Consider the baseband signaling of the textual message 'OK' (excluding the otes) in a wired DCS using binary line codes. Assume to bit duration is = 1 ms. (a) Covert the message "OK" into a bit stream based on the 6-bit ASCII standard. (b) Describe mathematically and plot the non-return to zero level de. (c) Describe mathematically and plot the bi-o-L (Manchester) line code. (d) escribe mathematically and plot the bipolar level line code. (NRZ-L) line ested Steven Sch

Consider the baseband signaling of the textual message 'OK' (excluding the otes) in a wired DCS using binary line codes. Assume to bit duration is = 1 ms. (a) Covert the message "OK" into a bit stream based on the 6-bit ASCII standard. (b) Describe mathematically and plot the non-return to zero level de. (c) Describe mathematically and plot the bi-o-L (Manchester) line code. (d) escribe mathematically and plot the bipolar level line code. (NRZ-L) line ested Steven Sch

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Similar questions

Write a VHDL code for 4:1 multiplexer using conditional concurrent signal assignment
Sketch the Bipolar RZ Voltage encoding on a classic Ethernet for the bit stream0001110101.
A. If the probability of error of BPSK is 0.85 then Pe of BFSK is? B. What happens to the radio wave propagation when the rouefractive index of ionospheric layer becomes low or high? C. If the number of quantization levels are multiplied by four time them how many numbers of bits are added to the actual number? D. What is the disadvantage of wave tilt? E. What is a bipolar line coding technique with phase encoding, and explain why it is named as phase encoding method? F. What is oblique communication circuit? G. What are the differences between DPCM and Delta Modulation? H. What is the change in bandwidth when channel capacity is doubled and two number of bits are increased?
What is the minimum bandwidth of the PSK modulated signal? and then compare the bit-error probability of PSK with other keying techniques
1/ A 4 MHz analog signal is to be converted to a binary signal (PCM). If the signal to peak quantization noise ratio should be at least 30 dB: a/ What is the size of the code word? b/ What is the system rate in bits per second if sampled at the Nyquist rate?
Given an ideal 6 bit ADC with a reference voltage of 640mV, what is a VLSB of this ADC? What is the rms value of its quantization errors ?
A PCM system is used to transmit base4 signal of 512 level, the input signal works in the range between (30 to 70) MHz. Find the bit rate and signal to noise ratio in dB? Note that: the step size is considered to be double of system levels? *
What is the best-case rising delay a standard size three-input NAND gate that does not have an external load, written in terms of RC (numerical result only)?
(b) In which encoding scheme Nyquist theorem is used and Why? Explain complete procedure of that Encoding scheme with example with the advantages and Disadvantages of this theorem.
An analog baseband signal of maximum frequency component of 4 KHz is transmitted using a pcm system with 8 bit uniform quantizer. What will be the minimum Transmission bandwidth?
The number of bits per sample in a PCM system has SNqR=45 dB is?
Exxplain the rellation between BER and E/N_0, where E is the energy per bit,N_0 is the noise spectral density, BER is the bit error rate. What is the reason for usign channel coding?