Consider the arrangement shown in the figure below. Assume that R = 6.00 Q, I=1.20 m, and a uniform 2.50T magnetic field is directed into the page. At what speed ( in units of m/s) should the bar be moved to produce a current of 11.7 A in the resistor? x xT B R * F. app x x xx x x x x x x x x x x x x x x x x x x x x x x x x x

Consider the arrangement shown in the figure below. Assume that R = 6.00 Q, I=1.20 m, and a uniform 2.50T magnetic field is directed into the page. At what speed ( in units of m/s) should the bar be moved to produce a current of 11.7 A in the resistor? x xT B R * F. app x x xx x x x x x x x x x x x x x x x x x x x x x x x x x

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 77AP: A solenoid with 4 x 107turns/m has an iron core placed in it whose magnetic susceptibility is 4.0 x...

See similar textbooks

Similar questions

Hall potentials are much larger for poor conductors than for good conductors. Why?
A solenoid with 4 x 107turns/m has an iron core placed in it whose magnetic susceptibility is 4.0 x 103. (a) If a cent of 2.0 A flows through the solenoid, what is the magnetic field in the iron core? (b) What is the effective surface current formed by the aligned atomic current loops in the iron core? (c) What is the self-inductance of the filled solenoid?
A straight conductor of length l moves with an acceleration a = 0.1 ms−2 at right angles to amagnetic field of uniform strength B = 10 T. The e.m.f. between the ends of the conductorincreased from 0 to 5 V during the first 20 s after the beginning of motion. Calculate l.
In a particular region there is a uniform current density of 15 A/m2 in the positive z direction. What is the value of when that line integral is calculated along a closed path consisting of the three straight-line segments from (x, y, z) coordinates (4d, 0, 0) to (4d, 3d, 0) to (0, 0, 0) to (4d, 0, 0), where d = 20 cm?
A metallic wire of uniform cross-section and resistance R is bent into a circle of radius a. The circularloop is placed in a magnetic field B t( ) which is perpendicular to the plane of the wire. This magneticfield is uniform over space, but its magnitude decreases with time at a constant rate k, wherek=d B/dtThe tension in the metallic wire is
A wire of nonmagnetic material, with radius R, carries current uniformly distributed over its cross section. The total current carried by the wire is I. Show that the magnetic energy per unit length inside the wire is μ0I2/16π.
Consider the systempictured in Figure P19.31.A 15 - cm length of conductorof mass 15 g, free tomove vertically, is placedbetween two thin, verticalconductors, and a uniformmagnetic field acts perpendicularto the page. When a5.0 - A current is directed asshown in the figure, the horizontalwire moves upward atconstant velocity in the presenceof gravity. (a) What forces act on the horizontal wire, andunder what condition is the wire able to move upward at constantvelocity? (b) Find the magnitude and direction of theminimum magnetic field required to move the wire at constantspeed. (c) What happens if the magnetic field exceedsthis minimum value? (The wire slides without friction on thetwo vertical conductors.)
Two long parallel wires carry currents I1=I, and I2=2I in the same directions. Which of the following statement(s) is/are true?
t is desired to construct a solenoid that will have a resistance of 4.50 Ω (at 20°C) and produce a magnetic field of 4.00 ✕ 10−2 T at its center when it carries a current of 3.75 A. The solenoid is to be constructed from copper wire having a diameter of 0.500 mm. If the radius of the solenoid is to be 1.00 cm, determine the following. (The resistivity of copper at 20°C is 1.7 ✕ 10−8 Ω · m.) (a) the number of turns of wire needed to build the solenoid Your response differs from the correct answer by more than 10%. Double check your calculations. turns(b) the length the solenoid should have cm
A circular loop made of copper wire with a diameter 0.96 mm is placed in a uniform magnetic field 0.274 T with field lines directed perpendicular to the loop plane. The shape of the loop is changed from circular to a square one. Find the total charge that flows in the conductor if the radius of the circular loop is 0.1 m. Use the copper resistivity 1.68E-8 Ohm⋅m.
Which of the following properties is found only in ferromagnetic materials ? A) Susceptibility independent of temperature B) Point in a particular direction C) Hysteresis D) Attracting a magnetic substance
It is desired to construct a solenoid that will have a resistance of 4.95 Ω (at 20°C) and produce a magnetic field of 4.00 ✕ 10−2 T at its center when it carries a current of 4.75 A. The solenoid is to be constructed from copper wire having a diameter of 0.500 mm. If the radius of the solenoid is to be 1.00 cm, determine the following. (The resistivity of copper at 20°C is 1.7 ✕ 10−8 Ω · m.) (a) the number of turns of wire needed to build the solenoid turns (b) the length the solenoid should have cm