Answered: Coupling Capacitors are used to prevent…

Coupling Capacitors are used to prevent High Frequency Low Power Communication Signals leaking into the Power System Transformers. Select one: True False

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 35RQ: Which of the following is the capacitance of two 20-microfarad running capacitors connected in...

See similar textbooks

Related questions

Q: 11- To increase the transfer power in a 230 kV transmission line, we plan to use a series capacitor…

A: Given - Length of the line= 100km Line X = 0.0911pu

Q: A choking coil having a resistance of 20 Ω and an inductance of 0.07 henry is connected with a…

Q: b. Determine what is the necessary length and characteristic impedance of a cable to be used as a…

Q: In series reactive power compensation, the series capacitors are not used to increase the…

A: In series reactive power compensation,

Q: An impedance coil having a resistance of 25 ohms and an inductance of 20 mH is connected in parallel…

A: The solution is given below

Q: Q27/B Draw the schematic diagram of Anderson's bridge circuit. Write the formula for unknown…

A: To draw the Anderson's bridge

Q: A 12-stage impulse voltage generator has a capacitor C. The wave front resistance equal to 0.6kΩ and…

A: n= 12 Wave front resistance, R1 =0.6 kilo-ohm = 600 ohm Wave tail resistance, R2 =7019 ohm Wave…

Q: If a Marx generator is required to perform a 170 kV lightning impulse test, and you have capacitors…

Q: 19. Determine the stored energy in the capacitor at t = 4. Assume v(0) = 27 %3! V 3272.22 J 3372.22…

A: From given current equation find the voltage across capacitor . Energy stored in capacitor = 0.5 ×…

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The…

A: Given:V = 220 Vf = 60 Hzcosϕ = 0.866025403 leadI = 1A…

Q: University of Moul College of Electronic Engineering Feineering Department afoint chanay of 30n cis…

A: We need to find out D at given point dur point charge and surface charge density .

Q: The series capacitors reactive compensation methods are attractive for decreasing the power…

A: Choose the correct option Whether the given statement is true or false?

Q: In distribution systems, fixed capacitors are usually sized for minimum base-load conditions. Select…

A: Distribution system

Q: Enumerate five step-by-step procedures of Maximum power transfer theorem method in application to ac…

A: MPT theorem: This is used to find the maximum power in the load.

Q: Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 Q is connected to the…

A: Given source of Voltage 10 v and frequency 1000 KHz with internal resistance of 10 Ω Transmission…

Q: An impulse generator has 8 stages, each having a capacitance of 1.2 μF and 167 KV. If it has to…

A: the generator Capacitance, C1=1.2 μF8=0.15 μF the load Capacitance, C2=15000 pF time to front, t1=1…

Q: Use DFT method to compute the circular convolution of x(n)={4,4} and h(n)={2, 6}.

A: Given data, xn=4,4hn=2,6

Q: In the outage replacement rate method, the repair rate is zero. Select one: True O False The…

A: We are answering all the questions. Solution of first question: Given statement is in outage…

Q: What is the electrical length of the transmission line measured from the source to the load if the…

Q: An impedance coil is connected in series with a capacitor across a 220 v, 60 Hz ac supply. The…

A: From given supply voltage and using condition of voltage across impedance coil and capacitor voltage…

Q: negligible only if the length of the Transmission Line does not exceed how many kilometers? A. 240…

A: In this question, we will write shunt capacitance effect...

Q: In an RL Series Circuit, the Supply Voltage is 240 VRMS. The Voltage across the Resistor is measured…

A: In this question we will find indictor voltage in series RL circuit....

Q: The transient response of a second order system is given below, for 5% * criterion the settling time…

A: General second order step response equation is c(t)=1-e-ℰωnt/√(1-ℰ²) ×sin(ωdt+φ) Given second order…

Q: A superheterodyne receiver is to tune the range 88.IMHZ to 107.1MH2. The RF circuit inductance is…

Q: In the following roots of the system, which one can form a stable system? coswt parabolic input step…

Q: A transmission line has a capacitance of 0.1 μF per phase. Determine the inductance of Peterson coil…

Q: 10/Explain in your own words and your own understanding (avoid plagiarism) why there's Capacitance…

A: Simply capacitor is nothing but two conducting materials separated by small distance, in between…

Q: A teala coil has a primary winding rated for 11kv. If L, La and coefficient of ooupling K are 12t,…

Q: ortion issues in a mechatronic system, otherwise known as an Impedance Matching Circuit. Figure…

Q: Consider the circuit shown below. What is the equivalent impedance for maximum current? Assume the…

A: In this question, We need to determine the equivalent impedance for maximum current. We know…

Q: An impedance coil is connected in series with a capacitor across a 120 v, 60 Hz ac supply. The…

A: Given that,an impedance coil is conncted with a capacitor in series connection.The AC supply voltgae…

Q: PMMC Instruments are used to measure dc current only. True False

A: Ans. True

Q: resistor of 100 Ω, a coil of 4.50 μH, and a capacitor of 220 pF are in parallel. What is the…

A: We need to calculate admittance for given parallel RLC circuit .

Q: Using Root Locus method, transient response of a system can be determined directly. Select one: True…

A: Root locus is used to determine nature of roots and stability analysis not for transient response

Q: A 230 kV, 3-phase, 50 Hz, 200 km transmission line has a capacitance to earth of 0.03 µF/km per…

A: We have an Transmission line with, Line Voltage (Vl) = 230 KV = 230 * 103 V Length of Line (l) = 200…

Q: Compute the 8 – point DFT of x(n) = { 1,2,3,0,3,2,1,3}, using the following methods; (a) DIT – FFT…

Q: The self admittance is the sum of all admittances connected between the buses. Select one: O True O…

A: The self admittance is the sum of all admittance connected between the buses.

Q: magnetic coil neglected resistance want to induction equal 80KQ at frequency 200HZ If this coil is…

A: In this question, We need to determine the circuit current, power factor and vector diagram of the…

Q: Capacitor bank are widely employed in distribution systems for achieve power and energy loss…

A: Capacitance bank is installed because it inject reactive power into the system and reduce the power…

Q: Calculate the reactance of a peterson coil suitable for 1 33kV, 3phase transmission system of which…

A: There will be three sequence networks in the given power system- Positive-sequence network…

Q: A capacitor has a reactance of 80 ohms when connected to a 50 Hz supply. Calculate the value of…

Q: Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 Q is connected to the…

A: Given data : Source voltage V= 10V f=1000 KHz Internal resistance = 10 Ω Capacitance (C) =0.001μF…

Q: The Steady state error of type-3 system applied with parabolic input is = O equal to velocity error…

Q: For an undamped system, poles are complex conjucate. Select one: True False

A: we will determine the pole location and we will answer the given question.

Q: Large-scale Hydroelectric Power Stations usually has a Dam. Select one: True False

A: Choose the given Statment is true or false? Large-scale Hydroelectric Power Stations usually has…

Q: An impedance coil is connected in series with a capacitor across a 220 v. 60 Hz ac supply. The…

A: According to question drawing the diagram circuit diagram,

Q: Biogas can be produced using biomass from plants also. Select one: True O False

A: Need to find true false

Q: Q3) Design a three-section binomial transformer to match a 40N load to al502 transmission line, and…

Question

Coupling Capacitors are used to prevent High
Frequency Low Power Communication Signals
leaking into the Power System Transformers.
Select one:
True
False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
Which of the following are considered triplen harmonics: 3rd, 6th, 9th, 12th, 15th, and 18 th?
Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
Resolve in a clear and orderly manner.DC AnalysisAC analysisEquivalent circui
Find the coupling coefficient if the Mutual inductance is 20H, the inductance of coil 1 is 2H and the inductance of coil 2 is 8H.
The attenuation and characteristic impedance of a symmetrical lattice attenuator are 40 dB and 500 Ω respectively. Design the network.
A 400V, 50HZ star connected induction motor takes a line current of 50 Amps At a p.f. of 0.8 Lagging. Three mesh connected capacitors are connected to raise the p.f. to 0.9 . Find the value of each capacitor in microfarads
A resistor of 0.0044 siemens, a capacitor whose susceptance is 0.035 Siemens, and a coil whose susceptance is -0.011 siemens are all connected in parallel. The admittance vector is: (Provide illustration of the circuit)
Find the value of x if the Mutual inductance is x H, the inductance of coil 1 is 2H and the inductance of coil 2 is 8H. The coupling coefficient is 5.
A 137 pF capacitor is connected to a voltage source such that Vc(t)=12e^-2t V, t>=0 and Vc(t)=12V for t<0. Calculate the energy stored in the capacitor at t equal to 500 ms
A 750-ohm resistor, an uncharged 1.50 uF capacitor, and a 8.00-V emf are connected in series. (a) What is the initial current and (b) the RC time constant?