ConstantS How much power must be produced by the "active Nat pumping" system to produce this flow against a +30-mV potential difference? Assume that the axon is 80 cm long and 30 um in diameter. During an action potential, Na ions move into the cell at a rate of about 3 x 10-7mol/m? •S. Express your answer using two significant figures. P = W Submit Request Answer Previous Next ubschpLIOTTAI N 18:25 О3/04/2022

ConstantS How much power must be produced by the "active Nat pumping" system to produce this flow against a +30-mV potential difference? Assume that the axon is 80 cm long and 30 um in diameter. During an action potential, Na ions move into the cell at a rate of about 3 x 10-7mol/m? •S. Express your answer using two significant figures. P = W Submit Request Answer Previous Next ubschpLIOTTAI N 18:25 О3/04/2022

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter22: Electric Current

Section22.2: Using Electric Energy

Problem 33PP

See similar textbooks

Similar questions

Calculate the axoplasm resistance for a neuron of length 0.06 m and a radius of 5 um. The axoplasm resistivity is 2.0 Ohm.m. Give your answer in MOhms
A certain single ion channel is selectively permeable to K+ and has a resistance of 1.15 GΩ , therefore a current of potassium ions through the channel is possible. During an experiment, the channel is open for approximately 1.50 ms while the voltage across the channel is maintained at 89.5 mV. How many K+ ions, ?, travel through the channel during this time?
What is the magnitude of the electric field in unite of N/C across an axon membrane (1.00x10^0)x10-8 m thick if the resting potential is -(7.400x10^1) mV?
A single ion channel is selectively permeable to K+ and has a resistance of 2.20 G-ohm. During an experiment, the channel is open for approximately 1.15 ms while the voltage across the channel is maintained at +85.5 mV with a patch clamp. How many ions, N, travel through the channel?
What is the magnitude of the electric field across an axon membrane 1.2×10−8 m thick if the resting potential is -70 mV ?
By using spherical electrodes with the diameter D=50cm, the following breakdown voltages are measured at 18°C air temperature and 770mmHg pressure. a) If gap is equal to 7.4cm, calculate the breakdown voltage at normal conditions (20°C, 760mmHg). b) Calculate the real breakdown voltage for 1% relative measurement error (T=18°C, P=770mmHg). c) Calculate the capacitance of the electrode system with the diameter D=50cm and the gap a=7.4cm. What is the value of the resistance (R) which leads minimum 1% relative error (H) during the measurement of breakdown voltage? Çapı D=50cm olan küresel elektrotlar kullanarak 18°C sıcaklıkta ve 770mmHg hava basıncında tabloda verilen delinme gerilimleri ölçülmüştür. a) Elektrot açıklığı 7.4cm ise normal şartlar altında (20°C, 760mmHg) delinme gerilimini hesaplayınız. b) Gerçek delinme gerilimini %1 bağıl hata için hesaplayınız (T=18°C, P=770mmHg). c) D=50cm çap ve a=7.4cm elektrot açıklığına sahip elektrot sistemi için kapasite değerini…
Calculate the capacitance of the myelinated neuron membrane (axon), if its thickness is 0.8 micrometres (um) using a value of area of 10-6 m2. The membrane wall is mainly lipids and you will need to find the value of the permittivity in your notes. Give your answer in picoFarads (10-12 F) NB 1um = 10-6 m
Apply the Loop Rule to ABCKFA.
Consider the model of the axon as a capacitor from Figure P18.43. (a) How much energy doesit take to restore the inner wall of the axon to -7.0 x 10-2 V,starting from +3.0 x 10-2 V? (b) Find the average current inthe axon wall during this process.
Calculate the conduction velocity if the electrodes are 12cm and there are 0.3sec between the time of stimulation and the peak of the CAP.
Suppose a biological membrane with a specific capacitance of 1 μF/cm^2 has a resting surface charge density of 0.1 μC/cm^2. Also suppose there are 50 sodium channels per μm^2 and thatwhen each opens for 1 ms, 1000 Na+ ions flow through the channel, resulting in a reduction of the potential difference (the membrane voltage). Compare this membrane’s resting potentialvoltage to the membrane voltage 1 ms after 10% of these channels open, assuming no other changes occur during this time.
What is voltage at terminal AB?