Hi.Most grateful some assistance with this question. I worked out the Ishort current is 8amps???Thanks %3DE SOA +8 = 'Adiagram below using Norton's Theorem.Determine the current flowing in, and the voltage dropped across the 6 Ohms resistor shown in the%3D%3D= 24 volts%3D= 12 chms%3D24 ohms2.

Answered: Image /qna-images/answer/8a0da076-90ab-44a5-89ad-6bf651dacb28.jpg

Cr. Determine the current flowing in, and the voltage dropped across the 6 Ohms resistor shown in the diagram below using Norton's Theorem. = 12 chms = 24 ohms R2 %3D 6 ohms = 24 volts %3D %3D S4OA +8 = '

Cr. Determine the current flowing in, and the voltage dropped across the 6 Ohms resistor shown in the diagram below using Norton's Theorem. = 12 chms = 24 ohms R2 %3D 6 ohms = 24 volts %3D %3D S4OA +8 = '

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 1RQ: 1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive...

See similar textbooks

Related questions

Q: Find the voltages at the thrce nonreference nodes in the circuit of the beloW nguiu. 20 ww 41, 30 2.…

Q: 1000 a 750 500 10A 40V 250 Note that there is no electrical connection at the middle intersection.…

Q: Q) For the circuit shown, Use Nodal voltage method: 1) Calculate the voltage across 15Ω resistance.…

A: According to question: Applying nodal analysis at node 1, node 2 and node 3, this will give At node…

Q: Fill in the blanks / identification: a) Find the value of R that will cause 4 A of current to flow…

Q: hoff's Voltage Law, find the current flowing through R2. Consider V1=24 Volts, V2=6 Volts, R1=4 Q,…

A: In this question we will find unknown current suing KCL..

Q: Example (3-2): Given the resistance values of the unbalanced Wheatstone bridge shown below, find.…

Q: Determine the total resistance of the circuit of the circuit below. 140 4.5n 3 40 250 180 1.50 5n…

Q: The resistances of the arms AB, BC, CD and DA of an unbalanced Wheatstone bridge are 40, 20, 10 and…

A: Given values of resistances are 40,20,10,30 Calculating net resistance…

Q: Determine the currents and voltages across all the resistances indicated in the circuit shown below.…

A: The solution can be achieved as follows.

Q: Draw the below given circuit. Change value of components according to your circuit. Use ammeter,…

Q: Use Norton's theorem to determine the current flowing in the 2-ohm resistance in the network shown…

A: Given figure:

Q: A transmission line is being built to bring power to a remote community, which is 40 miles from the…

A: We need to find the sending end line voltage of the system. The solution is provided in the next…

Q: For the circuit shown below Use using resistor combination, current division, or voltage division,…

A: In this question we need to find a voltage v shown in the given circuit.

Q: Procedure 1. Using the DC circuit trainer, Connect the circuit shown below: R3 820 1000 R2 R4 5 V d…

A: Let, Current i1 flows in the first loop. Current i2 flows in the second loop.

Q: 2. The sum of the three voltage for Y or A (Va, Vic, Va) must be equal to zero .Why ? Did your…

Q: Three resistors of 50 ohms, 100 ohms, and an unknown resistance R are connected in parallel and the…

Q: Using series and parallel combinations for the electrical network below, calculate current flowing…

A: The solution is given below

Q: 5. Three resistors connected in parallel with values 10, 5, 20 ohms respectively. Find the total…

Q: Determine the number of branches, nodes, loops, and meshes in Figure 3. ww

A: Branch(b) Part or section of a circuit which locate between two junctions is called the branch. In a…

Q: Use the mesh-current method to analyze the following circuit. What are the magnitudes of the mesh…

A: Here circuit is given and we have to find the unknown voltage and power dissipated in 15 ohm so…

Q: B. Consider the diagram above. If each circuit has the same voltage, which has the largest…

Q: From the data collected in Tables 1,2, and 3, plot the current versus voltage characteristic for…

A: Both table 1 and table 2 data is same so, same graph is enough.

Q: Using Kirchhoff's Law, calculate the current through the 4 ohms resistor of the circuit shown. 15 V

A: The equivalent circuit with assumed direction of current each resistor is shown below: To calculate…

Q: Apply Norton's Theorem to calculate the current flowing through the 5-ohm resistor.

Q: Find currents and voltages in the circuit below? 22 42 www i2 5 V 82 3 V

Q: 20 2 30 Ω 10Ω A В ww iz ww i2 + 30 Ω V2 40 Ω 100 V V1 200 V | i4 400 V

A: First we will find out all current and voltage then we verify krichoff's current law

Q: Q.2 For the network of Figure Q.2, by using Basic Laws of electrical circuit; (a) Determine the…

A: Apply KVL in middle loop to find Vab. Using ohms law find the current I. A source is said to be…

Q: Determine the equivalent resistance between terminals a and b. a 30 ohms 10 ohms 20 ohms bo 15 ohms…

Q: 535. A resistance R is connected across two batteries, A and B connected in parallel. The open…

A: According to the question we have to find the value of R.

Q: Find the current in a ground loop that is 250 m long, has a wire resistance of 0.04 ohms/m, and has…

Q: 3. Using Kirchhoff's Law, calculate the current through the 4 ohms resistor of the circuit shown. 10…

A: Given circuit, Kirchhoff's current law states that the algebraic sum of the currents entering a…

Q: Find the equivalent resistance of the network of resistors shown below. This network is usually…

A: Given circuit, Where, supply voltage, V = 120 V

Q: Example (3-2): Given the resistance values of the unbalanced Wheatstone bridge shown below, find.…

Q: b) Calculate the following parameters according to the circuit which is given in Figure 2: current…

A: To find the current through R1, R6 and voltage across R3

Q: Example (2): Design d.c voltmeter by using direct method with d'Arsonval meter of 1002 and full…

Q: 10 Ω 6Ω 10Ω 18 Ω a d 4Ω 120V 15 Ω 2Ω 3Ω

Q: 4 S2 2 A 4 V 3r, A

Q: For the circuit shown, the current flow through resistor R2 would be: IT R2=22Ω 12 13 R1= 602 R3=…

Q: Use the mesh-current method to analyze the following circuit. What are the magnitudes of the mesh…

Q: へ97 7る? 4323 8. て 22 て

A: Mesh Analysis Mesh analysis is also called loop analysis. To determine unknown currents in the…

Q: For the circuit given, If V=44 V, R1= 24 ohms, R2 = 16 ohms, R3 = 16 ohms. Voltage drop across 16…

Q: 22 IT ΙΩ 32 100V 12 22 sa 22 12 ww ww

A: VT is not mentioned in picture. So we can only calculate IT. Redrawing the circuit we get :-

Q: 2. Find the unknown quantities for the network below using the information provided -> R1 R2 R3 E E=…

A: Here we will use power calculation formula. We also use ohm 's law .

Q: MT.Q2- Calculate the voltages Vo and Va, the currents lo and Iy, the power of A in the circuit via…

A: We need to tell about the voltage and current value , we will find out it by using kvl ,kcl and…

Q: 4. A TV set and an electric fan are connected in parallel to a 220 - v line. The current in the TV…

A: Here we deal with the calculations related to the electrical circuit as given in the Q.

Q: b) Calculate the following parameters according to the circuit which is given in Figure 2: current…

A: Given circuit-

Question

Hi.

Most grateful some assistance with this question. I worked out the Ishort current is 8amps???

Thanks

%3D
E SOA +8 = 'A
diagram below using Norton's Theorem.
Determine the current flowing in, and the voltage dropped across the 6 Ohms resistor shown in the
%3D
%3D
= 24 volts
%3D
= 12 chms
%3D
24 ohms
2.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Write your conclusion in this module on how the hydro-electric power affects the needs of the society and the environment?
why is the answer for this problem is 2. ASAP TYIA
The answer is 60ohm. However i could only get 40 ohms using the method shown below. R1 // R2+R3 // R4 = 40ohms. Why isit wrong?
What are some of the environmental impacts of the use of geothermal energy sources? Compare these with present power generating schemes? (150 words)
Calculate the current flowing in the 2 ohm resistor (RL) and its direction using Thevenin's theorem. Assume the source of emf to have negligible resistance.
A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.12 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 135KV. Find the Voltage distribution across each unit and the String Efficiency
The diameter of wire A is greater than the diameter of wire B, but their lengths and resistivities are identical. For a given voltage difference across the ends, what is the relationship between PA and PB, the dissipated power for wires A and B, respectively?
2. Imagine that you're asked to install an auxiliary grounding electrode at the base of a lighting pole in aparking lot. This auxiliary grounding electrode will be connected to theA. lighting pole's electrical service equipment grounding conductor.B. electrical service's grounding electrode conductor.C. next lighting pole's auxiliary grounding electrode.D. lighting pole's neutral conductor.
PROBLEM SOLVING NO. 2: A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.08 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 110 KV. Find the Voltage distribution across each unit. Draw the diagram.
An incandescent lamp, rated at 100 W, gives a certain amount of light when placedacross the 120 V ac power line. Would the amount of light increase, decrease or remainthe same, when the lamp is placed across a 120 V dc power line? Explain your answer.2. 1. Is a wattmeter required to measure the real power delivered to a resistive load?__________ Explain.3. Explain briefly why is there a wattmeter reading in the purely inductive load as recordedin Procedure 6c.4. A wattmeter will indicate zero when the current lags (or leads) the voltage by 90 0 .Explain.
In the 3-layer planar electrode system shown in the figure; a) Calculate the stresses and electric field strengths in the layers. b) Determine whether the system will be punctured or not. c) Calculate the highest voltage that can be applied to the system without perforation in any layer of the system.
1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive circuit?