Considering a volume of air that is saturated, which of the following statements is NOT necessarily true: the water vapor pressure is equal to the atmospheric pressure the dew point temperature is equal to the air temperatures the relative humidity is 100%

Considering a volume of air that is saturated, which of the following statements is NOT necessarily true: the water vapor pressure is equal to the atmospheric pressure the dew point temperature is equal to the air temperatures the relative humidity is 100%

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter35: Comfort And Psychrometrics

Section: Chapter Questions

Problem 3RQ: Lower room temperatures can be offset in winter by A. lowering the relative humidity. B. being very...

See similar textbooks

Related questions

Q: (a) Find the moment of interia for area respect to y-axis. (b) Find the moment of interia for area…

A: Solution: Given Data: To Find: (a) MOI about y-axis. (b) MOI about P point.

Q: Build the following part. Report the volume in in^3. Assume all dimensions are in inches. Hint: Do…

A: It is asked to find the volume of the model based on the given dimensions

Q: A sled with two runners slides along a thin horizontal layer of water between the ice and the…

Q: E 100 mm Noc 120 rpm 65° OP-100 mm OC-200 mm PE-150 mm EF-500 mm Con slider D on link EPD TI F Find…

Q: 3. A 6 KN force is applied at the free end of a beam with dimensions given in the figure below.…

A: (a) Draw the given diagram of cross-section of beam.

Q: 2. A hollow generator shaft of 180-mm outer diameter and 120-mm inner diameter carries a torque T 40…

Q: 2. A 5 lbm gun fires a 0.05 lbm bullet. The bullet leaves the gun at a velocity of 1500 ft/s in the…

A: Given: mass of gun (mg) = 5 lbm mass of bullet (mb) = 0.05 lbm Velocity of bullet leaving gun (Vb) =…

Q: Draw the correct Free Body Diagram (FBD). . R is the resultant of three forces P,T and F acting on a…

A: The stepwise procedure to solve this problem is shown in the following attached image:

Q: A truck for which the information in Figure 10.8 applies operates over a haul road with a +4% slope…

Q: Fig.10 shows an off-set piston mechanism in which the crank OA rotates clockwise at 2500rpm.…

A: Given: N=2500 rpm To find: Velocity of piston B Acceleration of piston B Angular acceleration of…

Q: ᴀ ꜱᴘʀɪɴɢ ɪꜱ ʟᴏᴀᴅᴇᴅ ɪɴɪᴛɪᴀʟʟʏ ᴡɪᴛʜ 55 ɴ ᴛʜᴀᴛ ʀᴇꜱᴜʟᴛꜱ ɪɴ ᴀ ʟᴇɴɢᴛʜ ᴏꜰ 39.47 ᴍᴍ. ᴛʜᴇ ꜱᴘʀɪɴɢ ʀᴀᴛᴇ ɪꜱ…

A: Given data:- Load on the spring =55 N Final length of spring =39.47 mm Spring rate =1.6 N/mm To find…

Q: Three cables are tightened to an eyebolt as shown in the figure. Determine the resultant force and…

Q: 3.)A pump delivers 4 m³/min of water from 110 kPa to 350 kPa. Both pipe's gages are on the same le…

A: Given data as per question Q=4 m3/minP1=110 kPaP2=350 kPad1=16 cm=0.16 md2=13 cm=0.13 mρ=997 kg/m3

Q: A venturi meter has a main pipe diameter of 65 mm and 26 mm diameter of throat. When measuring the…

Q: An Ideal rankine cycle steam (7 MPa, 10kPa). Ideal Rankine vapor power cycle operates with steam.…

Q: A car, of mass m = 1,264-kg, is driving at a velocity Vo= 52 km/h towards a pedestrian at a distance…

Q: Consider the channel shown in (Figure 1). Suppose that a = 390 mm, b = 260 mm, c = 50 mm.

Q: ray for the paper supply of a photocopy machine is shown. The tray is supported by a single hinge at…

A: Given-Information:- Weight, W = 14 ND = 190 mm To-Determine:- Reactions at point B

Q: Are you Guys Sure? The answer is 14cm? Explain the formulaa please A four-cylinder engine, with a…

Q: The angular velocity of AB is 8.00 rad/s lockwise in the position shown in the iagram at the right.…

A: Given, wAB= 8 rad/s

Q: You have to select one of the materials (A, B or C) to be used as a casing material for a special…

Q: An arbitrary heat engine is operating with the average heat addition and heat rejection temperatures…

A: Given:Heat addition temperature, Tin,1=600 KHeat rejection temperature, Tout,1=360 KFind:The thermal…

Q: For an 18-8 Mo stainless steel (Animated Figure 8.36), predict the time to rupture for a component…

A: Given data: Stress = 80 MPa Temperature T = 700oC = 973 K P(L.M.) = 23.26*103 K-h Find: time to…

Q: The A-frame shown supports a 500 N force D at the midpoint of member AB as shown. Determine the…

Q: Rotate the objects shown below by the indicated amount. Sketch the result in the space provided.…

A: Find Rotate the object about the given axis.

Q: A helical gear of 10 inches pitch diameter has a helix angle of 25 degree, and there are 35 teeth.…

A: Detailed explanation and solution of the above problem uploaded in below picture.

Q: Problem 1 Water needs to be transferred from one reservoir to another at a rate of 600 gpm. A…

A: Note: As per the policy, we can solve the first three subparts. Please resubmit the remaining parts…

Q: Required information Problem 09.119C - Replacing Single-Stage Compression with Multistage…

A: To find: thermal efficiency increase, decrease or remains the same when replacing single stage…

Q: What is meant by the thermal equilibrium diagram of the alloy? And what is its importance?

A: Given Data- Thermal equilibrium diagram topic give we have to discuss it

Q: A compressor handles 3500 cfm of air as measured at intake of 14.5 psia and 75°F. At discharge, p2 =…

Q: Question 3 An insulated 1.15 m³ rigid tank contains air at 350 kPa and 50°C. A valve connected to…

Q: find Centroid of area shown. I got 0.4796in Please Clarify it within 30minutes

Q: Question 3 The following is an observation made during a trial on a 4-stroke diesel engine. The…

A: The given information in the problem is shown in the following attached image:

Q: The coefficient of static friction between the 65-lb roller and the ground is μ = 0.2. Fins the…

A: Given data: w=65 lbμs=0.2r=3 ft2=1.5 ftP=Pmax=?

Q: The specific weight and the specific gravity of a body of unknown composition are desired Its weight…

A: GivenWair=890NWwater=667N

Q: The two blocks used in a measuring device have negligible weight. The spring is compressed 4 in.…

Q: Given the headwater elevation and the tailwater elevation and the flow of a river, explain how you…

A: Given: There are a headwater elevation and a tailwater elevation. So if the headwater elevation is…

Q: Smooth C frictionless) An 1130 -Kg car is held in place by a light cable on a very ramp, as shown…

Q: The stresses in a 2-D rectangular steel body (E = 200 GPa, v=0.32) are 0xx = -A(L - x)y, and oxy =…

Q: A four-cylinder engine, with a cylinder capacity of 1385.44 cm3, stroke of 9 cm. Calculate the…

A: GivenV=1385.44 cm3L=9cm

Q: Problem 5: Calculate the thrust of a gas turbine engine if the exhausting jet expands to ambie…

Q: Steam enters a turbine at P1 = 0.6MPa and T1 = 400°C (673.15 K). The steam leaves at 0.1 MPa. If the…

A: Given that: P1 = 0.6 MPa = Pressure of steam at the inlet of the turbine T1 = 400 oC = Temperature…

Q: Determine the magnitude of the couple in KN-m acting on the gear given that F = 620 N. Provide your…

A: GivenF=620N

Q: gedem +x) 1+2) Circle the letter corresponding to the view on the right that shows the result of…

A: First, rotates the object along the y-axis in an anticlockwise direction then again rotates along…

Q: A man is riding his motorcycle with a 3 m/s towards his head. He has a mass of 70 kg with supplies…

A: Given data: V=3 m/sm=70 KgP=300 wcd=0.88μ=0.007A=3.9ft2=0.362 m2

Q: Using Mohr's circle and analytical method, determine the following: (a) the principal stresses; (b)…

Q: Installing a new air conditioning system in an old building would be classified as a.ordinary…

A: We know that whenever we install any new equipment or system then it is very clear that it is not…

Q: Consider the beam shown in (Figure 1). Suppose that a = 200 mm, b = 250 mm, c = 10 mm

A: First the moment of inertia for each element is calculated about u axis and then all of them are…

Q: A three cylinder single acting engine has its cranks set equally at 120° and it runs at 800 r.p.m.…

Q: he difference between the pressure at the pump suction and the vapor pressure of the liquid at the…

Question

Considering a volume of air that is saturated, which of the following statements is NOT necessarily true:

the water vapor pressure is equal to the atmospheric pressure

the dew point temperature is equal to the air temperatures

the relative humidity is 100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

absolute humidity at atmospheric pressure at 27 °C is 0.015 kg water / kg dry air. Specify:a. water vapor partial pressure (kpa)b. relative humidity (%)c. dew point temperature (° C)
If the air temperature is 85°F, what is the water vapor pressure corresponding to a relative humidity of 55 percent and at 55°F with 25 percent relative humidity.
Using the standard tables (Appendix C, Tables C-1 and C-2), determine the relative humidity and dew-point temperature if the dry-bulb thermometer reads 22°C and the wet-bulb thermometer reads 16°C. How would the relative humidity and dew point change if the wet-bulb reading were 19°C?
"For an air-water system at a given moisture content, the temperature decreases as the humidity increases."Is this statement true or false? Shouldn't it be relative humidity?
what is the relationship and formula of relative humidity and temperature?
How much heat and moisture must be added to 4 cubic meter per minute of air at 13 C dry bulb and 31% relative humidity to raise it to 36 C and 41% relative humidity? Show the psychometric chart diagram on your paper.
The cooling water entering the factory has a temperature of 28 C and when it leaves 45 C. This used cooling water is cooled in a cooling tower. The dry bulb temperature of the air entering the cooling tower is 24 C, the pressure is 1atm, and the relative humidity is 50%. Air exits the cooling tower at 35oC and relative humidity is 90%. Determine the range, approach, and cooling efficiency of the cooling tower!
In an air sample with a dry-bulb temperature of 28°C and a wet-bulb temperature of 22°C what is the (relative humidity)?
What happens when the temperature of air with 80% relative humidity at 15°C is raised to 20°C The saturation water vapor pressure is 1.71 kPa at 15°C and 2.34 kPa at 20°C.
As the Airstream is cooled and dehumidified, the relative humidity____ and the absolute humidity___ A. Increases , Increases B. Decreases, Decreases C. Increases, decreases D. Decreases, Increases
If the percent humidity of air (30 °C, total pressure 150 kPa) is 45 % and the saturation pressure of water vapor at that temperature is 6 kPa, the percent relative humidity and the absolute humidity of air are
During an air-conditioning process, 900 ft3 /min of conditioned air at 65OF and 30 percent relative humidity is mixed adiabatically with 300 ft3 /min of outside air at 80OF and 90 percent relative humidity at a pressure of 1 atm. Determine (a) the temperature Answer (b) the specific humidity Answer (c) the relative humidity of the mixture Answer