Consider the network topology shown below. GO/0 PC-A R1 Device IP address / prefix 2001:C:11:10/64 PC-A () What is the IPV6 address of PC-A in full hexadecimal? (ii) The last IP address of the network is assigned to the router interface GO/0, what is the IP address (in shortest format) of PC-A's default gateway?

Consider the network topology shown below. GO/0 PC-A R1 Device IP address / prefix 2001:C:11:10/64 PC-A () What is the IPV6 address of PC-A in full hexadecimal? (ii) The last IP address of the network is assigned to the router interface GO/0, what is the IP address (in shortest format) of PC-A's default gateway?

A+ Guide to Hardware (Standalone Book) (MindTap Course List)

9th Edition

ISBN:9781305266452

Author:Jean Andrews

Publisher:Jean Andrews

Chapter8: Connecting To And Setting Up A Network

Section: Chapter Questions

Problem 5RB

See similar textbooks

Similar questions

Suppose you are retrieving your email at the start of a new day at the College and your mail first reaches the BMCC’s web server. Assuming the BMCC webserver does not have the MAC Address of the workstation receiving these mail messages. Explain in detail how the ARP protocol is used in locating the final destination of the internal network computer that will be receiving this Internet traffic. The conversion from IPv4 to IPv6 Addressing has been completed for about 30% of Internet traffic after 22 years. Explain in detail why the Maximum Transmission Unit (MTU) of Ethernet frames is an obstacle in this conversion (hint: look closely at the TCP and IP headers for IPv4 to IPv6 Addressing).
Given the following IP Address 192.168.1.0/29 Write subnets, Broadcast Address, useable IP's, Block size and mask for each subnet.
Given the topology below, write the commands to advertise the OSPFv3 networks on the Sohar router. Use the following requirements: - Enable IPv6 routing- Process ID 10 - Router IDs (Sohar router = 2.2.2.2) - Advertise Network address for each interface - LAN interface (G0/0) set to passive interface - Assign Link-Local Addresses (fe80::1) to G0/0
Please solve with steps please solve from the picture How many host addresses are available on the network 10.20.0.0/22? Use the Classless (VLSM) Subnetting technique to find the prefix length, Subnet mask IP, network IP and broadcast IP for each subnet. (Show the detailed answer- Filling the table only results in deducting points) Subnet Number of Hosts prefix length /n Subnet mask IP Network Address Broadcast Address 1 2 3 4 5 6
Consider the single switch VLAN shown below, and assume an external router is connected to switch port 1. Assign IP addresses to the EE and CS hosts and router interface. Trace the steps taken at both the network layer and the link layer to transfer an IP datagram from an EE host to a CS host.
answer by true or false: For a specific Ethernet LAN switch, users connected with this switch can transmit at a fixed transmission rate. ( ) Two ISPs at the same level of the hierarchy often peer with each other. A lower layer ISP often connects with one or two higher layer ISPs. ( ) With persistent connections between browser and origin server, it is possible for a single TCP segment to carry two distinct HTTP request messages. ( ) Suppose you wanted to do a transaction from a remote client to a server as reliable as possible, it would be better if you use TCP, because TCP provides reliable transport service. ( ) A local DNS server can be an Authoritative DNS server. ( ) Host A is sending Host B a large file over a TCP connection. Assume Host B has no data to send Host A. Host B will also send acknowledgments to Host A. ( ) It is impossible for a program to run client and server side code at the same time. ( )…
8)How do you describe a TCP/IP encapsulation process? a. data is sent from transport to network access layer b. Segments are sent from transport to internet layer c. Bits are sent from transport to internet layer d. frames are sent from internet layer to transport layer
i. Write the IPv6 address of VLAN 40 in expanded form. ii. Aggregate the IPv6 routes of VLAN 30, 40 and 50. Ensure that you show your working. iii. Explain THREE benefits of route aggregation /summarization.
Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, answer the following question 1-5. The devices in each subnet are connected locally to each other through layer two intermediate devices such as Ethernet switch and ethernet hub. For each device in the subnets, both its Internet Protocol (IP )address and its MAC address (also called the Physical address or the Ethernet address are shown. The subnet mask used by all devices is 255.255.255.240 (which is the same as the prefix length “/28”). 1. If Client #1 wants to send a broadcast packet to all the devices on the left subnet (containing client #1, client #2, client #3) what destination IP address should be used? (Mention in both binary and decimal format.) 2. What is the first and last assignable IP address for the left subnet above (containing client #1 and #3)? (Mention in both binary and decimal format.)
Suppose you open your BMCC mailbox first thing on a Monday morning and find that your messages have arrived. Assuming the BMCC server does not have access to the MAC address of the device reading these emails. Explain in detail how the ARP protocol determines which device on the LAN will be the recipient of incoming Internet data. After 22 years, the transition to IPv6 addressing is complete for around 30 percent of Internet traffic. When comparing IPv4 and IPv6 address headers, the Ethernet frames' Maximum Transmission Unit (MTU) stands out as a potential stumbling block.
In ICT infrastructure, which of the following statements is true about the use of User Datagram Protocol (UDP) in Voice over Internet Protocol (VoIP)? VoIP often uses UDP because it offers low latency and is better suited for real-time communication than TCP. VoIP can use both TCP and UDP interchangeably, depending on the type of communication and the devices involved. UDP is used in VoIP only when the network has low congestion, otherwise TCP is used to ensure data reliability. VoIP always uses TCP to ensure that voice data is transmitted reliably. UDP is not used in VoIP because it does not support real-time communication.
Subject :-Data Communication 1) A router has the following (CIDR) entries in its routing table: Address/mask Next hop 147.38.96.0/19 Interface 0 147.38.75.0/22 Interface 1 192.67.124.0/24 Router 1 default Router 2 For each of the following IP addresses, what does the router do if a packet with that address arrives? 1) 147.38.98.12 2) 147.38.82.7 3) 192.67.100.2 Thank you in advance!