be neglected).
Consider a 1 m high rectangular closed space with two surfaces separated by an air gap of 0.125 m (at 1 atm pressure). Surface temperatures in the air gap are 34 0C and -9 0C. Find the natural convection heat transfer rates for the horizontal orientation (hot surface down), vertical orientation, and the hot surface inclined at an angle of 80° for this closed gap.
Calculate the convection heat loss from the top and bottom of a flat 1 m squarehorizontal restaurant grill heated to 227°C in ambient air at 27°C.
Exhaust gases from a manufacturing plant are being discharged through a 10-m-tall exhaust stack with outer diameter of 1 m. The exhaust gases are discharged at a rate of 0.125 kg/s, while temperature drop between inlet and exit of the exhaust stack is 30°C, and the constant pressure-specific heat of the exhaust gases is 1600 J/kg.K. On a particular calm day, the surrounding quiescent air temperature is 33°C. Solar radiation is incident on the exhaust stack outer surface at a rate of 500 W/m2, and both the emissivity and solar absorptivity of the outer surface are 0.9. Determine the exhaust stack outer surface temperature. Assume the film temperature is 60°C.
Consider a room having four identical walls of height 3.2 m and width 4 m each. In a hot summer day, the temperature of the inner surface of each wall is 32oC while the room air temperature is maintained at 24oC. The rate of heat loss from the room through the walls is Properties of the quiescent air: k = 0.0263 W/m.℃, ν = 15.89*10-6 m2/s, alpha= 22.5*10-6 m2/s, Pr = 0.707, β= 1/Tf = 0.00343 K-1. Select one: a. 282.6 W b. 35.3 W c. 1130.5 W d. 141.2 W
Heat Transfer Question is image part i) ?
Define Nusselt (Nu), Prandtl (Pr), Reynolds (Re) and Grashof (Gr) dimensionless numbers. State which numbers are used in free and forced convection to determine the heat transfer coefficient.