Consider the following : 1. When gas is heated at constant volume, its pressure and temperature will increase. 2. Volume 3. Change in internal Energy is equals to change in heat transfer 4. The value of the work done is not zero Which of the above condition relates with isochoric process? Select one: O a. 1,2 and 4 only O b. 2 and 4 only O c. 1, 2, 3 and 4 O d. 1 and 3 only * anssad

Consider the following : 1. When gas is heated at constant volume, its pressure and temperature will increase. 2. Volume 3. Change in internal Energy is equals to change in heat transfer 4. The value of the work done is not zero Which of the above condition relates with isochoric process? Select one: O a. 1,2 and 4 only O b. 2 and 4 only O c. 1, 2, 3 and 4 O d. 1 and 3 only * anssad

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter2: Steady Heat Conduction

Section: Chapter Questions

Problem 2.39P: The tip of a soldering iron consists of a 0.6-cm- diameter copper rod, 7.6 cm long. If the tip must...

See similar textbooks

Similar questions

A 1 kg gaseous system in a piston cylinder receives heat at a constant pressure of 350 kPa. The internal energy increases 200 kJ, and the temperature increases 70K. If work done is 100kJ, determine (a) Cp, (b) change in volume.
Can you show the solutions for this review problem in Thermodynamics 2 8. Water at 2.5 MPa and 200°C is heated at constant temperature up to a quality of 80%. Find (a) the quantity of heat received by the water, (b) the change in internal energy, and (c) the work of a nonflow process. Ans. (a) 2025.7 kJ/kg; (b) 1396.5 kJ/kg; (c) 629.17 kJ/kg
A tank contains Helium for which R = 382 ft.lbf/lb.-R and k = 1.66, is heated from 85°Fto a final temperature of 190°F in an unknown process. Find the value of cpA. 1.235 Btu/lb-R B. 1.335 Btu/lb-R C. 1.435 Btu/lb-R D. 1.535 Btu/lb-R
2) If an ideal gas undergoes a process where the change in enthalpy (Δh) is 424 kJ/kg, and the change in internal energy (ΔU) is 320 kJ/kg, and the gas has Cv = 0.7452 kJ/kgm-K, find the following: a) Specific heat ratio (k) b) Specific heat for constant pressure (Cp) c) Gas constant (R)
A closed, rigid tank fitted with a fine-wire electric resistor is filled with Refrigerant22, initially at -10 °C, a quality of 80 %, and a volume of 0.01 m 3 . A 12-volt batteryprovides a 5-ampcurrent to the resistorfor 5 minutes. If thefinal temperature of therefrigerant is 40 °C,determine the heattransfer, in kJ, from therefrigerant.
A spring-loaded piston-cylinder device contains of m=1 kg carbon dioxide. Initially, the spring has no force on the piston and , , . Heat is transferred to the gas, causing the piston to rise and to compress the spring. At the state 2, , . The gas is an ideal gas. (9) If cv=0.657kJ/kg·K, calculate the internal energy change ΔU=mcv(T2-T1)______(kJ)
Two pounds of gas, R= 26 ft-lb /lb-R and k=1.10, undergo a polytropic from 15 psia, 100 F to 75 psia, 3.72 ft0. Determine the value of “n”, ΔH, ΔS, Q and Work.
Heat in the amount of 7.5 kJ is added to a closed system while its internal energy decreases by 12 kJ. How much energy is transferred as work? For a process causing the same change of state but for which the work is zero, how much heat is transferred?
When air expands adiabatically (without gaining or losing heat), it's pressure P and volume V are related by the equation PV^1.4=C where C is a constant. Suppose that at a certain instant the volume is 510 cubic centimeters and the pressure is 87 kPa and is decreasing at a rate of 12 kPa/minute. At what rate in cubic centimeters per minute is the volume increasing at this time?
3. A system receives 1.3 kg/s of fluid at the following initial properties:u1 = 2,731 kJ/kg, P1= 16 kPa, v1=0.081 m3/kg. Exit properties are as follows: u2=5,053 kJ/kg, P2=37 kPa, v2=0.176 m3/kg. The fluid receives 1.2 kJ/s of heat as it goes through the system. Find the following:a. Work in kJ/kgb. Work done by / on the system in 20 seconds.
A vertical piston-cylinder assembly contains 0.5 kg of water. Initially, the piston is resting against the stops when the water pressure and temperature are 1.00 bar and 100°C, respectively. The piston has a mass of 50 kg and face area of 0.01 m2; local atmospheric pressure is 1.01 bar; local gravitational acceleration is 9.81 m/s2 (5) Assuming that the water's pressure remains constant, find the work for the volume to double in kJ. Carefully indicate the direction (i.e., what is the work that you reported being done on or by?) (2) Suppose the heat transfer stops, and the water is allowed to come to an equilibrium temperature with its environment at 25 °C. What phase(s) will the water be?
Please help, there are similar problems I found here but the answers are different in the answers of our workbook. (Topic is ideal gas with constant volume) . 3. A closed rigid container has a volume of 1m^3 and holds air at 344.8kpa and 273K. Heat is added until the temperature is 600K. Determine: a.) final temperature b.) change in internal energy c.) the work output Ans. a. 757.8K b. 497.22KJ c. 0