Consider the circuit shown below andanswer all of the following questions.iRt = 010ΩV =20 V8 V20 HVC20ic-ell 10Assuming that V1 = 20u(t+3), then thetime constant (t) for i_L(-3

Answered: Image /qna-images/answer/49a7a3a6-d799-4b38-877b-ee98b9928923.jpg

Answered: Consider the circuit shown below and…

Consider the circuit shown below and answer all of the following questions. iR t = 0 10Ω V, = %3D 20 V 20 H VC 8 V 20 ic elll

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 9PP: In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.

See similar textbooks

Related questions

Q: Problem [10] Obtain the inductor current for t>0 in each of the circuits below. 12 Ω 42 2 A 4Ω t=0…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: A series RL circuit with R = 15Q has a constant voltage E = 137 V applied at t = 0 by %3D the…

Q: (b) find Rab 10 N 18 N 35 N a 60 N 375 50 N 75 Ω Α 3 40 E 30 N 10 N 20 N b (b)

A: The detailed solution is provided below.

Q: Determine the inductor current i(t) shown in the circuit below. t = 0 4Ω i(1) 16 0 20 V 0.4 H v(1)…

A: Current: It is the time rate of the change of the charges. The direction of the current is opposite…

Q: EXAMPLE 3. Use step-by-step approach to find io(t) for t > 0. Plot the response. SW1 100 mH 3A(…

A: Find the current in the 3 ohm resistance io Inductor act as short circuit after long time.

Q: XI. Claculate the currents il and i2 in the circuit below, the initial currents are zeros. 8.4 H 10…

Q: 6) The voltage across a 3 uF capacitor is shown below. Plot and determine the current waveform. v(t)…

Q: 4. A RL transient circuit is shown below, 1=0 R=5kN V, = 100 V i(1) v(1) L=10mH Figure A4 Estimate…

A: For this problem, we have to find IL(t) .

Q: 28 A constant voltage is applied to a series RL circuit at t=0. The voltage across the inductance is…

Q: Find the current I. 150 N 300 N 75 N 30 V 450 N 150 N 50 N

Q: If the current through a 100 mH inductor is given as i(t) = 2t +3, the voltage across the inductor…

Q: Determine whether the circuit presented below is forward-biased or reverse-biased. State your…

A: Analog electronics problem. Look below for the explaination...

Q: Find the total current in the circuit below. 70 40 10 0 20 90 130 S1305 90 50 60 30 120 V 12 0 10 0

A: According to question circuit diagram,

Q: what the maximum values of RL in the circuit shown 100 N 10 V 5 V R, 1, IZM = 30mA 1250 Q 250 Q O…

Q: A series RL circuit with R = 50 N and L = 10 H has a constant voltage E = 100V applied t = 0 by the…

Q: what the maximum values of RL in the circuit shown 100 Ω www 10 V 5 V IZM = 30mA O 12500 +

Q: For the circuit shown below, find 1) i (0*) and v(0*), 2) di(0*)/dt and dv(0*)/dt, 3) i(00) and v(0)…

A: Redrawing the circuit before the switch closes as shown in the figure below. The circuit was in this…

Q: An RL circuit has an emf given (in volts) by 3 sin 2t, a resistance of 10 ohms, an inductance of 0.5

Q: Calculate the capacitor's voltage for t 0 for the following circuit a) 2 F 12 V X=0 www 352 b)…

Q: For the circuit given below, find the energy stored in 40 pF capacitor. 60 µF 40 pF 卞 6 kll 多 A OS -…

A: To solve above problem one should know the behavior of inductor and capacitor in DC circuit…

Q: For the following circuit, solve for v(t) at f>0. v(1) 1F t = 0 100 20Ω 120 V 4 H (+)

A: The solution is given below

Q: ! Required information In the given circuit, (2)a = 56 e i(t) = 9 e -260t V,t>0 -260 t mA , t>0 R…

Q: For the following circuit, find R such that Rab=11.04 N 10 2 12 d 12 ww а Rab 3Ω 4 2 12 2 bo b b O…

A: Series Connection of Resistors: When n no. of resistors are connected in series, their equivalent…

Q: RL Series Circuit Suppose E = 4.7_V, R = 10 0, and L = 4.5_H. After 0.31 time constants, the current…

Q: Q.3) In the circuit given below find 1) for t> 0 if (0) = 2 A. 6 H elll 10 2 0.5i 40 Ω

A: Network problem Current flow i(t) in inductor 6H which have i(0) =2A and i(t) =? for t>0

Q: A series circuit contains R=0, L=1 H, C=10-4 F and E=100sin50t V. Initially, the charge and current…

A: given circuit

Q: Solve for lo if R = 76, Vs = 66, and Is = 281. %3D Vs 4Ω Is

Q: 20μF R1 + R3 Vc 0.5mH R2 10V 0.4mH 10µF 24V Assume the above circuit has been in this state for a…

Q: what the maximum values of RL in the circuit shown 100 Ω www 10 V 5 V IZM = 30mA + 1250 Ω Ο 250 Ω…

Q: 12. An RLC parallel circuit has an applied voltage of 240 volts. R = 60 , X = 20 2, and Xc= 36 Q.…

A: In this question, choose the correct option What is capacitive current?

Q: Problem A: Given the time domain current i(t) = %3D 20cos(200t + 20 deg) A. Convert the current into…

A: Given time domain current is, i(t)=20cos200t+200 A

Q: what the maximum values of RL in the circuit shown 100 Ω |10 V 5V Ο 1250 Ω 250 Ω Ο 500 Ω Ο 0.167 Ω +…

Q: what the maximum values of RL in the circuit shown 100 Ω www 10 V 5V IZM = 30mA R₁

Q: :In the circuit of figure below, i(co) is i(t) 5 H 10 A t = 0 (a) 8 A O (b) 6 A O (c) 4 A O (d) 0 A…

A: In the Transient analysis of any circuits, Inductor always opposes the sudden change of current and…

Q: tion * Points) In the following circuit, if R, = 8N, then RTH between a and b is: %3D 2i, R1 B) 7.2…

Q: . Determine the inductor current i(t) shown in the circuit below. t = 0 16 2 4Ω i(t) 20 V 0.4 H v(1)…

Q: Determine the inductor current i(t) shown in the circuit below. t= 0 4Ω. i(t) 16 2 20 V 0.4 H v(1)…

Q: A 2 mH 300 N 220 N Calculate i¡ (f) at the instant just after the switch opens. The inductor current…

A: At steady state inductor acts as short circuit , inductor does not allow sudden changes in current .…

Q: he capacitor voltage in the circuit below is given by v(t) = 12 – 10e *v _ for t>0 Determine i(t)…

Q: 1) In the circuit shown below v(t)=56e200" V, t>0 i(t)=8e-200 mA, t>0 (a) Find the values of R and…

Q: Consider the following electrical circuite 100 µF t= 0 6 kN 12 V 6 kN 6 kN i. Find the respose time…

A: To find (i) response time (ii) Initial value of Capacitor (iii) Capacitor Voltage Vc(t) (iv) output…

Q: The current passing through a 1 F capacitor is as shown and the voltage across it is v(0) = 0 Volt,…

A: According to question:

Q: 6 kN 6kN 6 kN mA 10ΚΩ 6k9

A: According to question: The resistance of star when delta of [6ohm, 6ohm, 6ohm] is calculated as…

Q: i(t) 3N 0,25 H 0,1 F ; 수 v(t) + 40 V ) 4 A

A: we need to find the values v (+ ∞), i (+ ∞)

Q: + L R Iqu(-t) In the circuit above, use I, = 150mA, R = 1202, L = 570MH, and C = 38µF. Determine the…

Q: 1. Determine the inductor current i(t) shown in the circuit below. t = 0 4Ω ilt) 16Ω 20 V 0.4 H v(1)…

Q: Q 1: CODE*e* V. Assuming the initial current and charge: i(0) = 0, i'(0) = 0. Find the current i(t)…

Q: t=0 0.5 k. 4 mA(1 4 µF VC 0.25 H

Q: The figure shows the voltage across L = 30H , then the current through the inductor at t = 1.5 s is…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

10
Assuming that V1 = 20u(t+3), then the
time constant (t) for i_L(-3<t<0) is found
to be (in second)
O 0.5
None of the choices
O 4
10

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.
Schematic diagrams break the wiring of control systems down into a(n) _____ arrangement. a. circuit-by-circuit b. series circuit c. individual circuit d. none of the above
If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
The circuit is connected to a 400-Hz line with an applied voltage of 35.678 V. The resistor has a true power of 14.4 W. and there are 12.96 inductive VARs and 28.8 capacitive VARs. ET35.678VITZVAPFERIRRP14.4WELILXLVARsL12.96LECICXCVARsC28.8C
This circuit is connected to a 1000-Hz line. The resistor has a voltage drop of 185 V. the inductor has a voltage drop of 740 V, and the capacitor has a voltage drop of 444 V. The circuit has an apparent power of 51.8 VA. ETITZVA51.8PFER185VIRRPEL740VILXLVARsLLEC444VICXCVARsCC
In an R-L parallel circuit, R=240 and XL=360. Find impedance.
Thevinin and Norton VII. Perform open circuit test and short circuit test at terminal a-b and draw the circuit *use kvl, vdt, cdt, kcl
For the following given circuita) specify re.b) find Av mid = v0 / VI.c) we calculate Zi.
Calculate the voltage Va by node analysis, please show the procedure step by step.
A series R - L - C - circuit consists of a 25 ohms resistor , a 0.221 henry inductor, and a 66.3 microfarad capacitor , for what 60 - cycle impressed voltage will the current be 2.5 amps? 250V 125V 300V 110V
4.Two storage batteries are connected in parallel to supply a load having a resistance of 0.20ohm. The emf of the firstbattery is 12.1-V and that of the other is 11.8-V. The internal resistances are 0.20ohms and 0.23ohms, respectively. Determine the terminal voltage. Use Kirchhoff’s Circuit Analysis Method.
For the circuit below calculate: b) Zi, ZO, AV, Ai