Consider the op-amp circuit below. Given the input voltage V1= 0.2V, calculate the output voltages V2 and V3.

Q: A 1-phase, 20 km line delivers a load of 12 MW at 11 kV having a lagging p.f. of 0.9 at the receivin...

A:

Q: Construct the equivalent circuits using logic gates and explain your answer. There are two teams...

A: Given, There are two groups namely group A and group B. Both groups have two members, a member of gr...

Q: Prob. 8: The current through the secondary of the 2.2 MVA 11/3.6 kV, Z = (1+j6.2)% transformer is gi...

A:

Q: A parallel circuit consists of a resistor having a conductance of 4 siemens, an inductive reactor ha...

A:

Q: . Suppose you have an NMOS transistor with a threshold voltage of 1 V.  You apply 3 V to the gate, g...

A:

Q: Determine the diameter in inches and in millimeters of circular cables having cross-sectional areas ...

A: Since there are 4 sub-parts (a, b, c, d), as per the guidelines, in the following section, only the ...

Q: If the no-load voltage of a separately excited shunt generator is 110 volts at 1,350 rpm, what will ...

A: This question belongs to electrical machine . It is based on the concept of relation between voltage...

Q: a) Design an NMOC inverter with a resistive load (Find the value of R and W/L) for VDD = 5 V and P =...

A: Given the circuit, as shown below: a) We need to design an NMOS inverter with a resistive load for ...

Q: Given tree impedances: zl = 10 + j0, Z2= 3 + j4 and Z3 = 8 – j6. Impedances Z2 and Z3 are connected ...

A:

Q: 2. If 12.48 x 10^20 electrons pass a certain point in a circuit in 2.5 s, what is the current in amp...

A:

Q: 12V The books of the three equations are no longer complemetaryo Sarat and Arara of the circle of th...

A:

Q: Determine the equivalent resistance Req. * (1) R 2) (3) 2R (4) (6) (8) R (9) (10) 9R None of the cho...

A:

Q: 1. Choose one type of diode and explain its function, operation, and different applications. Your ...

A:

Q: Describe what the following conductor designation means when it is printed on the insulation; RHH/RH...

A:

Q: Example 3 For the circuit shown in Figure 2, find the current (1) and voltages Vo V, and V2. Solutio...

A:

Q: E3.9 Use nodal analysis to find I, in the network in Fig. E3.9.

A:

Q: Find the voltage VA in the circuit shown in Fig. (i). Use simplified mode 15 V Si Ge 3 k2 (i) 3.

A: In this question,  Find the voltage VA  as shown in the circuit?  Assume forward bias voltage for si...

Q: An LTI Sys tem described the defference Equation Iyin-2)=25n) is intially 16 write the tranefer fund...

A: Given  Difference equation of the LTI system  y(n)-116y(n-2)=x(n)

Q: Three identical capacitors of 15 micro farad are connected in star across a 425 volts, 50HZ, 3-phase...

A: Three identical capacitors are linked in a star configuration with a supply voltage of 400 volts, 50...

Q: Explain the essential features of Indicating Instruments?  Diagrams – draw neatly , scan and attach...

A: Measuring instrument- Define a measuring instrument as any device that can be used to determine the ...

Q: Ex. Calculate the PA for the follow assembly code which is assume the DS = 4500h, SS = 2000h, BX = 2...

A: Registers can be used instead of using memory which is smaller in size and takes less time to be acc...

Q: 1 out of 3 attemp Find the bandwidth and center frequency of the bandstop filter of the figure. Roun...

A: Given circuit,  

Q: A load of 120 MW at a power factor of 0.8 lagging can be delivered by a 3-phase transmission line. T...

A: per phase power =3 phase power 3Given 3 phase power = 120 MWso per phase power  = 1203 = 40 MWPer ph...

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and inducta...

A:

Q: Express the Boolean function, F(X, Y, Z) = Z' + XY', as a) a sum of Minterms b) a product of Maxt...

A: The given boolean function is shown below: FX,Y,Z=Z+XY¯

Q: A 400V, 3-phase Induction motor has output of 30HP and operates at power factor of 0.85 lagging with...

A: The power factor angle for the two wattmeter method is given by the expression as shown below:  tanϕ...

Q: Problem 26: Use mesh analysis to find the current through the resistor. R5 3 0 R3 R2. 10 Ω Ri 4 0 R6...

A:

Q: To detect a fire in a room, 3 (three) smoke detectors are used. If only one detector is active, the ...

A: Given, if only one detector is active, the fire alarm remains inactive. The new alarm becomes active...

Q: What is the dominant lower critical frequency of a three-stage amplifier in which fcl = 50 Hz for ea...

A:

Q: The following data were obtained when a 25 kVA, 2300/460 V, 50 Hz transformer was subjected to open-...

A:

Q: 2) Find all node voltages and branch currents 2 kN 4 kN 12 V(+ ) 2 mA 2 kN

A: Given,  

Q: (а) [(5 + /2X-1 + J4)-5/60'] 10 + j5 + 3/40 (b) + 10/30° + j5 -3 + j4

A: a z =5+j2-1+j4-5∠60°         = -5 -j2+j20-8-5cos60°+j5sin60°         = -13 +j18-2.5-j4.33z  =     20...

Q: An RL circuit has an emf of 5 volts, a resistance of 50 ohms, an inductance of 1 henry, and no initi...

A: Given an RL circuit has, EMF, E = 5 V Resistance, R = 50 ohms Inductance, L = 1 H No initial current...

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and inducta...

A: Given, An RLC series resonance circuit has Capacitance, C=22 μF Resistance, R=1200 Ω Inductance, L=3...

Q: a) Draw nominal - T model of Transmission Line.      b) Write ABCD Parameters of the nominal T mode...

A:

Q: xplain the essential features of Indicating Instruments Please do not write the answer on a ...

A: Indicating Instruments - An indicating instrument is simply a movable mechanism pivoting on jewel r...

Q: Find the current in R3 and Voltage at V2 * 3 poi Circuit Parameters Vs = 15 V La =2A I= 3 A R: V2 R ...

A:

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output vo...

A:

Q: An Alternator having three-phase, 3-wire ABC system supplying an effective line voltage of 120 V, ha...

A:

Q: A coil of a 50 ohm resistance and of 150 mH inductance is connected in parallel with a 50 µf capacit...

A:

Q: An impedances Za=4+j4 ohms is connected in parallel with an impedance Zb=12+j6. The input reactive p...

A:

Q: Using Thevenin's Theorem, Find Thevenin equivalent circult at terminals a-b.( Rth and Vth)* R3=1.5 k...

A:

Q: Given the points A(x=2, y=3, z=-1) and B(p = 4, 0 = -50°, z = 2), find a unit vector in cylindrical ...

A: Given points are,Ax=2, y=3, z=-1andBρ=4, ϕ=-50°, z=2

Q: What is the value of Vx in volts if I = 1.2 A and V = 9 volts. 50 10Ω 150 V + Answer:

A:

Q: Grinding Force Desired DOC Force K¸(Rs+1) Machine Stiffness 1 2 Deflection ms + bs + k Control Filte...

A: Given

Q: Example 1 For the circuit shown in Figure 1, find the diode current (Ip), the diode voltage (Vp), an...

A:

Q: 1. Determine the Vo for the circuits below: Si Ge 2 k2 +20 V 2 kQ (a) Si +10 V 1.2 k2 4.7 k2 (b)

A:

Q: A 415V, 3-phase Induction motor has output of 30HP and operates at power factor of 0.6 lagging with ...

A: The information we have : Output power,  Pout=32 hp=32×746 Watts=22380 Watts Power factor, cosϕ= 0.6...

Q: 2. Determine the output voltage (Vo) and current (I) for the circuit shown below. +16 V Si 4.7 ka 12...

A: Given circuit:

Q: Find the voltage across 10-ohm resistor. * 10ix 12 2 15Ω 4Ω 82 ix 6Ω 10Ω 12 V 24 V 1 V O 0.1 V 0.7 V...

A: Consider the given circuit,

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.