Consider the RL circuit shown in the figure, where R = 12.3 Ω. The switch S is closed at t = 0. At t = 3.00 ms, the current has reached 94.3% of its final value. Calculate the inductance (in mH).

Q: Tarik winds a small paper tube uniformly with 191 turns of thin wire to form a solenoid. The tube's…

A:

Q: The capacitive reactance is most nearly А. 167 The current in the circuit is given by i(t) = I…

A:

Q: An LC circuit like the one in the figure below contains an 60.0 mH inductor and a 25.0 µF capacitor…

A:

Q: In the circuit shown in (Figure 1), E = 56.0 V, R₁ = 36.0 , R₂ = 22.0 , and L= 0.290 H. Part A…

A: Givenε=56 VR1=36 ΩR2=22 ΩL=0.290 H

Q: A circuit is constructed with four resistors, one inductor, one battery and a switch as shown. The…

A:

Q: For R1=2 02, R2=6 02, R3=3 02, V1=20 V, V2=48 V & L1=2 H in the shown circuit, obtain the inductor…

A:

Q: Consider an RLC circuit with emf amplitude E„ = 10 V, resistance R = 10 N, inductance L = 1.0 H, and…

A:

Q: 0 μsμs after the switch of (Figure 1) is moved from aa to bb, the magnetic energy stored in the…

A:

Q: The current amplitude / versus driving angular frequency wa for a driven RLC circuit is given in the…

A:

Q: A wooden toroidal core with a square cross section has an inner radius of 13 cm and an outer radius…

A: Given : Inner radius (a) = 13 cm = 0.13 m Outer radius (b) = 16 cm = 0.16 m Diameter (d) = 0.90 mm =…

Q: In the circuit shown in the figure, the inductor has inductance ?=2.75 HL=2.75 H and negligible…

A:

Q: Draw an RL circuit with a resistor of R = 2on and an inductor of L = 0.5 H connected in series with…

A:

Q: The current through the inductor of an LC circuit oscillates at ω = (3.2 π x 103) rad/s. If the…

A:

Q: The circuit overall impedance is most nearly A. 335 2 The current in the circuit is given by i(t) =…

A:

Q: . The current through the inductor of an LC circuit oscillates at a = (5/V3)rad/s. If the…

A: Given  - Capacitance (C) = 0.3F               angular frequency (ω) =53 rad/s To find - Inductance…

Q: An LC circuit like that in the figure below consists of a 3.30-H inductor and an 834-pF capacitor…

A: Given: Value of inductor = 3.30 H Value of capacitor = 834 pF charge = 135 μC time = 5 ms

Q: A physics student notices that the current in a coil of conducting wire goes from / = 0.200 t 2 1.50…

A: induced emf is given by ∈=-Ldidt=-Li2-i1t2-t1t2-t1=0.250 seci2=1.50 Ai1=0.200 AL=3 mH=3×10-3 H

Q: A Tesla coil consists of a long solenoid with length L = 0.5 m that is closely wound with N1 = 1000…

A: Given data: The length of solenoid is L=0.5 m. The number of turns are, N1=1000N2=10 The area of…

Q: An L-C circuit has an inductance of 0.450 H and a capacitance of 0.240 nF. During the current…

A:

Q: For the RL circuit shown in Figure, let the inductance be 3.00 H, the resistance 8.50 ohm, and the…

A: Given, The inductance, L= 3 H, the resistance, R= 8.50 Ω, Emf, V= 36 V, and current, I= 2 A.

Q: A physics student observes that the current in a coil of conducting wire goes from i, = 0.200 A to…

A: Given: Inductance L = 4mH or 0.004 H                               i1= 0.200 A…

Q: A resistor (R = 9.00 x 10² N), a capacitor (C = 0.250 µF), and an inductor (L = 1.40 H) are…

A:

Q: The current through the inductor of an LC circuit oscillates at o (3.27x 10brad/s. If the inductance…

A:

Q: A generator with an adjustable frequency of oscillation is wired in series to an inductor of L =…

A:

Q: In an L-C circuit, C= 3.21 μF and L = 88.0 mH . During the oscillations the maximum current in the…

A: L = 88 mH = 0.088 H C = 3.21×10-6 F Imax = 0.853 mA

Q: A transformer consists of two coils of wire wound on a common toroidal iron core. The mutual…

A:

Q: Consider an RLC circuit with emf amplitude Em = 10 V, resistance R = 10 N, inductance L = 1.0 H, and…

A: Given data: The emf amplitude is εm=10V. The resistance is R=10 Ω. The inductance is L=1.0 H. The…

Q: Two coils connected as shown in the figure separately have inductances L1 = 34 mH and L2 = 50 mH.…

A:

Q: An LC circuit like the one in the figure below contains an 60.0 mH inductor and a 25.0 µF capacitor…

A: GivenL= 60.0 mH = 60.0 × 10-3 HC = 25.0 μF = 25.0 × 10-6 Fq0 = 185 μC =185 × 10-6 Cf = 129.95 Hz…

Q: The current in a coil drops from 3.8 A to 1.8 A in 0.51 s. If the average emf induced in the coil is…

A:

Q: A coil is connected in series with a 11.9 kΩ resistor. An ideal 59.5 V battery is applied across the…

A:

Q: A transformer has two sets of coils, the primary with N1 = 110 turns and the secondary with N2 =…

A: Answer:-  Given  Primary (N1) = 110 turns  Secondary (N2) = 1625 turns  Voltage of primary coil…

Q: In an oscillating RLC circuit, R = 2.5 0, L = 5.0 mH, and C = 500 µF. What is the angular frequency…

A: Given: The resistance is 2.5 Ω. The inductance is 5.0 mH. The capacitance is 500 μF.

Q: The switch in the figure below is connected to position a for a long time interval. At t = 0, the…

A: Since you have posted a question with a multiple sub parts, we will solve first three sub - parts…

Q: A simple series circuit consists of just a 38.1 µF capacitor and an 194 mH inductor, with no…

A: The given values are, C=38.1 μF=38.1×10-6 FL=194 mH=194×10-3 HQ=5.4 μC=5.4×10-6 C

Q: coil has 2.55-Ω resistance and 121-mH inductance. If the current is 3.00 A and is increasing at a…

A:

Q: The current through the inductor of an LC circuit oscillates at ω = (3.2 π x 103) rad/s. If the…

A:

Q: A wooden toroidal core with a square cross section has an inner radius of 15 cm and an outer radius…

A: Given :  Inner radius of toroidal (r1) = 15 cm = 0.15 m Outer radius of toroidal (r2) = 19 cm = 0.19…

Q: coil rated 600 Watts, 330 Volts, 60 Hz has a resistance of 20 Ω. What is the inductance of the coil…

A: Given: The rated power and voltage is 600 W and 330 V. The resistance of the circuit is 20 Ohm. The…

Q: An LC circuit like the one in the figure below contains an 70.0 mH inductor and a 12.0 uF capacitor…

A: The charge on the capacitor at time t = 1.00 ms is,

Q: A series RLC circuit has components with the following values: L = 20.0 mH, C = 100 nF, R = 20.0 Ω,…

A:

Q: A 4.7-µF capacitor and a 200-S resistor are connected in series. If you want to connect an inductor…

A:

Q: The current amplitude I versus driving angular frequency wa for a driven RLC circuit is given in the…

A:

Q: A wooden toroidal core with a square cross section has an inner radius of 10 cm and an outer radius…

A: a) The required value of inductance is,

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.